Delay in Remote Desktop Connection. What are possible solutions?

By kiddingguy
in Smart Home, Network & Security

 Share

Recommended Posts

Grand Master

kiddingguy

Posted
Posted

I am experiencing delays and reconnecting issues when connecting to RDP. Both wired and wireless.

I have purchased a new router - Linksys EA3500 - and still these issues occur.

Ping tests stated around 18ms for my connection.

My internet speeds/subscription are 120 MB down, 10 MB up. I have tested with different "Experience / Performance" settings within RDP, from low-speed broadband to high-speed broadband; all without success.

I have KIS2013 installed with default settings on both computers (wired and wireless).

What can be the issues for these delays/secs of 'hickups' during the RDP-connection?

Grand Master

+BudMan MVC

Posted
  • MVC
Posted

RDP connections to where? Some box on the internet, or between boxes on your own network - wired to wireless, wireless to wireless, wired to wired?

Also what do you consider delay, 2 seconds, 5 seconds, 10, 20, 3 minutes?

Grand Master

kiddingguy

Posted
  • Author
Posted

RDP to some box (server) on the internet - our server 80 km away.

The server is wired to its backbone/Internet, I make a RDP-connection via my computer (wired) or notebook (wireless) from home (or elsewhere) - I use its name/alias and not the IP.

The delay is a couple of seconds (mostly 2-5 sec); screen 'freezes', reconnecting popups appears, connection is back again and I can start working again...

And this once every 2-5 minutes.

EDIT:

adjusted delay time to real circumstances

Grand Master

+BudMan MVC

Posted
  • MVC
Posted

well there could always be a slight delay in resolving to its FQDN, I think that is what you meant by name/alias because those are not resolvable on the internet but a fully qualified domain name is ;) something.something.tld

so you its not really a delay in connection, but a loss of connection and reconnect

"this once every 2-5 minutes."

Are you connecting via a VPN to this server, or just the normal RDP 3389 just over the internet? Is there any firewall on the other end limiting connections to this port to only where your coming from?

You put 3389 open on the public internet and its going to get hit quite often with people attempting to log in.

If your saying it happens every few minutes I would look at logs on server side for any hints, and also would sniff the traffic from your connection. This will show you if your getting a lot of retransmission on lost packets, etc.

Grand Master

sc302 Veteran

Posted
  • Veteran
Posted

lagging could be upstream not fast enough to handle request, could be dns not fast enough to handle name resolution...you mention your upstream, is your upstream the upstream at home or your upstream at the office. The upstream at the office needs to be ~1Mb/s for optimal response...your down stream at home needs to be at least that. Also the dns plays quite a bit into speed, try connecting to the ip to negate dns being an issue. if it is fast connecting to the outside ip, then the issue is dns related.

Grand Master

kiddingguy

Posted
  • Author
Posted

it's kinda strange... when I use my cell phone with tethering (wayyy slower connection, everything is ok) on the same notebook, I have a good connection and no delay/lag.

It seems that either my modem or router is the "bad kid in town".

I just got a new router today - default settings - so that should not be the issue.

I might just check a direct cable connection from my modem to my computer (thus cancelling out the router) and see what happens...

I'll come back to this latter thing.

@ +Chris13NT, how can I prevent this? Or is this ISP-related?

Grand Master

kiddingguy

Posted
  • Author
Posted

Just tested it "quick and dirty" and the delay/lag is not present when connecting directly to the modem.

When I put my router in between the lag is there yet again.

There is a power/surge adapter to prevent over-voltage, but this hasn't been an issue ever since.

Might it be cable related? And that one of the UTP-cables has been damaged/is broken?

Replacing might help, but that I need to get myself some new cables....

By the way, the current cable-setup is:

ISP-entrance in my home - cable to modem, provided bij ISP - modem - cable to surge-adapter - cable to router, from there the standard 4 GBit ports of this EA3500 to computer and other periphicals + router wireless to notebook and other periphicals.

Grand Master

sc302 Veteran

Posted
  • Veteran
Posted

What is your dns configuration when connection directly to the modem?

start, run, cmd

ipconfig/all

What is your dns configuration when connected to the router?

start, run, cmp

ipconfig/all

change the dns on your adapter to the dns that you are getting when you are on the modem. does the same problem exist?

Grand Master

+BudMan MVC

Posted
  • MVC
Posted

dns could be the problem on initial delay, or just failure to resolve - but once the connection is established and having freezes every few minutes does not seem like a dns related problem to me.

Grand Master

Chris123NT

Posted
Posted

What kind of router is it? Some routers have trouble with connections over 50mbit, I had a Linksys E3000 and it couldn't cope with my 85mbit FiOS line, it would crap out every time I pegged the download.

It could be cable related but I doubt it.

Grand Master

kiddingguy

Posted
  • Author
Posted

I have a brand new Linksys EA3500. It should get "Transfer rates up to 300 + 450 Mbps".

The DNS I get when connect to the router is 1 IP: 192.168.1.1

When directly connected to the modem DNS server is 2 IP's: 213.48. .... and 62.179. ...

Grand Master

+BudMan MVC

Posted
  • MVC
Posted

yeah those are from your ISP when connected to modem, and when connected to router your using it as your dns forwarder. This is a common setup, your router would then forward dns to those handed to your router via your ISP 213.48 and 62.179

But again if your having the issues once your connected, it seems highly unlikely that it would be dns related.

Grand Master

kiddingguy

Posted
  • Author
Posted

yeah those are from your ISP when connected to modem, and when connected to router your using it as your dns forwarder. This is a common setup, your router would then forward dns to those handed to your router via your ISP 213.48 and 62.179

But again if your having the issues once your connected, it seems highly unlikely that it would be dns related.

Thx. So what can it be?

