win8 doesnt install tried everything


Recommended Posts

Just in case someone comes along with a similar issue, sees this and attempt it....

OS installations don't work this way. At least not as simple as that. When you install Windows, the installation process loads drivers and files for your specific hardware. It was a good suggestion, just not one that actually works.

Actually that will work in a lot of cases with Vista, 7 & 8. Just wait to activate until after you've swapped.

Actually that will work in a lot of cases with Vista, 7 & 8. Just wait to activate until after you've swapped.

So he could essentially install on an Intel based motherboard with an Intel CPU and then put that drive in an AMD based system and it would boot up without issue? I'm not being sarcastic either. I'm being serious. As far as I'm aware, that's not feasible.

So he could essentially install on an Intel based motherboard with an Intel CPU and then put that drive in an AMD based system and it would boot up without issue? I'm not being sarcastic either. I'm being serious. As far as I'm aware, that's not feasible.

no, as far as I'm aware that will work AS LONG as you shutdown before the restart timer reaches 0

I'm pretty sure it doesn't install any drivers until after that initial restart (though i could be completely wrong and talking out my ass)

So he could essentially install on an Intel based motherboard with an Intel CPU and then put that drive in an AMD based system and it would boot up without issue? I'm not being sarcastic either. I'm being serious. As far as I'm aware, that's not feasible.

It's feasible. :)

Moving the drive shouldn't be a problem due to how Windows works now in comparison to pre-Vista era installs. It's now image based and you can just deploy it to the drive, and then run sysprep...pull it out of machine A, and put it into machine B.

Running sysprep clears the 'unique' hardware info about the system...and then installs the correct drivers for the hardware once it's in the new machine. The HAL is nowhere near the headache that it used to be.

http://msdn.microsoft.com/en-us/library/windows/hardware/ff560129(v=vs.85).aspx a simple google search showed up with this

Cause

This bug check is issued if paged memory (or invalid memory) is accessed when the IRQL is too high.

The error that generates this bug check usually occurs after the installation of a faulty device driver, system service, or BIOS.

If you encounter bug check 0xA while upgrading to a later version of Windows, this error might be caused by a device driver, a system service, a virus scanner, or a backup tool that is incompatible with the new version.

Resolution

If a kernel debugger is available, obtain a stack trace.

To resolve an error caused by a faulty device driver, system service, or BIOS


  • Restart your computer.

  • Press F8 at the character-based menu that displays the operating system choices.

  • Select the Last Known Good Configuration option from the Windows Advanced Options menu. This option is most effective when only one driver or service is added at a time.

To resolve an error caused by an incompatible device driver, system service, virus scanner, or backup tool


  • Check the System Log in Event Viewer for error messages that might identify the device or driver that caused the error.

  • Try disabling memory caching of the BIOS.

  • Run the hardware diagnostics supplied by the system manufacturer, especially the memory scanner. For details on these procedures, see the owner's manual for your computer.

  • Make sure the latest Service Pack is installed.

  • If your system has small computer system interface (SCSI) adapters, contact the adapter manufacturer to obtain updated Windows drivers. Try disabling sync negotiation in the SCSI BIOS, checking the cabling and the SCSI IDs of each device, and confirming proper termination.

  • For integrated device electronics (IDE) devices, define the onboard IDE port as Primary only. Also, check each IDE device for the proper master/subordinate/stand-alone setting. Try removing all IDE devices except for hard disks.

If the message appears during an installation of Windows, make sure that the computer and all installed peripherals are compatible with the version of Windows being installed. For example, you can get information about compatibility with Windows 7 at the Windows 7 Compatibility Center.

It's feasible. :)

Moving the drive shouldn't be a problem due to how Windows works now in comparison to pre-Vista era installs. It's now image based and you can just deploy it to the drive, and then run sysprep...pull it out of machine A, and put it into machine B.

Running sysprep clears the 'unique' hardware info about the system...and then installs the correct drivers for the hardware once it's in the new machine. The HAL is nowhere near the headache that it used to be.

