computer STOPS after one third VISTA installation


Recommended Posts

:( Some one help me !!! i have fujitsue siemens scaleo C and after installing VISTA on it after one third (1/3) of installation it freeses and then stops installing windows and i must then restart computer by swittching it on and off. Below is information about what computer i use !!!! I hoop some one can help me THANKS !!! :( :( :( :( :(

I/O Port 0x00000000-0x00000CF7 PCI bus

I/O Port 0x00000000-0x00000CF7 Direct memory access controller

I/O Port 0x000003C0-0x000003DF PCI standard PCI-to-PCI bridge

I/O Port 0x000003C0-0x000003DF RADEON 9200 PRO (Omega 2.6.53)

IRQ 16 RADEON 9200 PRO (Omega 2.6.53)

IRQ 16 Hauppauge WinTV PVR PCI II (23xxx) (Tuner 1)

IRQ 17 Hauppauge WinTV PVR PCI II (23xxx) (Tuner 2)

IRQ 17 Realtek RTL8139 Family PCI Fast Ethernet NIC

IRQ 17 C-Media AC97 Audio Device

IRQ 17 Agere Systems AC'97 Modem v2146D

Memory Address 0xE4000000-0xEBFFFFFF PCI standard PCI-to-PCI bridge

Memory Address 0xE4000000-0xEBFFFFFF Hauppauge WinTV PVR PCI II (23xxx) (Tuner 1)

Memory Address 0xD0000000-0xDFFFFFFF PCI standard PCI-to-PCI bridge

Memory Address 0xD0000000-0xDFFFFFFF RADEON 9200 PRO (Omega 2.6.53)

IRQ 19 Standard OpenHCD USB Host Controller

IRQ 19 Standard OpenHCD USB Host Controller

IRQ 19 Standard Enhanced PCI to USB Host Controller

IRQ 19 VIA OHCI Compliant IEEE 1394 Host Controller

Memory Address 0xA0000-0xBFFFF PCI bus

Memory Address 0xA0000-0xBFFFF PCI standard PCI-to-PCI bridge

Memory Address 0xA0000-0xBFFFF RADEON 9200 PRO (Omega 2.6.53)

I/O Port 0x000003B0-0x000003BB PCI standard PCI-to-PCI bridge

I/O Port 0x000003B0-0x000003BB RADEON 9200 PRO (Omega 2.6.53)

I/O Port 0x0000C000-0x0000CFFF PCI standard PCI-to-PCI bridge

I/O Port 0x0000C000-0x0000CFFF RADEON 9200 PRO (Omega 2.6.53)

Link to comment
Share on other sites

have you tried leaving the intaletion all night?? i had the same problem (exept it didnt frezze, i was able to move the mouse) so i leave it all night and when i wokeup it was installed :D

Link to comment
Share on other sites

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.