Empty NTFS partitions on my SDD; what's the use?


Recommended Posts

After I cloned my SSD I see that there are empty, non drive-letters, partitions on muy SSD.

What's the use of this? Can they be safely deleted? [for space-sake they can remain, because this drive has lots of free space].

Just wondering...

image.png

image.png

First partition should be for boot. I see it all the time with Linux systems.

Why they are "fragmented" like that, not sure.. Maybe they use it for storing system data? IDK..

Technically your EFI Partition should only be 100MB (the very first one), and shouldn't have any gap between that and the Windows partition, the recovery partition (the last one) can vary but is generally around 600MB.

On 25/03/2023 at 23:48, Matthew S. said:

Technically your EFI Partition should only be 100MB (the very first one), and shouldn't have any gap between that and the Windows partition, the recovery partition (the last one) can vary but is generally around 600MB.

Unless t's an OEM install then it's not uncommon to see a Schmorgan's board of partitions.

Can't really do anything with the "Other" 16MB.  Assuming it's a MSR partition.

If you're worried about any possible data in the 837 and 650mb ... you should be able to just assign them drive letters and take a look inside.  Afterwards, you should be able to safely delete them causing them to become unallocated ... and extend the partitions of C and Z.  ¯\_ (ツ)_/¯

Does that 500+ GB partition have a drive letter...assuming it does?  What's up with the two smaller T and Z partitions?  Man, that's just a messy looking drive layout.

 

On 25/03/2023 at 23:48, Matthew S. said:

Technically your EFI Partition should only be 100MB (the very first one), and shouldn't have any gap between that and the Windows partition, the recovery partition (the last one) can vary but is generally around 600MB.

It's probably one of the ASUS notebooks in his sig block.  My Dell notebook has a 650 EFI partition ... my ASUS notebook is 345mb.  My home built desktop is 100.

On 26/03/2023 at 07:06, Warwagon said:

Unless t's an OEM install then it's not uncommon to see a Schmorgan's board of partitions.

True, I did forget about OEM bloat.  Having only ever owned one Windows-based laptop which was well before UEFI...

On 26/03/2023 at 06:08, Jim K said:

Man, that's just a messy looking drive layout.

Agreed ;) what is odd they don't look to be recovery partitions.. Even when you install windows native on the drive - shouldn't there be the recovery partition for say windows 10.. Those wouldn't show up as ntfs partitions..

That  looks to be self inflicted - or redoing maybe the recovery partitions that an OEM might do..

 

 

On 26/03/2023 at 15:06, BudMan said:

Agreed ;) what is odd they don't look to be recovery partitions.. Even when you install windows native on the drive - shouldn't there be the recovery partition for say windows 10.. Those wouldn't show up as ntfs partitions..

That  looks to be self inflicted - or redoing maybe the recovery partitions that an OEM might do..

 

 

It were recovery drives.

However, I put Win 11 Pro on it [with a purchased key], so I don't really need the Asus recovery anymore... drivers and software can be downloaded based on the model.

I rearranged the layout. And everything's working fine. 

The G: General is 'spare GB's' put on other drive :laugh:

Is this better drive layout-speaking?!

image.png

Even if you install windows 10/11 clean there should be a recovery partition.. This allows you to "reset" etc..

Not saying you have to have that - you could always do a clean install again if things go sideways.. But then again its not so large of amount of space that it should matter..  And pretty sure it contains recovery tools that could be used in the fixing of issues.. etc.

I don't see the point of like that G drive, why not just make it all just your OS drive?  I don't see the point of your temp and swap partitions either - do you ever even use swap?

Partitioning your drives like that make more sense in a multi user setup where you don't want some user using your whole disk with their stuff and killing the space the OS has for its use, etc.   In a single user machine they don't have as much use, and limit your use of possible space, etc.

 

 

 

On 26/03/2023 at 19:32, BudMan said:

Even if you install windows 10/11 clean there should be a recovery partition.. This allows you to "reset" etc..

Not saying you have to have that - you could always do a clean install again if things go sideways.. But then again its not so large of amount of space that it should matter..  And pretty sure it contains recovery tools that could be used in the fixing of issues.. etc.

I don't see the point of like that G drive, why not just make it all just your OS drive?  I don't see the point of your temp and swap partitions either - do you ever even use swap?

Partitioning your drives like that make more sense in a multi user setup where you don't want some user using your whole disk with their stuff and killing the space the OS has for its use, etc.   In a single user machine they don't have as much use, and limit your use of possible space, etc.

 

 

 

This is from a clean install disk [other computer]. I don't see any 'reset' partition...

Ah well.. when your computer's not working as is should, better to clean install anyhow.

image.png

On 26/03/2023 at 19:32, BudMan said:

Even if you install windows 10/11 clean there should be a recovery partition.. This allows you to "reset" etc..

Yeah, don't get rid of that. I have learned the hard way. I decided to reset the laptop and it went, "oops something went wrong." Because cleverclogs that I am thought, "meh, I'm never going to need that option." So I had to reinstall the whole Windows partition again. Ultimately it was going to be the same process, but I did have to make sure my documents and such were backed up to their latest version before I went ahead.

