Obama, McCain Campaign Computers Hacked


Recommended Posts

Source: Information Week

Obama, McCain Campaign Computers Hacked

Tech experts at the Obama headquarters initially believed that the computer systems had been invaded by a computer virus.

Computer systems used by the Obama and McCain campaigns were reportedly hacked over the summer by an unknown "foreign entity," according to an account of the attacks published Wednesday.

The sophisticated cyberattacks has prompted a federal investigation, Newsweek reported Wednesday. Attacks on both campaigns were similar in that investigators believed a foreign entity or organization sought to steal information on policy positions. Such information could be used in negotiations with the future administration.

The General Manager of IBM/ISS weighs in on paying hackers for bugs and the viability of an open source competitor. Positive Networks has a straightforward approach to two-factor authentication using your cell phone. Andrew Conry-Murray spoke with the president of RSA, Art Coviello, at EMC World 2008 about Data Loss Prevention.

Palo Alto Networks rethinks the firewall to accurately identify and control applications

Tech experts at the Obama headquarters initially believed that the computer systems had been invaded by a computer virus. The next day, however, they were told by the FBI and Secret Service that the problem was far more serious, the magazine reported.

"You have a problem way bigger than what you understand," an agent told Obama's team, according to Newsweek. "You have been compromised, and a serious amount of files have been loaded off your system."

Federal agents told Obama's aides that the McCain campaign had suffered a similar attack, which a top McCain official later confirmed to Newsweek.

Not in Ohio they are not, they are saved on a card and printed as well. The cards are then taken to the county board of elections for tabulation.

I'm in ohio and tahts the way it should be done...there needs to be a paper trail, if the power were lost and the backups failed it would be possible to loose millions of votes...paper FTW

I'm in ohio and tahts the way it should be done...there needs to be a paper trail, if the power were lost and the backups failed it would be possible to loose millions of votes...paper FTW

As long as you avoid the Florida fiasco with whatever permanent record you choose.

"Dimpled chad" (and the countless lawyers arguing over every ballot) FTL (N)

As long as you avoid the Florida fiasco with whatever permanent record you choose.

"Dimpled chad" (and the countless lawyers arguing over every ballot) FTL (N)

No chads in Ohio, all electronic with a printed backup. You can ask for a paper ballot if you want to. Some of the elder folk do that.

No chads in Ohio, all electronic with a printed backup. You can ask for a paper ballot if you want to. Some of the elder folk do that.

Even paper like that has problems.

I put my pen in a square, thinking if I should vote for Candidate A. I decide that I don't know that contest very well, and go on to a different section (for a state representative, for example).

Now, that square has a slight mark in it. If the race is close, lawyers will argue whether that constitutes an intent to vote or not. I do not like paper ballots for that reason.

I really like the electronic. Binary FTW (there is no 0.5 state). Printed confirmations can be done, and if the print is unclear (toner/ink issues), a reprint can be endlessly done off the same data to get a clear representation.

