Recommended Posts

Normal use, non-game playing and everything is fine but within a few mins of playing, TF2/skyrim/ect then my cpu fans start speeding up and this is all out of the blue. No hardware changes or software change/updates. Even if I tab out of the game the fan speeds slow down. Not sure what could be the issue. Below is a screen shot of HWMonitor/CPU-Z/GPU-Z. Any help would be appreciated.

VXgK649.png

Sounds like it's fine, a lot of rigs adjust fan speed depending on how much is being demanded from components, (mine goes from near silent to a jet engine taking off, depending on the game or application) it's getting hotter, so more cooling is required.

Sounds like it's fine, a lot of rigs adjust fan speed depending on how much is being demanded from components, (mine goes from near silent to a jet engine taking off, depending on the game or application) it's getting hotter, so more cooling is required.

 

 

It just never acted like this, had the pc since 2012, which is why I started to get concerned. 

It just never acted like this, had the pc since 2012, which is why I started to get concerned.

Actually Decrypter has a point, dust can cause heating issues also, and come to think of it, I haven't cleaned my new rig since I built it, so I should do that too.

Clear any dust out if you're concerned, but the CPU fans spinning up under load is normal, it's what they're supposed to do.

This.

 

Dust builds up in heatsinks, causing fans to have to spin up higher in order to cool.

the CPU cores are in their 60's.... what would you expect? youre saying the fans would never speed up before even when the cores are 60C+??

 

No it's never been an issue before.

 

 

Yeah clean the dust out of the heatsink/fan and also remove the heatsink/fan and reapply new thermal paste.

 

Going to reset the heatsink this weekend. 

Could be the drying of the heatsink thermal compounds on the CPU and GPU, I always replace my hs compound annually, it dries out being heated/cooled cycle for 2 years mate.

Also clean all your heatsinks of dust, any surface dust on components act like a dusty cosy blanket and will raise case ambient temps also.

 

Flow of air through the case is as important as the actual heatsinks, the lower the ambient air temperature in the case, the more effective your cooling is on heatsinked items (active & passive)

Also clean any dust sponge filters your fans have on the case, doesn't take that much to reduce airflow, allowing ambient temperatures to build up, affecting efficiency of your cooling, resulting in higher temps especially under load.

I think I got it solved. I took the heatsink down and took off the fans to give it a better cleaning. Even did all updates that I could just in case it was software related. Seems to be back to normal for the most part. Thanks for all the help.

I think I got it solved. I took the heatsink down and took off the fans to give it a better cleaning. Even did all updates that I could just in case it was software related. Seems to be back to normal for the most part. Thanks for all the help.

Your welcome mate, while your at it review your case cooling and free pathways for the intake fans etc
This topic is now closed to further replies.
  • Posts

    • With the current hardware prices Microsoft should lift the restriction. Then if you have the correct TPM then allow you to use X feature, if you don't have the correct TPM then don't but still actually let you run windows. 11. With a disclaimer during install that X features would be unavailable.
    • It's good for recycling of course. But commence inflation of a second hand RAM bubble and price gouging on DDR 4 inventory in 3... 2... 1...
    • Bypassed Windows 11 shows surprising stability on ancient, completely unsupported hardware by Sayan Sen When Windows 11 was first released, one of the most complained-about issues with the new desktop Microsoft OS was its higher system requirements, which pushed many relatively modern and powerful processors and devices onto the officially unsupported list. Thankfully, they have not been updated again for the base OS, though systems require four times the memory and storage if they want to run AI-powered apps and features. As such, Windows 11 technically runs on 4GB of memory, and there is no imposed restriction on the generation of memory it supports. Speaking of memory, prices are extremely high nowadays for hardware, especially DDR5 and DDR4 kits due to the current silicon shortage, and there are also reports of it affecting DDR2 as well, and it might only be a matter of time before even DDR1 gets affected. Before that could happen, an enthusiast took an ancient DDR1-based system and decided to try out Windows 11 on it to see how well the modern OS would fare on such hardware. The system runs an outdated graphics card interface standard based on AGP, or Advanced Graphics Port, called AGP 3.0 or AGP8x. AGP was essentially succeeded by the modern PCI Express (PCIe) bus standard. The user behind the experiment is retro hardware enthusiast Omores, who built the system around an ASRock ConRoe865PE motherboard based on Intel's i865PE chipset from way back in 2003, around the time when AGP was still in fashion. What made this board special back in the day was its unusual support for newer Core 2 Duo and even Core 2 Quad processors while still retaining older DDR1 memory support and an AGP8X graphics slot, making it an ideal bridge or link between two vastly different generations. Powering the machine was Intel's Core 2 Quad Q6600 alongside 3GB of DDR1 RAM and an ATI Radeon HD 4650 AGP graphics card, one of the final and most capable GPUs released for the aging AGP interface. While installing Windows 11 itself was relatively easy by bypassing Microsoft's hardware checks, getting the graphics card fully functional proved to be some challenge. Microsoft had quietly dropped native AGP support after the earliest releases of Windows 10, meaning newer versions of Windows no longer include the necessary Graphics Address Remapping Table (GART) drivers required for proper AGP acceleration. Without them, AGP graphics cards typically boot up, though with limited functionality, and can often throw a Code 43 error in Device Manager. To work around the limitation, Omores extracted Intel's legacy AGP440 SYS driver from an early Windows 10 release and paired it with a modified INF file so Windows 11 would correctly recognize the chipset. Following this and combined with AMD's final 64-bit Catalyst AGP drivers from 2012, the Radeon HD 4650 was able to operate with full AGP 8X acceleration intact. The result was said to be surprisingly usable for hardware that is over two decades old. Hardware-accelerated H.264 video playback worked correctly and benefited apps like Firefox, while legacy applications and games ran without major graphical issues. The system also successfully completed the 3DMark 2001 benchmark, although performance naturally lagged behind what the same hardware achieves under Windows 7, which is significantly lighter than Windows 11. There was, however, one unavoidable limitation as Microsoft's Windows 11 version 24H2 introduces a mandatory SSE4.2 CPU instruction requirement that cannot be bypassed through installer modifications or registry tweaks. Since no AGP-era processor supports SSE4.2, Windows 11 version 23H2 effectively becomes the final release capable of running on such systems. Regardless, it is still a very cool feat and quite fascinating to see just how stable Windows 11 turned out to be on such unfamiliar hardware. Source: Omores (Patreon) via O_MORES (Reddit)
    • That will only really help other players that are also responsible for creating the problem.
    • Well, it's good to know that they have found a workaround to a problem that they helped create, I guess...
  • Recent Achievements

    • Reacting Well
      NovaEdgeX earned a badge
      Reacting Well
    • Week One Done
      NovaEdgeX earned a badge
      Week One Done
    • One Year In
      BA the Curmudgeon earned a badge
      One Year In
    • Conversation Starter
      rosiecharles earned a badge
      Conversation Starter
    • First Post
      KMilenkoski1202 earned a badge
      First Post
  • Popular Contributors

    1. 1
      +primortal
      539
    2. 2
      +Edouard
      266
    3. 3
      PsYcHoKiLLa
      151
    4. 4
      Steven P.
      98
    5. 5
      macoman
      66
  • Tell a friend

    Love Neowin? Tell a friend!