How much tire pressure is too much?


Recommended Posts

I see a lot of conflicting advice on tire pressure online. Lots of people say just put the recommended pressure, lots of people also say put a bit more so you improve fuel economy.

Recommended pressure for my car is 33 psi and I've been using 38-40 PSI this summer. I've seen a great increase in fuel efficiency although I did the 100000km maintenance recently which probably also helped. However yesterday I had a tire failure which I don't know was caused by what, didn't see anything on the road, was in the middle of changing lanes on the highway, heard a loud BANG, suffice it to say it was not a pleasant experience. Fortunately it was a rear wheel so I didn't lose much control. Tire has a large whole on the inner wall (the side opposite to the road) but I did have to drive with it flat for maybe a kilometer which likely aggravated the initial damage.

Anyway, perhaps the failure is simply due to some object I hadn't seen but I'm wondering whether I'm taking risks by running at higher pressure than recommended. Surely a few PSI over is safe? How much is too much?

Link to comment
https://www.neowin.net/forum/topic/1233533-how-much-tire-pressure-is-too-much/
Share on other sites

I always do the recommended for normal driving.. My car that I have for drifting and racing, sometimes I'll run it higher pressure or lower depending on the track. If you are doing just normal driving, I would say keep it as close to the specs of the tires as possible..  

I'm doing a 20km commute on mostly highway at very conservative speeds, typically well under 100km/h. The car is empty save for me and I'm a slim nerd. Tires are good I think (Continental ContiProcontact I believe), don't seem too worn out, although I got them used when I bought the car.

Over-inflating your tires as little as 6psi can lead to excess damage when driving over uneven sections of road and/or potholes. When the tire is overinflated, it cannot compress and spread impact over its entire surface. This will also lead to a rougher ride, as the tire cannot cushion the weight of the car as well.

 

Overinflation will also cause the tire to bulge out along the center of the treads. This will result in a decrease in traction and stopping distance, since less of the tire is contacting the driving surface.

 

When tires are overinflated, they will wear unevenly. This will cause more stress on the tire itself, which can lead to leaks and blowouts.

Read more : http://www.ehow.com/list_6109527_effects-overinflation-tires.html
 

I see a lot of conflicting advice on tire pressure online. Lots of people say just put the recommended pressure, lots of people also say put a bit more so you improve fuel economy.

Recommended pressure for my car is 33 psi and I've been using 38-40 PSI this summer. I've seen a great increase in fuel efficiency although I did the 100000km maintenance recently which probably also helped. However yesterday I had a tire failure which I don't know was caused by what, didn't see anything on the road, was in the middle of changing lanes on the highway, heard a loud BANG, suffice it to say it was not a pleasant experience. Fortunately it was a rear wheel so I didn't lose much control. Tire has a large whole on the inner wall (the side opposite to the road) but I did have to drive with it flat for maybe a kilometer which likely aggravated the initial damage.

Anyway, perhaps the failure is simply due to some object I hadn't seen but I'm wondering whether I'm taking risks by running at higher pressure than recommended. Surely a few PSI over is safe? How much is too much?

 

The maximum tire pressure listed on the tire is just that...the MAXIMUM (not the recommended pressure).  The right pressure depends on the vehicle and the tire size and should be listed on your door/manual.  If you have the same size/type tires as the ones that came with the car ... those listed pressures are valid.  However, if your load index on the newer tires are lower than you will need to add pressure ... and vice verse.  

 

Anyway, I would just stick with whatever the vehicle manufacture suggests...in your case 33 PSI.

33 psi is fine and is the recommended to get the most life, fuel mileage, and best grip combination.  You can increase fuel mileage or grip by going higher or lower with the air pressure, but you will hurt life and the other attribute (fuel mileage or grip) if you go too high or too low. 

 

Lower pressure can increase grip, but by doing this you will gain more rolling resistance which decreases gas mileage (making the tire softer).  This will also decrease tire life

Higher pressure can increase gas mileage by decreasing rolling resistance but this will decrease surface grip (making the tire harder).  This will also decrease tire life.

 

Shouldn't really play much beyond 5psi, unless you are racing.  Usually drag racing with the right equipped tire, you will see pressures as low as 18psi or lower(remember that whole grip thing that I mentioned before, it comes in play heavily here). Even autox, you will have your tires ~5 psi lower than what the doors say. 

While we are on the topic, and please realize I am not a big car guy at all, which PSI do you all go by? The one that is on the inside of the drivers door on a sticker or on the tires themselves? As for me they are two different numbers entirely.

 

Also the tires almost always list max load. So is there some kind of calculation to figure out normal load?

The door has manufacturer recommended psi, I usually go 5 above during winter time when using air out of a compressor.  Air molecules like to shrink in cold, so psi drops.  If they are nitrogen filled, I believe they also fill ~5 above.  Nitrogen molecules are closer together so there is less of a psi drop or increase during the cold or hot months.  Besides, I have pressure indicators in my cars...If I don't over inflate slightly those lights come on within a week during the winter months.

The door has manufacturer recommended psi, I usually go 5 above during winter time when using air out of a compressor.  Air molecules like to shrink in cold, so psi drops.  If they are nitrogen filled, I believe they also fill ~5 above.  Nitrogen molecules are closer together so there is less of a psi drop or increase during the cold or hot months.  Besides, I have pressure indicators in my cars...If I don't over inflate slightly those lights come on within a week during the winter months.

