fmanchu Posted September 4, 2011 Share Posted September 4, 2011 My uncle has a Linksys 802.11b wireless router and he wants to amplify a wireless signal with it. Its a model BEFW11S4 version 4. Is it even possible? Link to comment Share on other sites More sharing options...
chrispinto Posted September 4, 2011 Share Posted September 4, 2011 (edited) Crikey probably not, unless there is a version of DD_WRT he can use that supports his router Edit: Although, he could wire the router into his existing network, means having a long ethernet wire though dpeending where he wants to extend it to. Then he'd essentially have 2 different wifi networks accessing the same internet connection Link to comment Share on other sites More sharing options...
sc302 Veteran Posted September 4, 2011 Veteran Share Posted September 4, 2011 Crikey probably not, unless there is a version of DD_WRT he can use that supports his router Edit: Although, he could wire the router into his existing network, means having a long ethernet wire though dpeending where he wants to extend it to. Then he'd essentially have 2 different wifi networks accessing the same internet connection No he wouldn't have 2 different wifi networks. If you make the two access points with the same exact ssid (using the same upper and lower case lettering, punctuation, etc) and the same security settings and access codes, then the wirless nic will seemlessly go about both "networks" attaching to the point with the strongest signal without a drop or connecting to a different access point. This has been in place since b standard and a standard. You would need dd-wrt. but really with the cost of a new router (I saw a G router in wally world for 30 bux the other night after I bricked my wrt54g and needed a new one at 11pm) get a new router. here is a e1000n for $22 http://www.amazon.com/Cisco-Refurbished-E1000-Wireless-N-Router/dp/B003VYEYE0/ref=sr_1_5?s=pc&ie=UTF8&qid=1315142132&sr=1-5 $20 http://www.amazon.com/TP-Link-TL-WR340G-54M-4PT-Routr/dp/B0035LF2R2/ref=sr_1_2?s=pc&ie=UTF8&qid=1315142434&sr=1-2 They are out there and they aren't that expensive. besides you will have more throughput on the newer routers that can cater to newer high speed internet access where that one tops out at maybe 3mb/s eventhough it is a 10mb port. Link to comment Share on other sites More sharing options...
+BudMan MVC Posted September 4, 2011 MVC Share Posted September 4, 2011 Who would still be running a B only router?? Yeah get a new one! As to using it to extend the range of some other network -- as sc302 stated you can put as many accesspoint you need. But you wouldn't be using it as a ROUTER.. Just an AP, does not matter what firmware you use or what router - any wireless router can be used as just an AP to widen your coverage. http://www.dslreports.com/faq/11233 Using a Wireless Router as an Access Point Now to do it wireless like a repeater or setup WDS then yeah that requires that feature set of your AP/Router -- but again B router, its pretty much junk if you ask me. Link to comment Share on other sites More sharing options...
fmanchu Posted September 4, 2011 Author Share Posted September 4, 2011 Thanks for the replies, I appreciate it. Link to comment Share on other sites More sharing options...
Recommended Posts