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • Those extra reboots are related to the UEFI Secure Boot certificate update thing.
    • Hands on with the ProtoArc EM25: Affordable ergonomic mouse that focuses on the right things by Taras Buria ProtoArc is known for making all sorts of office products with a big focus on ergonomics and comfort. Its latest product, the EM25, promises a comfortable-to-use, affordable, and customizable mouse. We took one for a spin; here are our impressions. The ProtoArc EM25 is a $49.99 mouse, but right now, during Prime Day 2026, you can get it for just $37.99. Right off the bat, you can see that the EM25 is inspired by Logitech's MX Master lineup and the legendary MX Master 3/3S. Its shape and proportions are very similar, so for a person with large hands (right-handed person, mind you), the EM25 is very comfortable to use. The mouse fills the palm, and the thumb rests on a small extension, giving your wrist a small tilt to reduce strain. The mouse is made of black plastic without any coating, eliminating long-term wear concerns. However, I can see the main buttons and other areas you touch the most getting polished over time. Despite its size and bulk, the mouse is not too heavy. It weighs about 100 grams, which is significantly less than the MX Master 3S and its successor. It is no lightweight gaming mouse by any means, but it is not excessively heavy like the MX Master 4. The EM25 has a built-in storage for its USB dongle. It is a cleverly made magnetic flap that you open by simply pressing on it. Next to the flap, you will find the on/off switch, the 1,000 Hz sensor, and a DPI button (up to 8,000 DPI). I find the DPI button location a bit odd, and I would prefer it somewhere below the main scroll wheel. Still, given that I never change DPI on my mice, I will let it pass. What is more important is that, unlike MX Master 3/3S/4, the device switch button is located below the left-click button, which allows you to switch devices without lifting and flipping the mouse. For a multi-device setup, this is a perfect solution: the button does not require too much effort to use, it does not get in your way, but it is also easily reachable with your thumb. The main scroll wheel has two modes: ratcheted and free-flow. You can only change between them with a bright orange button (I like this little touch of color), which is sprung and requires some effort to press. The wheel is dead-silent in free-flow mode, but ratched is quite loud and stiff, perhaps even too much to my liking. I can hardly call it deal-breaking, but it will certainly take some time to get used to. The side scroll wheel, it is notched, silent, and pleasant to use. Next to it, you can find a piece of glossed plastic with connection indicators: Dongle, Bluetooth 1, Bluetooth 2, and the low battery indicator. By the way, the built-in battery is rechargeable via a USB Type-C cable, which is included. It is sleeved and has an orange velcro strap to keep it tidy. After using the EM25 for a few weeks, I can say that its main buttons are my absolute favorite. They have very pronounced clicks, which feel great with just the right amount of force required to register a press. I would say they feel like something in between regular mouse clicks and silent ones. You can hear and feel the springy switch, but it is not sharp or loud to the point of annoying you. As for back/forward and device switch buttons, they are very clicky and quite noisy. Unfortunately, there are no extra buttons that you can map to specific things like in the MX Master lineup. Besides great primary clicks, another thing I like about the EM25 is its 1,000 Hz sensor. In the world, where Logitech still uses 125 Hz sensors in $100+ mice, seeing a much faster sensor in a mouse that costs three times less is very refreshing. Also, all the settings and customization you make are stored on-device, and you do not need to install any software. Just open the web-based app and change all that you need. Speaking of customization, you can remap what buttons do, adjust the DPI, and the sensor speed. Sadly, gestures are not supported, but you can still map pretty much anything to each button, including shortcuts, media buttons, and more. I also recommend using software like XMouseControl, as it will let you remap the side scroll wheel. At the end of the day, the ProtoArc EM25 is a great mouse. Clearly inspired by the MX Master lineup, it takes the best of it and complements it with a much more wallet-friendly price tag, significantly better sensor, on-device memory, a built-in storage for the dongle, and more (it fixes everything that I complained about the MX Master 4 recently). And for only $37.99 during Prime Day, the EM25 is an easy recommendation. Buy ProtoArc EM25 mouse - $37.99 | 24% off with Prime As an Amazon Associate, we earn from qualifying purchases.
    • Pretty nice tool, thanks
    • Indeed. But note that this has Wifi7, HDMI 2.1, BlueTooth 5.4, and 5G Ethernet, so even in the additional features list this bundle blows the Steam Machine away. And, with the money saved, one could improve this dramatically.
  • Recent Achievements

    • Dedicated
      HidekoYamamoto94 earned a badge
      Dedicated
    • One Month Later
      timbobit earned a badge
      One Month Later
    • One Month Later
      nates earned a badge
      One Month Later
    • Week One Done
      Almohandis earned a badge
      Week One Done
    • Rookie
      dorf went up a rank
      Rookie
  • Popular Contributors

    1. 1
      +primortal
      460
    2. 2
      +Edouard
      161
    3. 3
      PsYcHoKiLLa
      107
    4. 4
      Michael Scrip
      83
    5. 5
      Steven P.
      70
  • Tell a friend

    Love Neowin? Tell a friend!