Barts Network Boot Disk

[astrokat]

Does anyone know how to use Barts Network Boot Disk to automatically map a network drive after it finishes its sequence? I do not know what file to edit.

Thanks

[+primortal Subscriber²]

I think there is an autorun.bat file. Add the map drive command to the end.

[astrokat]

are you sure thats it? That file is located inside of a cab file (2 of them). I would have to rebuild the cab file in order to modify it.

[PseudoRandomDragon]

I have used it, it is very very good. Basically, what you do is load the files onto a disk. This is automatically done when you run the program. The default drivers don't always work, but you can replace the .cab files with the ones you want, the only limits being what the disk can hold.

[astrokat]

oh, oops, there is a map drive dialoge .. i just have to figure out how to get to it again.