HW RAID 5 Freezing


Recommended Posts

Hello all,

I have a hardware RAID 5 using an Areca SAS controller. I have two RAIDs on it one two drive RAID 0 and one four drive RAID 5. My dilemma is if I try to access the RAID 5 with file copy commands etc it stalls out. My RAID 0 on the same controller does not stall at all. I have done everything to my pc to make sure it wasn't my motherboard by updating firmware on it, the RAID controller, the latest drivers etc. The odd thing is in the controller none of the member disks in the RAID 5 have a bad SMART status all of them look just fine and the controller did a full volume check and its healthy. I was even able to do a CHKDSK with windows and it worked and passed with no errors. I don't know of a good way to readily identify which member disk might be faulty since their SMART status is good and I have a lot of data I need to get off the RAID if its looking like it might fail but any copy over a couple minutes stalls it out :(. Any ideas would be greatly appreciated, I un-mounted the volume till I can sort something out.

Link to comment
https://www.neowin.net/forum/topic/1118491-hw-raid-5-freezing/
Share on other sites

I had a similar issue with a hardware raid controller that had an external memory dimm. I replaced the dimm and it resolved the problem. Mind you, your saying only your raid 5 suffers the issue. But if you haven't checked it already. Doesn't hurt to rule it out.

Thanks for the reply. My controller has 256MB of RAM directly soldiered onto it but I have been suspecting the controller as well, even though my RAID 0 on it is running solid.

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • We had no idea as kids how much time and energy it took to be an adult 😅
    • The Trump administration doesn't want you to use OpenAI's GPT-5.6 without its approval by David Uzondu Image via @realDonalTrump (X) As OpenAI prepares the release of its next model, GPT 5.6, the White House has instructed the company to limit the distribution of the software to a small group of government-approved partners instead of the general public, as it has done with previous releases. According to The Information, OpenAI Chief Executive Officer Sam Altman sent an internal memo to staff on Thursday explaining that the federal government will approve access "customer by customer" during an initial preview phase. Altman noted in the communication that this restrictive rollout is "not [their] long-term model" for software deployment, and the company plans to work toward a "more sustainable" distribution method later. CNN said that both OpenAI and the Trump administration view the capabilities of GPT 5.6 on the same level as Anthropic's Mythos and that government officials intend to "collaborate with frontier AI labs to develop shared approaches for addressing the challenges of scaling this technology." The latest restriction comes just weeks after the US Commerce Department decided to restrict Fable, a version of Mythos with extra safety "guardrails" to prevent users from exploiting software vulnerabilities. Not long after the release, though, researchers at Amazon found a way to bypass these restrictions, prompting an aggressive response from federal authorities. The government ordered Anthropic to cut off access for non-US citizens located outside the US, non-US citizens living inside the US, and incredibly, even Anthropic's own foreign-born employees. Anthropic now appears to be building a workaround to resolve this compliance block with an update to its Privacy Policy that introduces a category called "Verification Data" to handle KYC and Digital IDs. This setup could mandate digital identity checks to filter users by nationality, requiring a government-issued ID and facial biometric data. Who knows? Maybe in the future, you would have to scan your US Passport or State ID to prove your citizenship before you are allowed to chat with Fable 5 (or any other model).
    • When Windows 7 was released I created an AutoHotkey script that uses Alt+` as a keyboard shortcut to move a window across monitors. I have been using that script for over 15 years and this is the first time I have come across another app that uses the same shortcut!
    • I called it last year that they wouldn't end support when they said there would. There are too many people still on Windows 10 waiting for something better to upgrade to and 11 ain't it! The recent promises of fixing Windows 11's many problems is nice, but unless they deliver on those promises in a big way then I expect customers will still want to stick with 10.
  • Recent Achievements

    • Week One Done
      xvvxcvv earned a badge
      Week One Done
    • One Month Later
      xvvxcvv earned a badge
      One Month Later
    • Enthusiast
      Xonos went up a rank
      Enthusiast
    • Conversation Starter
      Admir earned a badge
      Conversation Starter
    • First Post
      The_Focal_Point earned a badge
      First Post
  • Popular Contributors

    1. 1
      +primortal
      411
    2. 2
      +Edouard
      169
    3. 3
      PsYcHoKiLLa
      129
    4. 4
      neufuse
      69
    5. 5
      Xenon
      67
  • Tell a friend

    Love Neowin? Tell a friend!