Recommended Posts

Earlier today my PSU (Rosewill 630watt) appears to have died. it's 2.x years old as i got it sometime early 2010.

my CPU/Motherboard/RAM (ASUS P8H61-M LX Plus MOBO/i3-2120 CPU) i got May 2012 and everything has been stable so far until today when the PC turned off mid-day and the PC would not turn back on.

so is it safe to assume my PSU is dead?

p.s. i never had good luck with PSU's as in this same PC i have replaced the PSU once already and this will be the 2nd time (first PSU lasted from March 2006 til early 2010). but i am planning on getting a 'Seasonic 520w' which has a 5 year warranty for $75 out the door which is here... http://www.newegg.co...N82E16817151093

Link to comment
https://www.neowin.net/forum/topic/1116445-dead-psu/
Share on other sites

well there is no power light on the motherboard right now and it's plugged in.

only thing i have to test the PSU on is a motherboard sitting on my floor which is the old one i had replaced May 2012 with the current board. but that board (ASUS A8N32-Sli Deluxe) still works fine.

is there a way i can just plug in the power to the board etc just to see if it starts up WITHout installing it into a case since that would be a big pain to do right now since i would have to remove my current mobo?

Link to comment
https://www.neowin.net/forum/topic/1116445-dead-psu/#findComment-595289941
Share on other sites

Try jump starting the PSU: http://forum.overclo...hread.php?t=394

i just tried that and it appears to be dead.

just to make sure i did it correctly i had it unplugged and then had it (the paper clip(steel one obviously ;)) touching the green/black prongs and then plugged it in and nothing. then i even flipped the power switch a couple of times while the wire was there and nothing. then just to make sure i even had the power switch one way and then tried to do the paper clip as it was in one position and nothing and then removed the paper clip and tried the other position on the on/off switch on PSU and still nothing. so that should have covered pretty much everything you can try with that paper clip according to that article.

so it's pretty safe to assume the PSU is dead now?

and by the way... thanks for your time and everyone else.

p.s. i placed the order for that SeaSonic above in my initial post as hopefully getting a PSU with a 5 year warranty will finally give me a PSU that lasts but i have a feeling with my luck that eventually ill be making a claim on that warranty, lol. but supposedly the capacitors are of higher quality on those higher warranty PSU's?

Link to comment
https://www.neowin.net/forum/topic/1116445-dead-psu/#findComment-595291073
Share on other sites

If it doesn't jumpstart using the paper clip method, it's more than likely dead, although off I were you, I would still try a spare psu on the newer board just to make sure there's nothing wrong with the system, that is, if you have a spare one to test with. Sounds like it's history to me though. (The psu, that is) (Y)

Whoops...*IF I were you...auto correct got me, lol

Link to comment
https://www.neowin.net/forum/topic/1116445-dead-psu/#findComment-595291083
Share on other sites

If it doesn't jumpstart using the paper clip method, it's more than likely dead, although off I were you, I would still try a spare psu on the newer board just to make sure there's nothing wrong with the system, that is, if you have a spare one to test with. Sounds like it's history to me though. (The psu, that is) (Y)

Whoops...*IF I were you...auto correct got me, lol

Yeah, thats the best option is to test with another PSU but i don't have any other one to try otherwise i definitely would just to make sure the system is stable etc.

technically i got another PSU but... it's powering a old Athlon 1.2ghz (the PC i am using to type this) which obviously won't work with newer style boards.

but anyways... is it uncommon for a PSU to fry the board (and other components) when they fail? (i have had 3 PSU's die and, so far, none harmed my motherboard or any other components)

Rosewill is about the cheapest you can get, n_k.

Yeah, it was cheap at the time as i needed something cheap but provide decent stable power and that was basically my best option back then.

but since it only lasted 2 years and some odd months it just goes to show it's pretty low quality in terms of it's longevity and this new one (SeaSonic 520watt) should be much better due to 5 year warranty.

p.s. i do leave my PC running 24/7 though.

