Why is my steering wheel off center?


Recommended Posts

I noticed that it seemed to have been getting worse and worse, now if I'm on a straight and level road and driving straight; the steering wheel is off center. :/ I've had my wheels balanced and an alignment done by a reputable company.

Should I worry about this? It's a car from 2004, so its not very old.

Link to comment
https://www.neowin.net/forum/topic/598142-why-is-my-steering-wheel-off-center/
Share on other sites

My mother's car does the same thing. I'm assuming that yours is FWD. If your steering wheel is to the left while driving, turn it hard to the left and get on the gas hard (starting from a stop). See if that corrects (or over-corrects) the problem. The problem is most likely related to torque-steer, but I don't know why it stays off-center.

My mother's car does the same thing. I'm assuming that yours is FWD. If your steering wheel is to the left while driving, turn it hard to the left and get on the gas hard (starting from a stop). See if that corrects (or over-corrects) the problem. The problem is most likely related to torque-steer, but I don't know why it stays off-center.

That sounds like fun, I'm going to try it! I hope nothing breaks.

Its off center because whoever aligned it didn't bother to center it, or you have some loose/worn parts up there that are causing it to get worse. I'd take it in and have it checked out.

I'm going to do that too, but first I just got to try gdodson's suggestion. :/

It could be other things then alignment that causes the steering wheel to be off center. The right ball joint on my moms car was worn which was causing the steering wheel to be off center by quite a bit; after replacing the ball joint the problem was fixed

I would say that this is an alignment issue. I had the same problem and a good alignment cured the issue. If you are driving on a flat, straight road and your car starts to veer to the right/left within 7-8 seconds then you need an alignment. I say this because your car is so new and I'm guessing that you didn't get in any major accidents.

I had new tires fitted not long ago. So I don't think it's a worn tire problem.

It's just annoying having to take the car back in for a service since I'm always so busy, still, if it doesn't get fixed it could get even worse perhaps. :/

Thanks for everyones suggestions. (Y)

My mother's car does the same thing. I'm assuming that yours is FWD. If your steering wheel is to the left while driving, turn it hard to the left and get on the gas hard (starting from a stop). See if that corrects (or over-corrects) the problem. The problem is most likely related to torque-steer, but I don't know why it stays off-center.

That's a great idea. I'm sure the drive shafts are going to like this. Do you also open your breakfast eggs with a hammer?

That's a great idea. I'm sure the drive shafts are going to like this. Do you also open your breakfast eggs with a hammer?

Well we've taken it to a few different dealers and my dad is an ASE certified mechanic, but nobody can figure what is causing the problem. It goes off center to either side depending on the direction you have the wheel turned when accelerating. I didn't tell the OP to do it repeatedly, so unless his driveshafts are made of wood or he's putting a lot more than stock power down, nothing bad is going to happen to them. I was just wondering if his problem is due to an off-center alignment or if it's similar to my mother's car's problem.

I had new tires fitted not long ago. So I don't think it's a worn tire problem.

It's just annoying having to take the car back in for a service since I'm always so busy, still, if it doesn't get fixed it could get even worse perhaps. :/

Thanks for everyones suggestions. (Y)

Bent suspension leg? Like smashing into curbs with your car?

Well we've taken it to a few different dealers and my dad is an ASE certified mechanic, but nobody can figure what is causing the problem. It goes off center to either side depending on the direction you have the wheel turned when accelerating. I didn't tell the OP to do it repeatedly, so unless his driveshafts are made of wood or he's putting a lot more than stock power down, nothing bad is going to happen to them. I was just wondering if his problem is due to an off-center alignment or if it's similar to my mother's car's problem.

I was more concerned about the joints on the driveshaft. Which is a part of it. At least in Belgian terminology.

  • 12 years later...

Hey guys I'm a wheel aligner for Bobjane T-Marts wollongong nsw Australia and have been running into this problem a bit lately and I have found why after you have completed alignment the steering wheel is down to the left or right. Attempts to re-do your alignment nothing has changed! 

 

I have found that the steering rack it's self isn't straight. Maybe wrong aftermarket parts have been used and not genuine parts and only one side has been replaced not both! 

 

So I've knocked out both the tie rods joints, turned back the tie rod nuts as far as they can go then the same with the tie rods joints. Make sure steering wheel lock is on and do even numbers of turns to bot tie rod joints till you can slide the joints back in. Put back on the alignment and you should be able to have made the wheels and rack straight, ajust and problem fixed. 

 

Remember the rack isn't straight so if you don't do that you won't fix the down to the right or left problem. 

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • Mp3tag 3.35 by Razvan Serea Mp3tag is a powerful and yet easy-to-use tool to edit metadata (ID3, Vorbis Comments and APE) of common audio formats. It can rename files based on the tag information, replace characters or words from tags and filenames, import/export tag information, create playlists and more. The program supports online freedb database lookups for selected files, allowing you to automatically gather proper tag information for select files or CDs. Mp3tag supports the following audio formats: Advanced Audio Coding (aac) Free Lossless Audio Codec (flac) Monkeys Audio (ape) Mpeg Layer 3 (mp3) MPEG-4 (mp4 / m4a / m4b / iTunes compatible) Musepack (mpc) Ogg Vorbis (ogg) OptimFROG (ofr) OptimFROG DualStream (ofs) Speex (spx) Toms Audio Kompressor (tak) True Audio (tta) Windows Media Audio (wma) WavPack (wv) Mp3tag 3.35 changelog: This version introduces a new Files options page, enhanced toolbar customization, support for RF64 WAV files, improved Discogs and MusicBrainz tag sources, and many other improvements and fixes. See the Release Notes for more details. Download: Mp3tag 64-bit | 5.7 MB (Freeware) Download: Mp3tag 32-bit | 5.2 MB Link: Mp3tag Homepage | Screenshot Get alerted to all of our Software updates on Twitter at @NeowinSoftware
    • The FIFA World Cup is not US centric.
    • It’s amusing how Microsoft is pushing IT admins as if this was a major, game-changing update. In reality, it’s just an enablement package that bumps the build number, which is disappointing compared to the more substantial 22H2 and 24H2 releases. Technically, 25H2, 26H1, and the upcoming 26H2 are essentially the same, differing only in support schedules. They could have included the Windows K2 improvements here, but chose not to. The era of Windows being in the backburner continues, and this 26H2 release feels like an afterthought. Shame, Nadella, shame.
    • Microsoft, totally not confusing /s 25H2 - Current for non-Arm based Windows 26H1 - Current for Arm based Windows 26H2 - Only for non Arm Windows
    • After I installed those, my older but capable Win 11 laptop (16GB RAM) reported it as 26H2 26300.8697. Then I installed it on my big laptop (128GB RAM! Hehe sorry), it reported it as 25H2 26220.8690. Ugh. Do I have to switch Insiders channels from Release to Beta?
  • Recent Achievements

    • Week One Done
      AMV earned a badge
      Week One Done
    • One Month Later
      AMV earned a badge
      One Month Later
    • Collaborator
      ryansurfer98 went up a rank
      Collaborator
    • One Month Later
      Eurosoft10 earned a badge
      One Month Later
    • Week One Done
      Eurosoft10 earned a badge
      Week One Done
  • Popular Contributors

    1. 1
      +primortal
      523
    2. 2
      +Edouard
      172
    3. 3
      PsYcHoKiLLa
      78
    4. 4
      Steven P.
      72
    5. 5
      Michael Scrip
      71
  • Tell a friend

    Love Neowin? Tell a friend!