HEEEEEEELP!


Recommended Posts

sorry iam on my cell phonw

i acidently disabled nat on my cisco 677 router via telnet

and now i cant go online. now it wont let me back into telnet

tell me how to get back in or reset the router. or something else

dont ask queations just help

sux to write on phone

:cry:

Link to comment
Share on other sites

i found something on how to reset the p/w on a Cisco 675 and 678 router that also deletes the config files.

Connect your 675/678 to your PC via the management cable (originally supplied with the router - connects between the Cisco 675/678 and your PCs serial port)

Login to the router (using Hyperterminal or other serial port based terminal application)

Note: connect using 9600 baud, 8-N-1, no flow control

Remove, then restore power to the Cisco 675/678

As soon as the Cisco 675/678's red ALARM light comes on, hit Ctrl-C a few times to enter ROM monitor mode

Enter the following two commands:

CBOS# es 6 (erases sector 6)

CBOS# rb (reboots 675/678)

Once the unit reboots (you may need to manually power cycle the router) you can reenter your user info

not sure if you tried to get in with HT thru a serial cable, but its worth a shot.

Link to comment
Share on other sites

No, it was a extra cable i just found. one way cable i think ... Its made for connection 2 pcs without switch, inet or router.

I plugged that into the ENET port and i could access Telnet again.

And damn, you dont know how much it sucks to write on a phone .. touchscreen with alittle pen :p

Link to comment
Share on other sites

stfu before i smack you. You obviously never tried writing on a phone with touchscreen and alittle pen have you ?

Actually I have and do a darn good job at it.

Link to comment
Share on other sites

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.