Recommended Posts

I just spent over a $100 in computer parts (an Intel DG41TY motherboard -- manual: http://downloadmirror.intel.com/17101/eng/DG41TY_ProductGuide01_English.pdf , a 450W power supply, 2 x 1GB of DDR2 RAM chips and a P$ CPU with 3GHz speed for socket 775).

I can't get the damn thing to post...I've connected both the main power supply connecter which covers all the pins and the 4-pin square connector.

I've also connected a 3-pin CPU cooling fan to the 4-pin connector on the motherboard ...(it looked ok to do because you can only put it on one way).

Looking at the documentation provided with the PDF listed above there were only two locations of the front panel for power which I've tried to test by tripping with a laptop screw driver with no success. I see one green solid light on the MB when I turn on the power for the power supply and that's it.

Please advise!

Thanks in advanced for any helpful response.

Link to comment
https://www.neowin.net/forum/topic/1125060-motherboard-not-posting/
Share on other sites

The light you see on the board, verifies that you have power connected.

Do you get any fans spinning, beeps, or anything?

Try reseating the CPU and RAM. If no dice, try resetting the BIOS by removing the watch battery for a few minutes, and reinsert.

What are your full specs?

Perhaps he shorted the wrong pins then. If the mobo is indicating it's getting power, then there's not much of a reason why shorting the correct pins together wouldn't power it on.

The only other thing it could be is cracked solder connections or something flawed on the pcb traces. Both of which are pretty difficult to fix.

Since these are really old components, I would have to assume they are used. Scammed by the seller perhaps?

could be a bum mobo. are you sure you hooked up all of the power?

It is very important to have "G" and "I" plugged in on the pic on page 11..."E" and "O" should also be plugged into a fan.

http://downloadmirror.intel.com/17101/eng/DG41TY_ProductGuide01_English.pdf

Also check "U" pins 1 and 2 should be jumped.

Are you absolutely sure your PSU works fine?

I only ask as my old EZcool psu blew up last year, and after a day of troubleshooting, it turned out that even though the green light was on, on my mobo, the psu was at fault

(an embarrassingly easy oversight, just a possibility)

I've found the pins that give it power but after reseating the memory and cpu and then the BIOS battery after about ten seconds...after

I short the pins the power supply fan turns and the cpu fan turns but the monitor I know works that's connected to the mb doesn't show a display and no POST beep.

Like I said connector I is a 4-pin...what I have connected is a 3-pin yet it powers the cpu fan to turn.

I'm getting an RMA# for this motherboard...in the mean time I need to get an alternative

system going for my customer...and need to know if this memory: PC2-3200/4200 DDR2 SDRAM DIMMs

is interchangable with a DDR2 RAM 800MHz PC2-6400 240-PIN DIM for a GX520 Optiplex

Desktop computer...please advise.

Buy a prebuilt. Much less headache. And you don't warranty it like you are now. How much time have you spent on this convert that to money by how much you charge and figure out how much money you lost so far.

Now you have to take it apart put it back together and you still need to load the os, drivers, and apps. I would say right now you are in the hole at least 100 and you haven't even started.

150 can get an old prebuilt. 300 gets you brand new.

I had this before and it was because I hadn't earthed the motherboard correctly (didnt put in all the screws)

so be sure its earthed/ remove it and reseat it.

I would say right now you are in the hole at least 100 and you haven't even started.

150 can get an old prebuilt. 300 gets you brand new.

Plus the $100 he already spent on parts. so thats $200 already :laugh:

(I'd still build it myself though)

That's why I'm going to RMA this back to them...and if don't respond they'll have to respond

to BBB...it didn't come with manual ...so it's possible I tried to start it with the wrong two pins

at first. Can somebody please answer question regard the memory???!

yes and you client is out of a computer for how long? Home built computers are good for yourself and maybe family members, anything outside of that buy a prebuilt dell, hp, lenovo, cyberpower, emachines, etc.... I will never ever build another computer for anyone outside of that esp if they live more than 10 minutes away....I am not dealing with that headache, they can call the manufacturer or I can call the manufacturer and have one of their techs come out to do whatever. I charge $150 an hour for my time, 2 hours and they spent what they would on a new computer prebuilt, all I need to do is some clean up which usually doesn't take more than 30 min.

As far as the memory goes, I believe that dell will only accept pc2 5300 and pc2 6400 and is maxed at 4GB.