Dear god the time I could have saved! I stand corrected LOL

It's true, you really do learn something new every day ;)

  • Like 2
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • Samsung messages is still alive and well. They reversed that and decided to our more effort into it.
    • I think every American should have a course in a 'dry sense of humour' at school; and perhaps 'using sarcasm in jest' oh, and also 'the use or irony in humour'.
    • What they really need to do is automatically spell "loses" and "lose" correctly since nobody seems to know how to anymore. Then they blame spellcheck/autocomplete and don't realize autocomplete is just filling in the word for them automatically so it was misspelled in the first place.
    • If someone chooses to continue using SB and therefore goes through the manual intervention in the thread, afterwards the BSOD problem is gone. Whether they then re-enable the task doesn't matter, they're done, though on such machines it might pay to keep it disabled in case the next update (if there is a next) causes the same problem. OTOH, if someone disables SB in the BIOS, the problem is also gone. Incidentally, I noticed that this task exists even on machines that don't support SB. It's just installed across the board...and runs. Doing what on such machines is a little hazy.
    • qBittorrent 5.2.2 by Razvan Serea The qBittorrent project aims to provide a Free Software alternative to µtorrent. qBittorrent is an advanced and multi-platform BitTorrent client with a nice user interface as well as a Web UI for remote control and an integrated search engine. qBittorrent aims to meet the needs of most users while using as little CPU and memory as possible. qBittorrent is a truly Open Source project, and as such, anyone can and should contribute to it. qBittorrent features: Polished µTorrent-like User Interface Well-integrated and extensible Search Engine Simultaneous search in most famous BitTorrent search sites Per-category-specific search requests (e.g. Books, Music, Movies) All Bittorrent extensions DHT, Peer Exchange, Full encryption, Magnet/BitComet URIs, ... Remote control through a Web user interface Nearly identical to the regular UI, all in Ajax Advanced control over trackers, peers and torrents Torrents queueing and prioritizing Torrent content selection and prioritizing UPnP / NAT-PMP port forwarding support Available in ~25 languages (Unicode support) Torrent creation tool Advanced RSS support with download filters (inc. regex) Bandwidth scheduler IP Filtering (eMule and PeerGuardian compatible) IPv6 compliant Available on most platforms: Linux, Mac OS X, Windows, OS/2, FreeBSD qBittorrent 5.2.2 changelog: FEATURE: Use D-Bus to show file in file managers (Chocobo1) #24340 BUGFIX: Fix friendlyUnitCompact precision calculation (vafada) #24323 BUGFIX: Remove all top-level folders (glassez) #24333 BUGFIX: Use proper API for checking exit status (Chocobo1) #24349 BUGFIX: Delete stale lockfile when hostname mismatch (TurboTheTurtle, glassez) #24363 BUGFIX: Fix wrong removal procedure of watched folder paths (Chocobo1) #24413 BUGFIX: Don't reannounce before interface changes are applied (glassez) #24447 BUGFIX: Use Latin script for Bosnian locale name (Andy Ye) #24342 WEBUI: Fix performance of global checkbox toggling (tehcneko) #24316 WEBUI: Fix Safari transfer list header misalignment (Piccirello) #24377 WEBUI: Fix error when submitting magnet before metadata loads (Piccirello) #24378 WEBUI: Use correct row id when updating Rss Downloader feed selection (Chocobo1) #24402 WEBUI: Use SameSite=Lax for session cookie to fix cross-site login (Piccirello) #24422 WEBUI: Bring back properties panel expand/collapse button (vafada) #24430 WEBAPI: Only use X-Forwarded-Host header when reverse proxy support is enabled (Chocobo1) #24457 RSSS: Fix "RSS Smart Episode Filter" RegEx (nathanon-akk, glassez) #24398 RSS: Fix previously matched episode format (glassez) #24452 WINDOWS: Fix Python fallback search path (TurboTheTurtle) #24325 WINDOWS: NSIS: Allow to install x64 binary on ARM64 (Chocobo1) #24358 Download: qBittorrent 5.2.2 | 41.1 MB (Open Source) Download: qBittorrent 64-bit installer (qt6) | 43.6 MB Links: qBittorrent Home page | Screenshot Get alerted to all of our Software updates on Twitter at @NeowinSoftware
  • Recent Achievements

    • One Year In
      Console General earned a badge
      One Year In
    • One Year In
      Twozo Technologies earned a badge
      One Year In
    • One Month Later
      Twozo Technologies earned a badge
      One Month Later
    • Week One Done
      Twozo Technologies earned a badge
      Week One Done
    • Veteran
      branfont went up a rank
      Veteran
  • Popular Contributors

    1. 1
      +primortal
      493
    2. 2
      +Edouard
      182
    3. 3
      PsYcHoKiLLa
      125
    4. 4
      Steven P.
      85
    5. 5
      neufuse
      71
  • Tell a friend

    Love Neowin? Tell a friend!