• Sign in to Neowin Faster!

    Create an account on Neowin to contribute and support the site.

Sign in to follow this  

Hyper-v checkpoint

Recommended Posts

notta    59

I am testing out some software and in each step of the process I have created a checkpoint so if I have any problems I can revert back to the previous step to try again. Well the disk is running low on space so I want to expand the drive. Well Hyper-v is telling me that I can't edit the disk because there are snapshots. I would rather not lose all my snapshots, but I need to expand the disk. How do you merge all the snapshots into a single checkpoint at where am I currently? I only ask because I have been burned in the past and I want to make sure I don't lose all my work and get reverted to an older point. New to Hyper-v  so I apologize. Thanks.

Share this post


Link to post
Share on other sites
notta    59

OK, so I was impatient. I went in and one by one deleted all the checkpoints previous to Now.  I can now edit the disk and I'm right where I left off. As I said I was burned hard on this the other day so I wanted to make sure I didn't wipe out a full days work. I'm good now.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.