[Review] M-Audio Studiophile LX4 Speakers


Recommended Posts

Introduction

M-Audio has been in the music industry not so much as a competitor for PC consumers, but more for recording musicians who use their products to create and record audio. Those of us enthralled by all things audio usually find ourselves stepping away from entry-level soundcards and speakers, but it's always been more difficult trying to find a good pair of stereo speakers for a PC setup due to limited selections. This is what makes the Studiophile LX4 speakers so versatile; their capability of either 2.1 or 5.1 speakers can accomodate the music or movie user. At only $350 USD for the 2.1 setup, it's price is affordable and does not sacrifice performance (the 5.1 expandable speakers can be purchased for an additional $150). For the purpose of this review, I will only be evaluating the system in 2.1 mode.

maudio017ms.jpg

Evaluation

The LX4 arrived at my front door before I was home from work. To my amazement, the box itself was huge and looked like it could've housed a typical 5.1 PC speaker system. Upon opening it, there were only the common accessories like speaker wires, power cable, and manual. Being the hardcore audio enthusiast that I am, I did not bother to read the manual and proceeded to set up the speakers without any guidance.

maudio026bo.jpg

Setup soon became a nightmare as I soon realized that the integrated amp on the subwoofer required 1/4" phono plugs. I had to make an emergency trip to RadioShack to pick up several items necessary to properly set up the system.

maudio104ot.jpg

maudio099sb.jpg

I had to get three 1/4" phono-to-RCA plugs to hook up to the integrated amp on the subwoofer, a 1/8" Y-adapter stereo-to-RCA plug for hookup to the soundcard, and finally a 1/8" stereo-to-RCA single adapter for the subwoofer cable (LFE). Make note of these items if you plan to buy a set of these speakers.

maudio063in.jpg

Here is a closer look at the LX4 speaker system, front and back. The subwoofer wasn't as monstrous as I had expected it to be, but its performance proved otherwise.

maudio114hf.jpg

maudio031hz.jpg

maudio046cv.jpg

Those of you with little children may want to reconsider getting these because like all traditional monitor speakers, there is no protected grill cover. Here is a comparison of the LX4 monitor's size alongside a Logitech Z-2200 satellite speaker.

maudio053ja.jpg

maudio084jg.jpg

Finally onto the setup. I never use the factory supplied speaker wires since they are almost always cheap quality, so I scrounged through my box of spare cables and managed to dig up a pair of MonsterXP speaker wires. I also used a set of Monster Interconnects for hookup to the left/right audio channels. While I'm not a big fan of Monster cables (they sound harsh and don't do a good job of filtering the brightness), I figured it was appropriate to pair them with the LX4 considering they are in the same category of price/performance.

maudio141ig.jpg

maudio135rg.jpg

maudio071ip.jpg

Here is the back of the X-Fi soundcard.

maudio126vv.jpg

After 30 minutes of fiddling around with speaker angles and calibrating, I finally had the LX4 in their temporary positions for music evaluating. The monitors have to be toed in slightly and have a distance of no less than 3.5 feet between them for the best soundstage.

maudio150jl.jpg

The Music

The LX4 definitely has the detail and clarity level of higher-end bookshelf speakers in the $600-$1000 range, capable of producing rich high-frequencies and maintaining a solid tonal balance between midrange and low-frequencies. The subwoofer is not at all too overpowering and outputs more accurate bass than I've heard from any of the Logitech Z-5500 or Klipsch 5.1 Ultra line of speakers. Lows are quick and punchy with all types of music and never once did I hear any muddiness. All material I played through the LX4 allowed for good depth, focused imaging, and was easy to listen to after properly calibrating the speakers.

Garth Brooks as Chris Gaines' track It Don't Matter To The Sun in HDCD really revealed the true character of the LX4. His voice was extremely neutral and the guitar strikes were so revealing it made me almost forget I was listening to speakers. These monitors really do an excellent job at detail execution!

The Games

I did not have the chance to test the LX4 on many different games but let me just say that of the few games tested, the LX4 had chills running down my spine! During the intro screen of Need For Speed: Most Wanted (right before you select users), I heard crystal clear details of tires screeching and engines revving in the far background. I was amazed that I had played this game 100 times before (using X-Fi and Z-2200) and those subtle details never stood out enough to "wow" me. Even at just this intro screen, cars chased left and right behind my ears. I was stunned! The one problem these speakers did have with gaming was the bleeding highs; however, this problem was quickly fixed by adjusting the treble down to about 25% using the X-Fi volume panel.

The Downside

There is no volume control anywhere else on this system except behind the subwoofer which makes it a hassle. I have been using the X-Fi software to adjust volumes but will more than likely resort to hooking everything up to an external integrated amp/processor for easier volume adjustment. The system was not intended for use with only PCs, therefore no phono plugs and adapters were included. I wish M-Audio would've supplied its consumers with these for the sake of simplicity. As far as sound performance, the LX4 monitors do tend to sound a bit bright at times (especially at higher volumes). I have spent hours tweaking and calibrating but cannot get it perfect. I guess you cannot expect too much from a system that is only $350, although I'm sure with the right soundcard (EMU 1212) the LX4 would definitely perform better.

Conclusion

I have found the M-Audio Studiophile LX4 system to be one of the best sub $400 speakers for PC enjoyment. Low frequencies were solid without any boominess and soundstage was dead-center! Compared to my old set of B&W 602S3 bookshelf speakers, the soundstage isn't as wide but when you factor in that it is only $350 these reference monitors are excellent.