Link to comment
https://www.neowin.net/forum/topic/1116445-dead-psu/#findComment-595291141
Share on other sites

yes, it's pretty uncommon, but you know, just to be sure and all never hurt anything....but I'm 99% positive that just the PSU was affected, by the sound of it. (Y)

Link to comment
https://www.neowin.net/forum/topic/1116445-dead-psu/#findComment-595291173
Share on other sites

Well i just got the PSU (Seasonic 520watt) in today and i just finished installing it not long ago and so far so good as everything starts right up and so far everything seems stable as ill probably run a Prime95 test and FurMark test on it for CPU/GPU stability etc.

but anyways... thanks for everyone's time. i appreciate it ;)

Link to comment
https://www.neowin.net/forum/topic/1116445-dead-psu/#findComment-595301763
Share on other sites

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • One of the strangest galaxies in our Universe could help answer some long overdue questions by Sayan Sen Image by Pixabay via Pexels | Not representative An international team of astronomers led by the Department of Astronomy at Tsinghua University has discovered an unusually metal-poor galaxy that may contain signs of first-generation star formation. The galaxy, named Metal-Pristine Galaxy COSMOS Redshift 3 (MPG-CR3), or CR3, was identified using observations from the James Webb Space Telescope (JWST), the Very Large Telescope (VLT), and the Subaru Telescope. The findings, published in The Astrophysical Journal Letters, describe CR3 as the most metal-poor galaxy known from the period known as "cosmic noon," around 11.5 billion years ago. Cosmic noon refers to a period when the universe was producing stars at its highest rate and galaxies were growing rapidly. In astronomy, "metals" refers to all elements heavier than helium, including oxygen, carbon, and iron. Because CR3 contains so few of these heavier elements, researchers say it closely resembles what scientists expect the earliest galaxies in the universe may have looked like. The discovery is significant because it could offer clues about Population III (Pop III) stars, the first generation of stars thought to have formed after the Big Bang. These stars are believed to have formed from gas made almost entirely of hydrogen and helium, before heavier elements were created inside stars and spread across the universe through supernova explosions. Hence this is why CR3 has been referred to as a "living fossil." Scientists have long believed that Population III stars existed only in the very early universe. As more generations of stars formed and died, they enriched surrounding gas with heavier elements, making the conditions needed for metal-free star formation increasingly rare. Because of this, researchers expected the formation of such stars to have largely ended after the epoch of reionization, a period when radiation from the first stars and galaxies transformed the neutral hydrogen filling the universe and made it largely transparent to ultraviolet light. CR3 appears to challenge that idea. The galaxy was observed at a redshift of z = 3.193 ± 0.016. Redshift measures how much light from a distant object has been stretched as the universe expands and helps astronomers determine how far back in time they are looking. In this case, the redshift corresponds to roughly 11.5 billion years ago during cosmic noon. Although the universe was already several billion years old by that point, CR3 shows characteristics more commonly associated with much earlier galaxies. Observations revealed exceptionally strong emissions from hydrogen and helium, including Lyα, Hα, and He I λ10830. Lyα, or Lyman-alpha emission, is a specific wavelength of light produced by hydrogen and is widely used to study distant galaxies. Hα emission is another hydrogen signature commonly used to trace active star formation, while He I λ10830 is produced by helium and can indicate the presence of very hot, young stars. The measured equivalent widths of EW₀(Lyα) = 822 ± 101 Å and EW₀(Hα) = 2814 ± 327 Å are among the highest ever observed in star-forming galaxies. Equivalent width is a measure of the strength of an emission line relative to the surrounding light, and such large values are typically associated with intense and very recent star formation. At the same time, researchers found no statistically significant detections of metal emission lines, including [O III] λλ4959, 5007 and C IV λλ1548, 1550. Emission lines act as chemical fingerprints that reveal which elements are present in a galaxy. Oxygen and carbon lines are commonly seen in galaxies that have already undergone significant chemical enrichment. Their absence in CR3 suggests an unusually pristine environment. Using abundance calibration methods developed with JWST observations, the team placed a 2σ upper limit on the galaxy's gas-phase metallicity of 12+log(O/H)<6.52, corresponding to less than 0.7% of the Sun's metallicity (Z < 7 × 10⁻³ Z⊙). Gas-phase metallicity measures the abundance of heavy elements in a galaxy's gas. A 2σ upper limit indicates that the true value is very unlikely to be higher than the quoted threshold. Even when accounting for uncertainties in the calibration methods, the most conservative limit remains 12+log(O/H)<6.95, making CR3 the most metal-poor galaxy identified at cosmic noon. The galaxy also appears to contain very little dust. Researchers measured a Lyα/Hα flux ratio of 13.9 ± 2.5, a result that suggests negligible dust attenuation, meaning very little of the galaxy's light is being absorbed or