 

On 26/03/2023 at 19:32, BudMan said:

 don't see the point of like that G drive, why not just make it all just your OS drive?  I don't see the point of your temp and swap partitions either - do you ever even use swap?

Partitioning your drives like that make more sense in a multi user setup where you don't want some user using your whole disk with their stuff and killing the space the OS has for its use, etc.   In a single user machine they don't have as much use, and limit your use of possible space, etc.

I would argue that if you are dual-booting or trying to access information from one OS to another over a network you might want a common filesystem area that both systems could access, but I agree that there are easier solutions.

On 26/03/2023 at 13:18, Nick H. said:

dual-booting or trying to access information from one OS to another over a network

While I agree with dual-boot, but does anyone even do that any more.. Back in the day sure I could boot multiple OSes - but now just run a VM, or for my linux fix just run it on a pi, or of late I have just been using wsl in windows..   Also use cygwin etc..   I just don't see the need to partition a disk like being done, other than like uefi or some sort of recovery partition, etc.  For my storage/os needs I would just use 1 partition.. 

But over a network - makes no difference what the file system is.. As long as the server that is sharing it can access it, for example my nas disks are btrfs - windows sure doesn't understand that filesystem ;)

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • Turbo Pascal was my first real programming experience more than 30 years ago at university. I mostly taught myself from the included examples and help documentation, because the university only taught the basic syntax and philosophy of Pascal, without going deeply into Turbo Pascal’s advanced features. I still remember when I discovered that I could embed assembly language directly into Pascal code, call BIOS functions, manipulate screen memory, use mouse interrupts, and control peripherals from my programs. That opened huge doors for me. Programming back then felt really fun, direct, and close to the machine. What I loved about Pascal was its readability and the almost instant compile time. Turbo Pascal was an amazing environment, but unfortunately Turbo Pascal for Windows 3 did not feel like it fully carried that legacy forward. Later, Delphi got things back on the right track after the messy transition to TP for Windows. Sadly, Delphi suffered from years of uncertainty as it moved from Borland to CodeGear and then to Embarcadero. That instability made many developers lose confidence in it, even though Delphi itself remained a powerful and productive tool. I still work with Delphi from time to time, but I definitely miss the old days of Turbo Pascal.
    • I hope this encodes in to AV1 or AV2 as currently tiktok uses h265 and h264.
    • Qualcomm reportedly in talks to build custom video chips for TikTok parent ByteDance by Karthik Mudaliar Qualcomm is reportedly in advanced discussions to provide custom chip-design services to Chinese tech giant ByteDance, the same company behind TikTok. According to a report from Reuters, Qualcomm could be involved in designing custom silicon tailored for ByteDance's massive data-center workloads. If it goes through, the deal would make ByteDance one of Qualcomm's early anchor customers for its fastly growing custom chip-design division, For years, Qualcomm was the king of making smartphone processors and modems. The company has also been moving into the PC ecosystem and other formats such as on-device AI for Android XR headsets. However, this particular deal is about Qualcomm's custom Application-Specific Integrated Circuits (ASICs). For a platform like TikTok, ByteDance needs hardware that can help it ingest, process, and serve billions of short-form videos daily. Generalised hardware is no longer the most cost-effective and efficient route, which is why ByteDance is trying to develop custom Video Processing Units (VPUs). VPUs designed specifically for ByteDance’s algorithmic needs could drastically reduce data-center power consumption and improve encoding speeds at an unprecedented scale. The underlying tech behind these processors is actually from Qualcomm's recent acquisition of AlphaWave Semi, a high-speed connectivity specialist company. By combining AlphaWave’s high-bandwidth IP with Qualcomm’s architectural expertise, the company could begin mass production by the end of 2026, if the talks go through. All this also comes at a time when U.S.-China tech relations have dwindled. Escalating trade frictions between Washington and Beijing have severely impacted the export of high-end AI chips from U.S. firms like Nvidia, AMD, and Lam Research. Yet, the Qualcomm-ByteDance discussions show that U.S. tech companies are still actively seeking growth avenues and are open to doing business with China, where regulators still permit. Reuters notes that the outcome of this deal could be uncertain, and ByteDance might also seek partners other than Qualcomm. via Reuters | Image via DepositPhotos.com
  • Recent Achievements

    • One Year In
      OHI Accounting earned a badge
      One Year In
    • First Post
      Almohandis earned a badge
      First Post
    • Rookie
      DaviKar went up a rank
      Rookie
    • Dedicated
      HidekoYamamoto94 earned a badge
      Dedicated
    • One Month Later
      timbobit earned a badge
      One Month Later
  • Popular Contributors

    1. 1
      +primortal
      461
    2. 2
      +Edouard
      169
    3. 3
      PsYcHoKiLLa
      119
    4. 4
      Michael Scrip
      82
    5. 5
      Xenon
      69
  • Tell a friend

    Love Neowin? Tell a friend!