Mouse use and muscular pain


Recommended Posts

My mother uses the computer pretty much all the time on her new job, and she experiences muscular pain in her right hand and arm, the one she uses with the mouse. She suffers from Fibromyalgia to begin with, so any repeated movement or prolonged effort is particularly likely to cause pain in her case. It's to the point where she may be forced to quit her job if she doesn't find a solution.

I've trying to give her advice to put her arm and wrist in the correct position while holding the mouse, based on my own experience and a few quick searches on the net, but I'm not an expert. Any good resources on mouse-related ergonomics appreciated.

Also I wonder if a trackball would be a solution, and if so, what models are best. Or if anything else exist that could replace the mouse as a pointing device.

Thanks for the help.

Link to comment
https://www.neowin.net/forum/topic/1057176-mouse-use-and-muscular-pain/
Share on other sites

I use a trackball and it's helped my wrist a lot it's a

Logitech marble mouse

and they can be had for aorund 30 bucks

Been using this same one for years now and it works great.

As an aside here...my mom, sis, and wife all have Fibro. Dunno what your mom takes to deal with it, but my mom and my sis are getting great results from Lyrica. They're sleeping better and having much less aches and pains. My wife hasn't made the switch because she's dreading weaning off her current meds before she could switch.

Here are two ergonomics at work guides, one from HP, one from Microsoft:

* http://www8.hp.com/us/en/hp-information/ergo/index.html

* http://www.microsoft.com/hardware/en-us/support/ergonomic-comfort

After that, some personal experience

* One of my colleague is currently using a vertical mouse from http://www.evoluent.com/. From his feedback, he has much less wrist pains.

VM4S-md.jpg

* an other colleague ended up with a prescription for new glasses. She had a bad correction on one of her eyes and she ended up with a bad posture at her computer desk as she unknowillingly tried to compensate. She tried various mouses, trackballs to no avail.

In both cases, they consulted a doctor specialized in ergonomics.

I use the computer around 12-15hrs / day (more some days :/) and at work I still use a regular mouse with a wirst pad...not the best but better than nothing. At home what made the biggest change for me was when I started using an Apple Magic Trackpad, since my wrist doesn't rub on the desk as much anymore it's MUCH better!

I've never been a fan of trackballs because I could never get precise enough movement. In your Mom's case it might be a viable option though. A touchpad might make a lot of sense too. Logitech makes a real nice one, she can move the pointer with her fingers and click with simple taps.

I use the PC literally all day, and I used to get some pretty wicked back, wrist and hand pain, but it went away eventually. I just had to improve my posture, but I know where you're coming from, my mother suffers from Fibromyalgia too, so has my sister, and my grandmother, and all my Aunts, and most of my Uncles, so far I haven't developed it, whatever it is, I'm either immune to it, or never got it. -knocks on wood-

Would also consider making sure the desktop also more ergonomic. Consider a desk with low height and ensure the desk allows the chair to situation properly underneath to allow resting of the elbow. This will greatly reduce the amount of muscle tone required to maintain the mouse holding position.

I once had a case of Carpal Tunnel. I had to do some exercises for awhile and they helped. I do have to work on a machine 10-12hrs a day so I have to be careful how I position my wrists. A track ball or track pad might be the best bet for her.

I have used them but still prefer my mini mouse from Logitech. What about something with a touch screen? Could that help her?

iWilcon is right the right posture and positioning of the devices will also help a lot. I should have mentioned my problem occurred over 10 years ago.

The simple option would be to get a mouse pad with wrist rests:

http://www.staples.com/Staples-Mouse-Pad-with-Gel-Wrist-Rest-Blue-Crystal/product_811891

And also get a mouse with adjustable DPI, so she could crank it up and then won't have to move her wrist as much.

Or she could buy one of those Bowling braces:

http://www.bowlersdream.com/stormgadget.html

Her coworkers will be forced to give her mass respect since she'll look like a robot. :rofl:

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • This AMD RX 9070 16GB GPU that performs close to Nvidia 5070 is under $600 by Sayan Sen With the memory shortage that's prevalent nowadays, discounts are super-hard to get. As such we post good deals whenever they pop up. Recently, we covered a few great discounts on SSDs wherein you can get a 4TB TeamGroup NVMe PCIe Gen4 drive for just $400 thanks to a special coupon. If you want a faster product but don't need all that capacity, you can also opt for Samsung's 990 PRO 2TB that is on sale for its lowest price in over three months. Let's say though that you are on the hunt for a 1440p gaming card. In that case AMD's RX 9070 non-XT can help, and with its 16GB VRAM, you can also run AI models locally without worrying about bottlenecking (check out our recent 9070 GRE reviews for gaming and productivity to get an idea). The PowerColor Reaper variant of the RX 9070 is currently on sale for just $580 which is a very good price in the current state of affairs (purchase link under the specs table down below). The Reaper cooler on this 9070 uses a triple‑fan design with ring‑blade fans, paired with premium dual ball bearings to extend lifespan and reduce friction. "Intelligent" fan control allows the fans to remain idle at lower temperatures, only spinning up when the GPU is under load. A nickel‑plated copper base makes direct contact with both the GPU and memory modules, helping to spread heat evenly. PowerColor also applies Honeywell PTM7950 phase‑change thermal interface material (TIM), which fills microscopic gaps between the die and heatsink for more efficient thermal transfer. The fan shroud is shorter in height as the firm has made it such that it can be used in certain SFF (small form factor) cases. The technical specifications of the Reaper RX 9070 are given in the table below: Specification Value Stream Processors 3584 Units Video Memory 16GB GDDR6 Memory Speed 20.0 Gbps Memory Interface 256-bit Engine Clock Game Clock: up to 2070 MHz Boost Clock: up to 2520 MHz Bus Standard PCI Express 5.0 x16 Display Connectors 1 x HDMI 2.1b, 3 x DisplayPort 2.1a Maximum Resolution DisplayPort: 7680 × 4320 HDMI: 7680 × 4320 Board Dimensions 289mm × 111mm × 41mm 304mm × 127mm × 42mm (with bracket) Slot 2 Minimum System Power Requirement 600W Power Connectors Two 8-pin PCI Express Get the PowerColor Reaper RX 9070 at the links below (you get only a 90-day warranty on Woot): PowerColor Reaper Radeon RX 9070 16GB Graphics Card (RX9070 16G-A): $579.99 (Sold and Shipped by Amazon US) (Was: $700) PowerColor Reaper Radeon RX 9070 16GB Graphics Card (RX9070 16G-A): $559.99 (Sold and Shipped by Woot US) Good to know This Amazon deal is U.S. specific, and not available in other regions unless specified. We only use first-party seller links (at the time of article publishing); ensure that you purchase from a first-party seller link only. Check out Today's Deals on Amazon | or our recent tech deals. Become a Prime member (for Students or SNAP) via Neowin Get Prime Access - Prime for half price (for qualifying Medicaid, EBT, SNAP) Subscribe to Prime Video, Audible Plus, Music Unlimited or Kindle Unlimited via Neowin As an Amazon Associate, we earn from qualifying purchases.
    • Are they marketed as an entry into astronomy or astrophotography? I do astrophotography. With big rigs, lots of computers, cables and headaches. I love it. And by learning this ridiculously complex hobby, I’ve learned about the objects I’m shooting. Astronomy followed from photography.
    • Microsoft confirms Recycle Bin bug across all versions of Windows by Usama Jawad A couple of days ago, we reported that the latest Patch Tuesday update has seemingly resulted in a lot of issues for many users, including OneDrive and Dropbox access problems, BitLocker recovery lockouts, and BSODs. Although Microsoft is yet to acknowledge these bugs, it has confirmed another, relatively smaller issue across all supported versions of Windows. In an update on its Windows Release Health Dashboard, Microsoft has confirmed that after installing June's Patch Tuesday update (KB5094126), you'll experience unexpected behavior when leveraging Recycle Bin. Basically, when you attempt to delete an item from the Recycle Bin, the confirm dialog will show you the internal file name of that content rather than the actual name. For example, the file may be named abc.png, but the confirm dialog will ask if you're sure that you want to permanently delete $Rxxxxx.png from the Recycle Bin. This is pretty much it for the scope of the bug itself; it just displays the wrong name in the confirm dialog. The correct name will be shown in the list view of the Recycle Bin and if you restore the file, it will return with the correct name as well. This issue affects pretty much all supported versions of Windows client and server, including: Client: Windows 11, version 26H1; Windows 11, version 25H2; Windows 11, version 24H2; Windows 11, version 23H2; Windows 10, version 22H2; Windows 10 Enterprise LTSC 2021; Windows 10 Enterprise LTSC 2019; Windows 10 Enterprise LTSB 2016 Server: Windows Server 2025; Windows Server 2022; Windows Server 2019; Windows Server 2016; Windows Server 2012 R2; Windows Server 2012 As things currently stand, Microsoft is working on a concrete solution that will be released in a "future" Windows update. It remains to be seen if the firm will wait till the next Patch Tuesday or roll out an out-of-band (OOB) fix. The good news is that commercial customers can deploy a workaround right now, but they will have to reach out to Microsoft Support for Business for additional details.
    • They said by this time everyone will have flying cars. WELL...
    • A study by physicist Henry Tye of Cornell University suggests that the universe may not expand forever. Instead, it could eventually stop expanding, begin contracting and end in a "Big Crunch" roughly 20 billion years from now. Maybe not as we now know that time can flow backwards.
  • Recent Achievements

    • Week One Done
      Jordan Smith earned a badge
      Week One Done
    • Reacting Well
      BizSAR earned a badge
      Reacting Well
    • First Post
      AndreaB earned a badge
      First Post
    • Week One Done
      Huge Trailer earned a badge
      Week One Done
    • Week One Done
      Classifyskilleducation earned a badge
      Week One Done
  • Popular Contributors

    1. 1
      +primortal
      578
    2. 2
      +Edouard
      184
    3. 3
      PsYcHoKiLLa
      75
    4. 4
      Michael Scrip
      72
    5. 5
      neufuse
      64
  • Tell a friend

    Love Neowin? Tell a friend!