scattered by cosmic dust. Because dust is usually produced by earlier generations of stars, this finding further supports the idea that CR3 has experienced very little chemical enrichment. Further analysis using spectral energy distribution modelling, a technique that compares observed light with theoretical models, suggests that CR3 contains an extremely young stellar population only around 2 million years old. The modelling, which used Population III stellar templates, also indicates the galaxy has a stellar mass of approximately 6.1 × 10⁵ M⊙. The symbol M⊙ represents one solar mass, or the mass of the Sun. One of the key questions raised by the discovery is how such a chemically primitive galaxy could exist in a universe that had already spent billions of years producing heavier elements. To investigate this, the researchers examined CR3's surroundings. Their analysis suggests the galaxy may lie in a slightly underdense environment, with a density contrast of roughly δ ≈ −0.12. An underdense region contains less matter and fewer galaxies than average. The team suggests that this relative isolation may have helped preserve pockets of pristine gas. Metal-rich material expelled from nearby galaxies may never have reached CR3, while the lower rate of galaxy mergers and interactions could have slowed the mixing of enriched gas into the system. If future observations confirm these findings, CR3 could provide some of the strongest evidence yet that first-generation star formation continued well after the epoch of reionization. Such a result would challenge the conventional view that pristine star formation ended by z ≳ 6 and suggest that small pockets of metal-free gas survived much longer than previously thought. Researchers stress that more observations will be needed to determine the galaxy's true nature. Future spectroscopic studies with higher resolution and better signal quality could help confirm whether CR3 is genuinely hosting Population III star formation. The discovery is also expected to encourage searches for other similar galaxies, which could help astronomers better understand how the first stars formed and how galaxies evolved in the early universe. Source: Tsinghua University, IOPscience This article was generated with some help from AI and reviewed by an editor. Under Section 107 of the Copyright Act 1976, this material is used for the purpose of news reporting. Fair use is a use permitted by copyright statute that might otherwise be infringing.
    • "I think in the immediate absence of a partner to apply relief" In the words of Sterling Archer... "Phrasing!"
    • For me, the fundamental problems with these "smartglasses" is that they really don't work well for people with significant prescriptions and massively up the price if you use attached lenses if they have displays, and if they don't, then they're not actually "smart" anything, rather just connecting to your phone and relaying voice to an AI. In a few cases like this, they throw in small cameras to feed video to the AI. All around, these feel like both a solution looking for a problem, and the problems it tries to solve seem more easily solved by different approaches and designs. Oddly, if the rumours are true, Apple may actually have invented something for once and it kind of does this right: put cameras in ear buds and manage the interface to AI exactly as most of us do: tapping on an ear bud and saying "Hey Google" or "Hey Siri." That makes them compatible with almost everyone, can double up as a hearing assist device, an impaired vision assist device, a "smart" device... and answer your phone and play music. That just seems like a better solution all around.
    • Usually the bigger ones with many fixes/changes take a few, theyre an exception to the rule most likely
    • If you don’t get lucky with Valve’s Steam Machine reservation system, you can make your own Steam Machine instead. Valve says that “starting with the SteamOS 3.8 release, you can put together your own Steam Machine using whatever PC parts you want.” SteamOS 3.8.10 launched last week with a slew of updates, including “improved compatibility with recent Intel and AMD platforms.” Alongside that improved compatibility, Valve is giving gamers the green light to install SteamOS on their own desktops. In an interview with The Verge, Valve’s Pierre-Loup Griffais said Valve has been “rolling out improvements to [SteamOS] so it’s more compatible with desktop hardware,” including eventual support for Nvidia graphics. Griffais says Valve has “a growing team” working on Nvidia driver support for SteamOS, adding, “We’re collaborating with Nvidia very closely.” While he mentioned that Nvidia support might not come this year, Griffais emphasized that “it’s certainly something that we’re working on in the background.”     Subscription not needed: https://archive.fo/Tssfc Subscription needed: https://www.theverge.com/games/953411/valve-steamos-desktop-nvidia
  • Recent Achievements

    • Dedicated
      HidekoYamamoto94 earned a badge
      Dedicated
    • One Month Later
      timbobit earned a badge
      One Month Later
    • One Month Later
      nates earned a badge
      One Month Later
    • Week One Done
      Almohandis earned a badge
      Week One Done
    • Rookie
      dorf went up a rank
      Rookie
  • Popular Contributors

    1. 1
      +primortal
      452
    2. 2
      +Edouard
      161
    3. 3
      PsYcHoKiLLa
      107
    4. 4
      Michael Scrip
      84
    5. 5
      Steven P.
      70
  • Tell a friend

    Love Neowin? Tell a friend!