Grand Master

sc302 Veteran

Posted
  • Veteran
Posted

unlikely sure, test it, verify it, make sure. be sure, not be somewhat sure....perhaps the router is being retarded when forwarding, it is a link in the chain....remove the link.

I thought it was initial connection....if it is not initial connection, then it is not dns related. something is happening with the traffic when it goes from router to modem.

Grand Master

Chris123NT

Posted
Posted

Can you to a trace route to the IP of the RDC server? This might give a clue if you have a hop with unusually high ping.

do tracert <ip (or dns name)> in cmd

The fact that the lag only happens when the router is in the link is making me almost positive it's the router botching things.

Grand Master

kiddingguy

Posted
  • Author
Posted

Can you to a trace route to the IP of the RDC server? This might give a clue if you have a hop with unusually high ping.

do tracert <ip (or dns name)> in cmd

In which setup and from where?

From my computer, connected via router, to the RDC server?

Or from the RDC server to my computer? (and also here via router or directly connected to modem?)

Grand Master

Chris123NT

Posted
Posted

Off topic but in reply to Chris, my e2000 handles my 120mbit line with ease and it has a slower CPU than your e3000..

So something is up there..

It could have just been going bad, or it could have been DD-WRT's fault.

Grand Master

kiddingguy

Posted
  • Author
Posted

Can you to a trace route to the IP of the RDC server? This might give a clue if you have a hop with unusually high ping.

do tracert <ip (or dns name)> in cmd

The fact that the lag only happens when the router is in the link is making me almost positive it's the router botching things.

What kind of info do you need from this trace?

From which hop# there is a time out? or else?

Grand Master

kiddingguy

Posted
  • Author
Posted

There has been some less delays (but still annoying) with the new FW... although I had to wrestle myself through the Cisco Cloud Connect.

Still some delays.

Question remains....

EDIT:

I guess I was over-enthusiastic... delays still remain as strong as before :(

This topic is now closed to further replies.
 Share
Go to topic listing

  • Posts

    • Apple reportedly looks to blacklisted Chinese memory chips as RAM prices climb

      By Karthik Mudaliar · Posted

      Apple reportedly looks to blacklisted Chinese memory chips as RAM prices climb by Karthik Mudaliar Image via Apple Apple is reportedly trying to get a clearance from the Trump administration to buy memory from ChangXin Memory Technologies (CXMT) to get some relief from soaring DRAM prices. As per a report by the Financial Times, Apple approached the Commerce Department more than a month ago and also spoke to other officials and allies in Washington. For starters, CXMT is a company that's already been placed on the Pentagon's list of Chinese military companies. The Chinese company is the country's top DRAM maker. For Apple, the timing is certainly awkward but not surprising. Tim Cook had recently warned that Apple would have to raise prices because AI companies are buying up large amounts of memory for data centers, and just like that, Apple raised MacBook and iPad prices. Micron also recently revealed that customers have committed billions of dollars to secure memory supply years in advance, which shows us how aggressive securing infrastructure has become. This gives suppliers such as Samsung, SK Hynix, and Micron more leverage, while pushing hardware makers to look for alternatives. CXMT is one of those alternatives, but not the simplest one. Apple has spent many years trying to diversify parts of its supply chain away from China, especially for final assembly, while still depending heavily on Chinese manufacturing and suppliers. Even domestic brands from China are moving towards CXMT and YMTC instead of relying on Samsung, Micron, and SK Hynix. For Apple, though, it would invite more scrutiny than local Chinese companies. For now, this is more like a lobbying effort rather than a confirmed supply deal. There's no official statement from either of the parties. What is clearer, though, is the pressure behind such a request. AI demand has certainly made hardware a bottleneck, and companies are trying everything they can to bring things back to normal, even if that means making politically sensitive choices. Source: Financial Times
    • You've tried DuckDuckGo and Brave Search, now get serious with SearXNG

      By datacenter · Posted

      I did test it a month or so back, but ... the results I expect to be on the first page are not there.
    • 4TB TEAMGROUP MP44Q, 2TB T-Force G50, and 2TB WD My Passport SSDs drop to great prices

      By ryansurfer98 · Posted

      Neowin is saying these are good prices? Thats crazy. As others have said they are just ######. Time for big tech to bring down the prices for real not this fake crap.
    • Hands on with iFlyTek AINote 2 E-Ink tablet: insanely thin and smart

      By The Werewolf · Posted

      The iFlyTek AINote 2 is among the thinnest E-Ink tablets. It has an EMR stylus, a built-in fingerprint reader, and plenty of built-in AI features. You had me until "and plenty of built-in AI features." That and any company that still does the iProduct naming trope is an immediate pass. It suggests the company isn't very imaginative or creative and is trying to piggyback off another company's success. Extremely lame. Also kind of expensive. Better choices at lower prices out there.
    • 4TB TEAMGROUP MP44Q, 2TB T-Force G50, and 2TB WD My Passport SSDs drop to great prices

      By The Werewolf · Posted

      These are not "great" prices... just "less awful". Apparently "Those who forget the past are doomed to pay higher prices and think they've won."

  • Recent Achievements

    • Week One Done
      flexorcist earned a badge
      Week One Done
    • One Month Later
      Woland13 earned a badge
      One Month Later
    • Week One Done
      Woland13 earned a badge
      Week One Done
    • One Year In
      bernmeister earned a badge
      One Year In
    • Week One Done
      Scoobystu earned a badge
      Week One Done

  • Popular Contributors

    1. 1
      +primortal
      486
    2. 2
      +Edouard
      220
    3. 3
      PsYcHoKiLLa
      147
    4. 4
      Steven P.
      74
    5. 5
      FloatingFatMan
      70
    Show More

  • Tell a friend

    Love Neowin? Tell a friend!