Delay in Remote Desktop Connection. What are possible solutions?


Recommended Posts

I am experiencing delays and reconnecting issues when connecting to RDP. Both wired and wireless.

I have purchased a new router - Linksys EA3500 - and still these issues occur.

Ping tests stated around 18ms for my connection.

My internet speeds/subscription are 120 MB down, 10 MB up. I have tested with different "Experience / Performance" settings within RDP, from low-speed broadband to high-speed broadband; all without success.

I have KIS2013 installed with default settings on both computers (wired and wireless).

What can be the issues for these delays/secs of 'hickups' during the RDP-connection?

RDP connections to where? Some box on the internet, or between boxes on your own network - wired to wireless, wireless to wireless, wired to wired?

Also what do you consider delay, 2 seconds, 5 seconds, 10, 20, 3 minutes?

RDP to some box (server) on the internet - our server 80 km away.

The server is wired to its backbone/Internet, I make a RDP-connection via my computer (wired) or notebook (wireless) from home (or elsewhere) - I use its name/alias and not the IP.

The delay is a couple of seconds (mostly 2-5 sec); screen 'freezes', reconnecting popups appears, connection is back again and I can start working again...

And this once every 2-5 minutes.

EDIT:

adjusted delay time to real circumstances

well there could always be a slight delay in resolving to its FQDN, I think that is what you meant by name/alias because those are not resolvable on the internet but a fully qualified domain name is ;) something.something.tld

so you its not really a delay in connection, but a loss of connection and reconnect

"this once every 2-5 minutes."

Are you connecting via a VPN to this server, or just the normal RDP 3389 just over the internet? Is there any firewall on the other end limiting connections to this port to only where your coming from?

You put 3389 open on the public internet and its going to get hit quite often with people attempting to log in.

If your saying it happens every few minutes I would look at logs on server side for any hints, and also would sniff the traffic from your connection. This will show you if your getting a lot of retransmission on lost packets, etc.

lagging could be upstream not fast enough to handle request, could be dns not fast enough to handle name resolution...you mention your upstream, is your upstream the upstream at home or your upstream at the office. The upstream at the office needs to be ~1Mb/s for optimal response...your down stream at home needs to be at least that. Also the dns plays quite a bit into speed, try connecting to the ip to negate dns being an issue. if it is fast connecting to the outside ip, then the issue is dns related.

it's kinda strange... when I use my cell phone with tethering (wayyy slower connection, everything is ok) on the same notebook, I have a good connection and no delay/lag.

It seems that either my modem or router is the "bad kid in town".

I just got a new router today - default settings - so that should not be the issue.

I might just check a direct cable connection from my modem to my computer (thus cancelling out the router) and see what happens...

I'll come back to this latter thing.

@ +Chris13NT, how can I prevent this? Or is this ISP-related?

Just tested it "quick and dirty" and the delay/lag is not present when connecting directly to the modem.

When I put my router in between the lag is there yet again.

There is a power/surge adapter to prevent over-voltage, but this hasn't been an issue ever since.

Might it be cable related? And that one of the UTP-cables has been damaged/is broken?

Replacing might help, but that I need to get myself some new cables....

By the way, the current cable-setup is:

ISP-entrance in my home - cable to modem, provided bij ISP - modem - cable to surge-adapter - cable to router, from there the standard 4 GBit ports of this EA3500 to computer and other periphicals + router wireless to notebook and other periphicals.

What is your dns configuration when connection directly to the modem?

start, run, cmd

ipconfig/all

What is your dns configuration when connected to the router?

start, run, cmp

ipconfig/all

change the dns on your adapter to the dns that you are getting when you are on the modem. does the same problem exist?

dns could be the problem on initial delay, or just failure to resolve - but once the connection is established and having freezes every few minutes does not seem like a dns related problem to me.

What kind of router is it? Some routers have trouble with connections over 50mbit, I had a Linksys E3000 and it couldn't cope with my 85mbit FiOS line, it would crap out every time I pegged the download.

It could be cable related but I doubt it.

I have a brand new Linksys EA3500. It should get "Transfer rates up to 300 + 450 Mbps".

The DNS I get when connect to the router is 1 IP: 192.168.1.1

When directly connected to the modem DNS server is 2 IP's: 213.48. .... and 62.179. ...

yeah those are from your ISP when connected to modem, and when connected to router your using it as your dns forwarder. This is a common setup, your router would then forward dns to those handed to your router via your ISP 213.48 and 62.179

But again if your having the issues once your connected, it seems highly unlikely that it would be dns related.

  On 26/09/2012 at 16:23, BudMan said:

yeah those are from your ISP when connected to modem, and when connected to router your using it as your dns forwarder. This is a common setup, your router would then forward dns to those handed to your router via your ISP 213.48 and 62.179

But again if your having the issues once your connected, it seems highly unlikely that it would be dns related.

Thx. So what can it be?

unlikely sure, test it, verify it, make sure. be sure, not be somewhat sure....perhaps the router is being retarded when forwarding, it is a link in the chain....remove the link.

I thought it was initial connection....if it is not initial connection, then it is not dns related. something is happening with the traffic when it goes from router to modem.

Can you to a trace route to the IP of the RDC server? This might give a clue if you have a hop with unusually high ping.

do tracert <ip (or dns name)> in cmd

The fact that the lag only happens when the router is in the link is making me almost positive it's the router botching things.

