Trouble with GPU that works in 10.8 but not 10.8.3


Recommended Posts

Spec:

Core i5 2400

Gigabyte Z68AP-D3 UEFI Ua5

OEM nVidia GT230

I have two USB installers, one with 10.8 and one with 10.8.3, if I install ML from vanilla 10.8 then I don't need to do anything other than PCIRootUID=0, it will boot both installer and installed OS.

If I upgrade that installation or try to boot from 10.8.3 installer it gets as far as DSMOS has arrived then goes to black screen and monitor goes into power save.

I've tried multiple combinations of ports on the card and -x, graphicsenabler=n, etc.. and nothing I do works.

Does anyone have any ideas, thanks.

Link to comment
Share on other sites

Spec:

Core i5 2400

Gigabyte Z68AP-D3 UEFI Ua5

OEM nVidia GT230

I have two USB installers, one with 10.8 and one with 10.8.3, if I install ML from vanilla 10.8 then I don't need to do anything other than PCIRootUID=0, it will boot both installer and installed OS.

If I upgrade that installation or try to boot from 10.8.3 installer it gets as far as DSMOS has arrived then goes to black screen and monitor goes into power save.

I've tried multiple combinations of ports on the card and -x, graphicsenabler=n, etc.. and nothing I do works.

Does anyone have any ideas, thanks.

This is a Macintosh community where most here having very limited exposure to hackintosh - you'd be better off possibly asking the question over at a more dedicated hackintosh website.

Link to comment
Share on other sites

This topic is now closed to further replies.