Both of my cars will tell me when the pressure is low, just neither unfortunately tell me when it is correct, unless I am missing something.

 

The PSI listed on the tire itself is a maximum PSI, not recommended.

Yep, which is why I asked this...

Also the tires almost always list max load. So is there some kind of calculation to figure out normal load? 

Recommended tire pressure varies per tire and per car. As long as you're sticking with the factory recommended model/size tire for your car, just check the manual for the required pressure. Anything under or over that is bad.

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • This Chinese company is reportedly developing a feature Apple and Samsung can only dream of by Hamid Ganji While companies like Apple and Samsung have been relatively conservative with their devices’ battery capacities in recent years, Chinese manufacturers have taken the competition to the next level by introducing significantly larger batteries. However, the latest report from China suggests that a local company may already be developing a smartphone with a whopping 14,000mAh battery. Chinese leaker Digital Chat Station claimed on Weibo that a smartphone maker is developing a device with a 14,000mAh battery. If true, it would be the largest battery ever used in a smartphone and could, in theory, provide up to a week of battery life on a single charge. The leaker did not reveal the name of the company behind the device, but there are some clues. This week, HONOR unveiled the X80 Pro Max in China with an 11,000mAh battery and 90W wired charging support. The company also launched the Honor Win in January, which packs a 10,000mAh battery. HONOR, a former subsidiary of Huawei, has a proven track record of developing smartphones with unusually large batteries. However, other Chinese brands, including Xiaomi, have also launched devices such as the Xiaomi 17 Pro Max with 7,500mAh batteries. Though Chinese users on Weibo also believe the company behind the new battery is HONOR. Interestingly, Digital Chat Station said the device with the 14,000mAh battery weighs around 220 grams, making it lighter than the Apple iPhone 17 Pro Max (233 grams) and slightly heavier than the Samsung Galaxy S26 Ultra (214 grams). The iPhone 17 Pro Max currently packs a 5,088mAh battery in eSIM-only versions, while the Galaxy S26 Ultra features a 5,000mAh battery. Neither device is expected to see a dramatic increase in battery capacity in its next-generation successor. So when it comes to battery comparison, Chinese brands are unbeaten. HONOR smartphones are currently available in the EU, but the Chinese brand has no official presence in the United States due to restrictions imposed by the U.S. government.
    • Qualcomm takes on NVIDIA with new Dragonfly CPU and AI chips by Pradeep Viswanathan Microsoft, Google, Amazon, AMD, Meta, Apple, OpenAI, and several others have been developing their own chips for AI infrastructure. However, NVIDIA still remains the dominant player in the market. Today, Qualcomm announced a major expansion of its data center infrastructure portfolio to better compete with NVIDIA. The new lineup includes the Qualcomm Dragonfly C1000 CPU, Qualcomm High Bandwidth Compute technology, the Dragonfly AI300 inference accelerator, new connectivity products, and custom silicon solutions. Qualcomm claims that this new lineup improves performance per watt, token throughput, and total cost of ownership for AI data centers. The Dragonfly C1000 is a new data center CPU built with Qualcomm’s custom Oryon cores. This chip will feature more than 250 cores, frequencies above 5GHz, and a chiplet-based design. Qualcomm claims that this new C1000 can deliver more than 2x better performance per watt compared to existing server CPU offerings based on specifications. The Dragonfly C1000 will support PCIe Gen 7 with more than 2TB/s of connectivity, along with CXL, advanced RAS features, and both air and liquid cooling. Qualcomm expects the Dragonfly C1000 to be commercially available in 2028. Additionally, Qualcomm and Meta announced a multi-year, multi-generation agreement under which Qualcomm will supply Dragonfly C1000 data center CPUs for Meta’s next-generation server fleet. Qualcomm also announced High Bandwidth Compute, a new near-memory computing architecture designed to address AI’s memory bandwidth bottleneck. HBC Gen 1 will debut with the Dragonfly AI250, which is expected to sample in mid-2027. The AI250 will deliver 133TB/s per card, an 18x increase in effective memory bandwidth compared to the AI200 with LPDDR5X. The new Dragonfly AI300 with HBC Gen 2 is a rack-level AI inference platform from Qualcomm. Qualcomm claims that the AI300 can deliver 4x to 8x better performance per watt compared to existing GPU-based architectures based on memory bandwidth per watt per card. The Dragonfly AI300 is expected to be available in 2028.
  • Recent Achievements

    • Week One Done
      Meta Plast earned a badge
      Week One Done
    • First Post
      kinowa earned a badge
      First Post
    • Rookie
      krychek57 went up a rank
      Rookie
    • Grand Master
      Jaybonaut went up a rank
      Grand Master
    • One Year In
      Philsl earned a badge
      One Year In
  • Popular Contributors

    1. 1
      +primortal
      461
    2. 2
      +Edouard
      171
    3. 3
      PsYcHoKiLLa
      136
    4. 4
      Michael Scrip
      78
    5. 5
      Xenon
      77
  • Tell a friend

    Love Neowin? Tell a friend!