xp, ide device question


Recommended Posts

would this work, on my primary ide chanel i only have my hardrive at present so i have set the slave device to none.

i am going to connect another hard drive on which i will install linux if i do not change the device type back, then windows will not look for the device so in windows i will not have another disk that will move all my cd drive letters up again. but since this only applies to windows xp, the drive will still be visible to install linux on and run it from.

is this asumption correct??

Link to comment
Share on other sites

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.