  On 26/09/2012 at 16:29, Chris123NT said:

Can you to a trace route to the IP of the RDC server? This might give a clue if you have a hop with unusually high ping.

do tracert <ip (or dns name)> in cmd

In which setup and from where?

From my computer, connected via router, to the RDC server?

Or from the RDC server to my computer? (and also here via router or directly connected to modem?)

  On 26/09/2012 at 17:01, hjf288 said:

Off topic but in reply to Chris, my e2000 handles my 120mbit line with ease and it has a slower CPU than your e3000..

So something is up there..

It could have just been going bad, or it could have been DD-WRT's fault.

  On 26/09/2012 at 16:29, Chris123NT said:

Can you to a trace route to the IP of the RDC server? This might give a clue if you have a hop with unusually high ping.

do tracert <ip (or dns name)> in cmd

The fact that the lag only happens when the router is in the link is making me almost positive it's the router botching things.

What kind of info do you need from this trace?

From which hop# there is a time out? or else?

There has been some less delays (but still annoying) with the new FW... although I had to wrestle myself through the Cisco Cloud Connect.

Still some delays.

Question remains....

EDIT:

I guess I was over-enthusiastic... delays still remain as strong as before :(

This topic is now closed to further replies.
  • Posts

    • Thank you for mentioning Windows Vista in the title of a news article!
    • Let's be real. Part of the motivation of the UI change is to increase CPU/RAM usage, which slows down older devices and makes battery life worse, therefore tempting people into upgrading to the latest devices. We've been through this enough times to know that the iOS updates never improve performance. Personally I value battery life over eye candy.
    • Apple announces watchOS 26 with a 'Workout Buddy,' new gestures, and more by Taras Buria Apple has unveiled watchOS 26, another operating system under the new naming scheme (all of Apple's systems now feature the same version number to match the current/upcoming year) and "Liquid Glass" Redesign. The latter is a dynamic interface that features translucency, reflections, parallax, and other visual candy. Aside from the redesign and a new number, Apple is introducing new health and workout features. Workout Buddy is a feature that offers personalized, spoken motivation during workouts. It analyzes your pace, heart rate, and fitness history, delivering real-time encouragement and more engagement, like having someone else work out next to you, providing useful information and cheering you up. Here is an example of what you will hear with Workout Buddy: The Workout app also has a more streamlined interface with four buttons in the corners for quick access to favorite features during workouts. You can set up music and podcasts right in the Workout app so that your favorite content starts playing when you begin your workout. In addition, Apple announced a new one-handed wrist flick gesture that allows users to dismiss notifications with a quick flick, which is convenient when you cannot use your both hands to interact with your watch. Other changes include the Notes app, which now lets you access notes on the Apple Watch, Hold Assist and Call Screening in the Phone app, Live Listen with real-time Live Captions of what the iPhone hears, improvements to the Photos face, and more. watchOS 26 will be available later this year, and the first developer betas are expected soon.
    • tvOS 26 arrives with karaoke mode, updated profile switcher, Liquid Glass, and more by Aditya Tiwari WWDC 2025 is now live, and Apple has finally renamed all of its operating systems to version 26. This year, we have tvOS 26 for the Apple TV, featuring the freshly-baked Liquid Glass software design. Apple explained that Liquid Glass brings a fresh and vibrant look to Apple TV, "delivering a fresh and expressive design that beautifully reflects and refracts its surroundings using real-time rendering." Content is the primary focus of the experience when you fast-forward, rewind, or change a setting from the Control Center. The redesigned Apple TV app now features new poster art for movies and TV shows, with a touch of Liquid Glass. Users can now choose whether to display the profile switcher UI when their Apple TV wakes up, allowing them to quickly access their Watchlist and recommendations in the TV app, as well as playlists in Apple Music. Speaking of Apple Music, your iPhone can now double as a handheld microphone for Apple TV. The new karaoke mode allows multiple users to queue up songs from their iPhones and sing along, with support for lyrics translation and pronunciation. Apple has updated the FaceTime experience to make it consistent with iPhone. Contact Posters introduced with iOS 17 are now available on Apple TV, which display a contact's customized photo and name when starting a FaceTime call. Live Captions support on FaceTime now includes French, German, Japanese, Korean, Mandarin, and Spanish. FaceTime on Apple TV has been updated to display phone and voice call notifications for active profiles. Users can use their connected HomePod speakers or iPhone to answer them. Apart from that, tvOS 26 also brings new Aerial screen savers, featuring India's Goa and Kerala. Users can also personalize their screensaver experience and designate any AirPlay-enabled speaker as the permanent speaker for Apple TV. tvOS 26 has also made the sign-in experience a bit easier for users. Developers can link app logins to an Apple account, making it quicker for users to access their apps and content when setting up a new device. The new tvOS update is now available for testing through the Apple Developer Program, supported on Apple TV 4K (2nd generation and later). Meanwhile, the updated sing-along feature is available on iPhone 11 and later with Apple TV 4K (3rd generation).
  • Popular Contributors

    1. 1
      +primortal
      479
    2. 2
      +FloatingFatMan
      276
    3. 3
      ATLien_0
      257
    4. 4
      Edouard
      205
    5. 5
      snowy owl
      200
  • Tell a friend

    Love Neowin? Tell a friend!