Posted 13 August 2009 - 20:01
Temp1 is a sensor on the motherboard, unfortunatly it chages per mb so it has a generic name to it.
"SpeedFan is very flexible and is the temperature monitoring utility of choice. SpeedFan detects and labels thermal sensors according to various motherboard, chipset and super I/O chip configurations, so the Tcase label can be CPU, Temp 1, Temp 2, or Temp 3. Even if Tcase is labeled as CPU, it is still necessary to confirm the identity of Tcase prior to conducting Calibrations. Run Prime95 and note which SpeedFan temperature scales with an Idle to Load Delta similar to the Cores. This will identify the label corresponding to Tcase. Labels can later be renamed using the Configure button, (see Section 11). If a temperature shows a flame icon, this indicates alarm limits which require adjustment. Use the Configure button to set CPU and Core temp alarms to Safe Scale. If a temperature shows Aux 127, this is simply an unassigned input which can be disabled using the Configure button."...
Again, labels are assigned according to various hardware configuration, so Temp 1, Temp 2 and Temp 3 are not consistently assigned to the same devices accross all hardware platforms. HD obviously refers to hard drive. CPU is easy to verify as described above, which is typically Temp 2, but not always. That leaves motherboard and / or chipset to identify. Chipset temp scales more closely to the CPU temp and Core temps when load is applied, while motherboard temp will show the smallest scaling. If you use the Charts tab while repeatedly starting and stopping Prime95, it's easy to sort out which labels apply to which devices. Once identified, labels can be renamed to match your rig's particular hardware configuration. "