Recommended Posts

I just spent over a $100 in computer parts (an Intel DG41TY motherboard -- manual: http://downloadmirror.intel.com/17101/eng/DG41TY_ProductGuide01_English.pdf , a 450W power supply, 2 x 1GB of DDR2 RAM chips and a P$ CPU with 3GHz speed for socket 775).

I can't get the damn thing to post...I've connected both the main power supply connecter which covers all the pins and the 4-pin square connector.

I've also connected a 3-pin CPU cooling fan to the 4-pin connector on the motherboard ...(it looked ok to do because you can only put it on one way).

Looking at the documentation provided with the PDF listed above there were only two locations of the front panel for power which I've tried to test by tripping with a laptop screw driver with no success. I see one green solid light on the MB when I turn on the power for the power supply and that's it.

Please advise!

Thanks in advanced for any helpful response.

Link to comment
https://www.neowin.net/forum/topic/1125060-motherboard-not-posting/
Share on other sites

The light you see on the board, verifies that you have power connected.

Do you get any fans spinning, beeps, or anything?

Try reseating the CPU and RAM. If no dice, try resetting the BIOS by removing the watch battery for a few minutes, and reinsert.

What are your full specs?

Perhaps he shorted the wrong pins then. If the mobo is indicating it's getting power, then there's not much of a reason why shorting the correct pins together wouldn't power it on.

The only other thing it could be is cracked solder connections or something flawed on the pcb traces. Both of which are pretty difficult to fix.

Since these are really old components, I would have to assume they are used. Scammed by the seller perhaps?

could be a bum mobo. are you sure you hooked up all of the power?

It is very important to have "G" and "I" plugged in on the pic on page 11..."E" and "O" should also be plugged into a fan.

http://downloadmirror.intel.com/17101/eng/DG41TY_ProductGuide01_English.pdf

Also check "U" pins 1 and 2 should be jumped.

Are you absolutely sure your PSU works fine?

I only ask as my old EZcool psu blew up last year, and after a day of troubleshooting, it turned out that even though the green light was on, on my mobo, the psu was at fault

(an embarrassingly easy oversight, just a possibility)

I've found the pins that give it power but after reseating the memory and cpu and then the BIOS battery after about ten seconds...after

I short the pins the power supply fan turns and the cpu fan turns but the monitor I know works that's connected to the mb doesn't show a display and no POST beep.

Like I said connector I is a 4-pin...what I have connected is a 3-pin yet it powers the cpu fan to turn.

I'm getting an RMA# for this motherboard...in the mean time I need to get an alternative

system going for my customer...and need to know if this memory: PC2-3200/4200 DDR2 SDRAM DIMMs

is interchangable with a DDR2 RAM 800MHz PC2-6400 240-PIN DIM for a GX520 Optiplex

Desktop computer...please advise.

Buy a prebuilt. Much less headache. And you don't warranty it like you are now. How much time have you spent on this convert that to money by how much you charge and figure out how much money you lost so far.

Now you have to take it apart put it back together and you still need to load the os, drivers, and apps. I would say right now you are in the hole at least 100 and you haven't even started.

150 can get an old prebuilt. 300 gets you brand new.

I had this before and it was because I hadn't earthed the motherboard correctly (didnt put in all the screws)

so be sure its earthed/ remove it and reseat it.

I would say right now you are in the hole at least 100 and you haven't even started.

150 can get an old prebuilt. 300 gets you brand new.

Plus the $100 he already spent on parts. so thats $200 already :laugh:

(I'd still build it myself though)

That's why I'm going to RMA this back to them...and if don't respond they'll have to respond

to BBB...it didn't come with manual ...so it's possible I tried to start it with the wrong two pins

at first. Can somebody please answer question regard the memory???!

yes and you client is out of a computer for how long? Home built computers are good for yourself and maybe family members, anything outside of that buy a prebuilt dell, hp, lenovo, cyberpower, emachines, etc.... I will never ever build another computer for anyone outside of that esp if they live more than 10 minutes away....I am not dealing with that headache, they can call the manufacturer or I can call the manufacturer and have one of their techs come out to do whatever. I charge $150 an hour for my time, 2 hours and they spent what they would on a new computer prebuilt, all I need to do is some clean up which usually doesn't take more than 30 min.

As far as the memory goes, I believe that dell will only accept pc2 5300 and pc2 6400 and is maxed at 4GB.

http://www.crucial.c...20GX520&Cat=RAM

This topic is now closed to further replies.
  • Posts

    • Google reshuffles its AI coding team as it struggles to catch Anthropic by Karthik Mudaliar Google is already reorganizing the AI coding “strike team” it created roughly two months ago, as it attempts to find ways to close the gap with Anthropic in one of generative AI’s most commercially important areas. According to The Information, Google DeepMind is expanding the team’s focus to include “midtraining,” rather than concentrating only on coding tools and agents. Midtraining takes place after a model’s broad initial training but before the final stages that prepare it to follow instructions and perform specific tasks. In simple terms, it gives developers another opportunity to expose a model to carefully selected data before it is polished for release. That could help Google improve Gemini’s underlying coding abilities instead of relying only on better prompts, interfaces, or post-training. Previous research has found that midtraining can be particularly effective for code and mathematics, where models must move from general language knowledge to more structured tasks. Google reportedly created the original strike team in April. It was led by Google DeepMind research engineer Sebastian Borgeaud, who previously worked on model pretraining, and focused on complex, long-running programming jobs. Google co-founder Sergey Brin and Google DeepMind chief technology officer Koray Kavukcuoglu were also reportedly involved in the effort. DeepMind researchers were said to believe that Anthropic’s coding tools were outperforming Google’s Gemini models, prompting the company to give the project more attention. Anthropic has made coding a central part of its AI strategy through Claude Code and its Claude model family. The company has continued improving that area, with Claude Opus 4.8 offering upgrades for coding and other agentic tasks, along with the now-unavailable Mythos and Fable models. The reshuffle also comes at a time when Google faces increased competition for AI researchers. Gemini co-lead Noam Shazeer recently announced that he was leaving Google for OpenAI, while two other researchers who contributed to Gemini and DeepMind projects are reportedly preparing to join Anthropic. It remains unclear whether the reorganized team will produce a new public Gemini model or developer product. No release date, team size, or specific performance target has been disclosed. Source: The Information
    • Just remember - Microsoft is a trillion dollar company. They didn't have to raise the price this high. They chose to.
  • Recent Achievements

    • First Post
      kinowa earned a badge
      First Post
    • Rookie
      krychek57 went up a rank
      Rookie
    • Grand Master
      Jaybonaut went up a rank
      Grand Master
    • One Year In
      Philsl earned a badge
      One Year In
    • Dedicated
      Scoobystu earned a badge
      Dedicated
  • Popular Contributors

    1. 1
      +primortal
      413
    2. 2
      +Edouard
      168
    3. 3
      PsYcHoKiLLa
      132
    4. 4
      Xenon
      73
    5. 5
      Michael Scrip
      73
  • Tell a friend

    Love Neowin? Tell a friend!