Packaging: 10/10

Design: 8.5/10

Ease of Setup: 7/10

Accessibility: 8.5/10

Music: 9.5/10

Games: 9.5/10

Value (Price/Performance): 10/10

OVERALL: 9/10

Score Comparison Reference Guide:

Dynaudio BM5A Studio Monitors: 9.5/10

Logitech Z-5500: 8/10

Klipsch ProMedia 2.1: 8/10

Logitech Z-2200: 7.5/10

Logitech Z-2300: 6/10

Edited by coolmonk

Great review coolmonk. I have a slightly off topic question though. In your experience, why did you give the Z-2300 a 6/10? Thanks.

Well depending on what type of "audio" user you are, you may or may not agree with my opinion. From the POV of an audiophile or hardcore audio enthusiast, the Z-2300 just isn't capable of producing any accurate details, whether it be highs or lows. Bass is too boomy and highs are cloudy...and this was on the X-Fi soundcard. You really can't complain considering it's a budget speaker, and I rated it low because it came out after the Z-2200 (which is superior to the Z-2300) so it's supposed to be an upgraded version yet fails to outperform its predecessor. In my opinion, the best budget 2.1 PC speakers are the Klipsch ProMedia 2.1!

I will be doing another review over the weekend on the Dynaudio BM5A monitor speakers ($1,500/pair) and will use the EMU 0404 soundcard. These speakers are believed to be the BEST thing you can get for under $3,000. Keep an eye out for it...

Do you make music then?.. because these arn't the type of speaker the usual consumer would buy.

No I don't make music...I just enjoy listening to it. While these speakers aren't primarily aimed at PC consumers, it is well within the same price as other sets (Z-5500 is $350+ and Creative Gigaworks is $500). Therefore, I'm simply justifying that for a similar price you can have yourselves a much better speaker.

Now...the Dynaudio BM5A that I will be getting this weekend are more for audiophiles, yes, but it's always nice and fun to read a review about extreme products every now and then, right? :yes:

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • Rufus alternative Ventoy now supports Windows 11's mandatory update, fixes major boot bug by Sayan Sen While Microsoft has its own official Media Creation Tool used for making bootable USB media, there are some popular third-party utilities as well which offer additional options like bypassing system requirements, Microsoft Account creation, and more. One of these is Ventoy, and the software has received its latest update today. In fact, the app actually got a slew of updates over the last couple of days, three version releases in total, to be specific. The first release, version 1.1.13, was pulled as there was some unspecified error in the update, and as such, the corrected version 1.1.14 was pushed out. Following that on very short notice, 1.1.15 was published as well. For those unfamiliar, Ventoy is an open-source utility that lets users create a bootable USB drive once and then simply copy ISO, WIM, IMG, VHD, or EFI files onto it without repeatedly formatting the drive. It supports both legacy BIOS and UEFI boot modes, Secure Boot, and a wide range of operating systems, making it one of the most versatile tools in the category. The biggest change in version 1.1.14 is an updated Secure Boot shim file aimed at resolving the UEFI CA 2023 issue, which is basically a compatibility problem that has affected Secure Boot environments on some systems. If you recall, we reported about severe boot issues on HP devices following the release of updated Secure Boot 2023 keys. For anyone who may not be aware, back in early 2024, Microsoft announced that it was updating Secure Boot keys as they were going to become 15 years old in 2026, which is also when they are set to expire. As such, the new 2023 certificates have been rolling out with the newest Windows 11 updates. Updated boot manager and Secure Boot certificates are crucial for protection against malware like bootkits. These are mandatory updates. Alongside that, the VentoyPlugson graphical plugin configurator was updated in sync with the release. The update also introduces a new VTOY_SECURE_BOOT_POLICY option within the Global Control plugin, giving users more flexibility in managing Secure Boot behavior. Ventoy has also received a fix for a startup issue when Secure Boot was disabled. Microsoft does officially allow users to boot systems without Secure Boot as long as the PC is Secure Boot capable. The full changelog is given below: Update secure boot shim file to solve the UEFI CA 2023 issue. The new release use a new CA, so you need to enroll the new key for the first boot time. VentoyPlugson update synchronously. Global control plugin add a VTOY_SECURE_BOOT_POLICY option. Fix the boot issue when Secure Boot is disabled in the UEFI firmware. You can download the latest version of the app here on Ventoy's official GitHub repo or from Neowin software stories.
    • Windows 11 is fine, no issues on any of the machines I've run it on since release. The stricter security requirements are a good thing, sometimes the baseline needs to change and people will winge, but it is what it is. Happened with the move from 9x to NT - broke compatability Happened with XP SP2 when security started to become a serious consideration Certainly happend with Vista that brought in UAC, the concept of not running as admin (something that has been the norm in Linux/Unix from pretty much the start) and a completely new driver stack. Windows 11 will probably get looked back at as the point where even consumer and SMB IT was dragged kicking and screaming into a somewhat secure by default configuration.
    • Bluestacks has been emulating Android on Windows for fifteen years. It's janky and riddled with ads though, so WSA looked like it was going to be a huge improvement over the emulator experience. Too bad Microsoft dropped the ball on that.
    • Classic. China would be nothing without Western, Japanese, and South Korean technology.
    • The world is larger then your small viewpoint. Plenty of scientists care about this, especially those involved in space.
  • Recent Achievements

    • Rookie
      krychek57 went up a rank
      Rookie
    • Grand Master
      Jaybonaut went up a rank
      Grand Master
    • One Year In
      Philsl earned a badge
      One Year In
    • Dedicated
      Scoobystu earned a badge
      Dedicated
    • First Post
      Tom Schmidt earned a badge
      First Post
  • Popular Contributors

    1. 1
      +primortal
      441
    2. 2
      +Edouard
      172
    3. 3
      PsYcHoKiLLa
      134
    4. 4
      Michael Scrip
      78
    5. 5
      Xenon
      77
  • Tell a friend

    Love Neowin? Tell a friend!