Digital Speedometer


Recommended Posts

Okay so I am looking at buying a car so I can eventually move out and keep my current job and I am looking at buying a 2006 For Focus LX 1.8 but I want to get a Digital Speedometer, Fuel Indicator and RPM Indicator for the car but I've searched online and cant find ANYTHING at all > <.

Anyone know where I can get a Digital Speedometer etc online.

Link to comment
https://www.neowin.net/forum/topic/1107543-digital-speedometer/
Share on other sites

Any reason why?

You can get devices that hook into the car's diagnostics bus and give you readouts like this, but they're invariably slow to update ? the fastest I could ever get a dedicated diagnostics system to read this stuff was about 1Hz on a modern CAN bus when I was doing research for my degree. Dedicated consumer digital reader devices may fake it faster by interpolating, though.

Also, it's worth noting that many, many cars these days use digital readouts already ? they just have an analogue dial at the end. I don't think you'll find a single new car on the market today that has a mechanical connection all the way to the dashboard. I had a 2005 Mazda (who were owned by Ford at the time) that used such a digital system.

Back on topic, I can't actually help other than stuff like this for iOS: http://sturminteractive.com/2011/07/26/gopoint-technology-gl1-odb-ii-for-ios/ ? my system wasn't designed to be actually used while driving, only recording for later analysis. If you actually end up replacing the car's stock instruments with something else, make sure you do your research thoroughly since having a device that doesn't have an approved calibration can be tricky, law wise, in some areas.

If you're not replacing the car's internal instruments then this post wraps around to the beginning ? why?

I want to get some with Digital Readouts because if I can see in a clear number the speed I am going nice and big on the dashboard it helps.

I have had a few driving lessons and with the Dial it annoys me because I am looking at this needle and I like to see clear numbers in front of me. I just find it easier.

Like you said about them being slow to update. It doesn't even need to be a full replacement just something with a Digital Readout telling me my speed that is apart of the Dashboard.

You can get a car that has them built in - the only car I can think of in that class is the Honda Civic (2006+, at least in the US market). I know it's not an ideal solution, but ikenndac has a good point

Never really liked the look of a Honda Civic Interior TBH.

Just looking for a nice, decent car for ?2,500 that I can add a Digital Read Out too while keeping the old one I guess.

If you have a phone or gps enabled device, then you can download digital speedometer app.

Go to app store and look up then download it to use it while you use it in your car..

Or look for aftermarket shops and you can replace the analog dashboard with your new digital dashboard.

Never really liked the look of a Honda Civic Interior TBH.

Just looking for a nice, decent car for ?2,500 that I can add a Digital Read Out too while keeping the old one I guess.

My aunt has a Suzuki Areo and it had a stock digital speedo, it was inaccurate at times (I find the one in the civic's to be the same case) Nothing beats a dial.

My aunt has a Suzuki Areo and it had a stock digital speedo, it was inaccurate at times

You know, my Mazda was the same. Then, when I was doing the research mentioned in my post further up I noticed that the speed figure received straight from the car's diagnostics bus was much more accurate, and the display was intentionally inaccurate (by around 5% faster than I was actually travelling).

Turns out it's legal for a speedo to be calibrated to read up to 10% too fast, but not for it to read too slow, so car manufacturers intentionally make their speedos a bit too fast to give them a safer margin.

It *also* turns out that all the cars with dials I've had since then are the same, but because you read it as "almost 50mph" instead of "47mph", you notice it a bit less.

If you can't get an in dash replacement, I would honestly suggest you learn how to use an analogue speedo.

Do not try and use a GPS device as a speedo. There are tons of reasons why, including inaccuracy, but also in most countries you will find it's illegal due to the screen or where it's placed or whatever else.

I'd recommend getting a car with dials until you learn how to drive. I'm sorry, but "I don't like it" is ridiculous, you need to know how to read the needles first, then go to a digital.

My car has a standard cluster, with digital speed read out, it came standard with the car. Addons and GPS are not accurate.

You know, my Mazda was the same. Then, when I was doing the research mentioned in my post further up I noticed that the speed figure received straight from the car's diagnostics bus was much more accurate, and the display was intentionally inaccurate (by around 5% faster than I was actually travelling).

Turns out it's legal for a speedo to be calibrated to read up to 10% too fast, but not for it to read too slow, so car manufacturers intentionally make their speedos a bit too fast to give them a safer margin.

It *also* turns out that all the cars with dials I've had since then are the same, but because you read it as "almost 50mph" instead of "47mph", you notice it a bit less.

This was a tolerance thing with cable drive speedos. This doesn't occur in new vehicles. Our shop diagnostic equipment can confirm this too.

Anyway, people don't seem to worry about their speedo being out, just look at the majority of people who have put biggers wheels on their car, and not had the speedo re-calibrated or the default wheel setting changed in the ECU.

