hdparm


Recommended Posts

I wanna see what setting my HDD is using so I go and type: hdparm /dev/sda

This is what I get:

/dev/sda:
 readonly     =  0 (off)
 geometry     = 9964/255/63, sectors = 160086528, start = 0

From what I read, I'm supposed to get more info. What's up?

Link to comment
Share on other sites

It depends what info you want, check the manual for additional parameters.

Thanks, I didn't read the part that says " (except when a given device is SCSI, in which case -gr is the default)"

EDIT: Damn, I can't get any info. Stupid SCSI interface.

Link to comment
Share on other sites

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.