http://www.crucial.c...20GX520&Cat=RAM

This topic is now closed to further replies.
  • Posts

    • I have a couple to mention, and they still run great on Windows 11 Adobe Lightroom Version 2 Alcohol 120% DVDDecrypter ISO Buster Pro version 1.9.1 (Still supports HD-DVD too) Nero Burning Rom 8 (Only the burning software, no backup, media converter, etc)   PowerDVD 12 Ultra SPTD (SCSI Pass through Direct Driver) UltraISO Windows Media Encoder 9 WinImage You can tell I still sport an optical drive    
    • Linux 7.1 arrives with an NTFS overhaul and major hardware performance boosts by Paul Hill The founder of the Linux kernel has just announced the availability of Linux 7.1. This is a stable version of the kernel that will now be tested by various Linux distributions before it is shipped to users through update managers. Some users, like those on Debian, for example, might not get it for a long time, if at all, while Fedora users can expect it in the near future. With Linux 7.1 out on time, the merge window for Linux 7.2 is now open, giving contributors the opportunity to send in major new features that have been waiting for the last two months. Torvalds warned that he is currently travelling and will be in another timezone, so timing for the merge window may be irregular due to timezone differences and limited internet access. Torvalds said that he has already fetched early pull requests to allow him to do some offline work, but the travel could still cause disruption. Right now, he is not planning to extend the release, but did consider it. He said he might later regret not extending, though. In terms of this last week of development for Linux 7.1, Torvalds said there were no major or alarming changes. This week consisted mostly of smaller driver updates to GPU, networking, and sound, networking fixes, trace tooling fixes, and misc minor fixes. The shortlog this week lists fixes for driver bugs, memory leaks, I/O and USB fixes, networking and RDMA fixes, DRM/graphics fixes, and tooling and verification improvements. Specific fixes include USB series heap-overflow and buffer overflow fixes, and multiple use-after-free, memory-leak, and refcount corrections across subsystems such as i2c, zram, gpio, and net. There are fixes for graphics drivers, including amdgpu, i915, and virtio, as well as hypervisor and virtualization tweaks affecting mshv, vmbus, and hyperv. According to Phoronix, anyone running Linux 7.1 should look out for the new NTFS driver, Intel FRED for improved performance on Panther Lake and future CPUs, faster graphics with Intel Arc Battlemage, and improvements for older AMD Radeon GPUs. If you are running Linux on your computer and everything is fine, then you don’t need to worry about updating to Linux 7.1 as a priority; just wait for it to be pushed to you. If you have tried Linux on hardware but it didn’t work properly, trying again with a distro that uses Linux 7.1 could cause Linux to work on your machine, thanks to the new hardware support.
    • you can also do this with this tool: PowerSettingsExplorer made by mbk1969 at 3dguru forum.. I found it by accident researching on modern standby and annoying quirks of it in 2022
    • AB Download Manager 1.9.1 by Razvan Serea AB Download Manager is an open-source, feature-rich download manager designed to accelerate downloads, organize files efficiently, and provide seamless control over downloads. With support for multiple connections, resume capability, and an intuitive interface, it enhances the downloading experience for users seeking speed and reliability. The software integrates with various browsers, enabling quick link grabbing and batch downloading. It supports HTTP, HTTPS, and FTP protocols, ensuring broad compatibility with different file sources. Users can schedule downloads, set speed limits, and categorize files automatically for better organization. AB Download Manager is lightweight yet powerful, making it a great alternative to proprietary download managers. Its open-source nature allows developers to contribute, customize, and improve the software as needed. Whether you're downloading large files, managing multiple downloads at once, or seeking an ad-free experience, this tool offers a practical and efficient solution. Key features of AB Download Manager: Multi-Connection Support – Accelerates downloads by splitting files into multiple segments. Resume Capability – Allows paused or interrupted downloads to be resumed without starting over. Batch Downloading – Supports downloading multiple files at once for improved efficiency. Browser Integration – Captures download links directly from browsers for seamless operation. HTTP, HTTPS, and FTP Support – Ensures compatibility with a wide range of file sources. Download Scheduling – Enables users to automate downloads at specific times. Speed Limiting – Lets users control bandwidth usage for optimized performance. File Categorization – Automatically organizes downloaded files into designated folders. User-Friendly Interface – Simple and intuitive design for easy navigation. Cross-Platform Compatibility – Works on multiple operating systems. Ad-Free Experience – No intrusive ads or tracking for a clean user experience. AB Download Manager 1.9.1 changelog: Added An option to customize notification sounds (#1259) Fixed Ongoing notification was laggy on Samsung One UI devices (#1269) Improved Updated Translations Minor UI/UX improvements Download: AB Download Manager 1.9.1 | Portable | ~80.0 MB (Open Source) Download: ARM64 | Portable ARM64 | Android Links: AB Download Manager Website | Github Page | Screenshot Get alerted to all of our Software updates on Twitter at @NeowinSoftware
    • watching him because of the Mr Klinton cat
  • Recent Achievements

    • Week One Done
      rolfus earned a badge
      Week One Done
    • One Month Later
      Leroy Jethro Gibbs earned a badge
      One Month Later
    • Conversation Starter
      flexorcist earned a badge
      Conversation Starter
    • One Month Later
      AndreaB earned a badge
      One Month Later
    • One Month Later
      agatameier earned a badge
      One Month Later
  • Popular Contributors

    1. 1
      +primortal
      507
    2. 2
      +Edouard
      196
    3. 3
      PsYcHoKiLLa
      140
    4. 4
      ATLien_0
      90
    5. 5
      Steven P.
      81
  • Tell a friend

    Love Neowin? Tell a friend!