This was a tolerance thing with cable drive speedos. This doesn't occur in new vehicles. Our shop diagnostic equipment can confirm this too.

I think you misread my post. While doing the research, I did a 20 minute-long run at 100mph indicated (circular track at Millbrook in the UK). The speedo read 100 mph the whole way, while the ODB bus was reading 96 mph the whole way. The display had an intentional increase.

I think most modern cars have digital dials (but in analog format) I know my Grand Prix's analog gauges are connected to the car's data bus, no analog connection, just data and power. the ODB2 bus though updates a lot less frequently... if its a newer car you might be able to find a gauge cluster that replaces your "analog" gauges with digital ones

but seriosusly though, learn to drive with gauges... even new digital cluster cars have analog gauges on them shown graphically

I'd recommend getting a car with dials until you learn how to drive. I'm sorry, but "I don't like it" is ridiculous, you need to know how to read the needles first, then go to a digital.

I 100% agree. Learn to drive your car the "normal" way, then look at changes.

I 100% agree. Learn to drive your car the "normal" way, then look at changes.

Honestly, I quite agree. If you can't tell how fast you are going by either looking at the dial (which come on, is not a difficult task AT ALL) or by just a judgement of speed, I do not want you driving on the same roads as me. Fortunately, OP is in England.

Let's face it, learn it the "normal" way, because 95%+ of the cars have analog dials. Some may have digital only or a combination of both. Just learn or adapt.

I wouldn't bother, just learn the analogue way (is it even learning?) you tilt your eyes slightly now and then to see the speed. Honestly as you learn to drive you'll find you're able to judge the speed when you're used to the car, same way you learn to change gear by hearing the revs.

If you can't learn to drive with an analogue speedo (everyone else has). Then i doubt you'll be able to put a dash replacement in the car :laugh:

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • That is $130 more than I paid for my 4TB a year ago. How is this a deal?
    • JetBrains' new AI-first 'IDE' JetBrains Air is now on Windows by David Uzondu JetBrains has announced that JetBrains Air, its Agentic Development Environment (ADE) is now available for download on Windows x64 and ARM. You might not be familiar with JetBrains Air. It's this new desktop app that the company launched back in March 2026 to let developers hand off tasks to AI agents instead of writing every line manually. You can see it as more of an Agentic Development Environment (ADE) rather than a traditional Integrated Development Environment (IDE). The latter builds its features around a central text editor, while the former arranges everything around the AI agent itself. Here's how JetBrains describes it: Air was born from the ashes of Fleet, an experimental editor that the company quietly killed in December 2025 after realizing that competing directly with VS Code was a losing battle. The company repurposed Fleet's lightweight, modern architecture to build Air, transforming a basic code editor into a workspace for running multiple AI agents. When Air launched, it was only available for macOS. It wasn't until earlier this month that Linux users got a chance to play with the software. Now that Air is on Windows, you can do things like map out a complex feature in Plan mode and watch an AI write the implementation plan to a markdown file before writing any code. You can iterate on this plan, add references to specific classes or files, and choose whether to run the agent locally or inside an isolated Git worktree. Running agents in parallel means you can have Claude refactor a database schema in one branch while Codex writes tests in another, leaving you free to do other important things. You can even set up a pipeline where Claude writes the code, and Codex reviews it. At the moment, Air is free. If you have a JetBrains AI Pro or Ultimate subscription, you get full access to the built-in agents, though there's also the option to Bring Your Own Key (BYOK) to run APIs from Anthropic, OpenAI, or Google. If you're interested, here are the download links for both x64 and ARM64.
    • Depending how you’re wiring it internally, but try to put it inside conduit, that way in the future you can more easily replace cables, compared to running inside studs alone At least cat6a too
    • I bet Meta has lots of info on you anyway, gathered by other means. And Google, and Microsoft, and every other tech giant. If you use some form of modern electronic device, they own you already...
    • I'm using Windows 11 Pro 25H2 on "ancient" hardware, too: - Core i7 3770K - GTX 1050 2GB - 16GB DDR3 1333 MT/s It runs flawlessly, not a single issue. I also have it on other ancient setups, but I don't remember the exact specs right now (Intel 4th. generation).
  • Recent Achievements

    • Reacting Well
      NovaEdgeX earned a badge
      Reacting Well
    • Week One Done
      NovaEdgeX earned a badge
      Week One Done
    • One Year In
      BA the Curmudgeon earned a badge
      One Year In
    • Conversation Starter
      rosiecharles earned a badge
      Conversation Starter
    • First Post
      KMilenkoski1202 earned a badge
      First Post
  • Popular Contributors

    1. 1
      +primortal
      530
    2. 2
      +Edouard
      264
    3. 3
      PsYcHoKiLLa
      149
    4. 4
      Steven P.
      97
    5. 5
      macoman
      60
  • Tell a friend

    Love Neowin? Tell a friend!