106 mpg 'air car' creates buzz, questions


Recommended Posts

(CNN) -- You've heard of hybrids, electric cars and vehicles that can run on vegetable oil. But of all the contenders in the quest to produce the ultimate fuel-efficient car, this could be the first one to let you say, "fill it up with air."

That's the idea behind the compressed air car, which backers say could achieve a fuel economy of 106 miles per gallon.

art.aircar.jpeg.jpg

Plenty of skepticism exists, but with many Americans trying to escape sticker shock at the gas pump, the concept is generating buzz.

The technology has been the focus of MDI, a European company founded in 1991 by a French inventor and former race car engineer.

New York-based Zero Pollution Motors is the first firm to obtain a license from MDI to produce the cars in the United States, pledging to deliver the first models in 2010 at a price tag of less than $18,000.

The concept is similar to how a locomotive works, except compressed air -- not steam -- moves the engine's pistons, said Shiva Vencat, vice president of MDI and CEO of Zero Pollution Motors.

The six-seater planned for the U.S. market would be able to reach speeds of more than 90 mph and have a range of more than 800 miles thanks to a dual energy engine, Vencat said.

The design calls for one or more tanks of compressed air under the car's floor, as well as a tank holding at least 8 gallons of fuel.

Whether the engine uses just air or both air and fuel would depend on how fast the car is going. It would run purely on compressed air at speeds less than 35 mph, Vencat said.

Since the car could only go a short distance when using just air, fuel is needed to get the full range, he explained.

"Above 35 mph, there is an external combustion system, which is basically a heater that uses a little bit of gasoline or biofuel or ethanol or vegetable oil that will heat the air," Vencat said.

"Heating the air increases its volume, and by increasing its volume, it increases [the car's] range. That's why with one gallon of gasoline or its equivalent we are able to make over 100 mpg."

Vencat said an on-board compressor would refill the air tank while the car is running, or owners could refill it by plugging it into a power outlet for four hours.

Experts aren't sure Americans will be zipping around in air cars and getting 106 mpg, or more than twice the fuel economy of hybrid-electric vehicles such as the Toyota Prius.

It is possible to power a car with compressed air, but the mileage claim is "at the edge of possibility," said John Callister, director of the Harvey Kinzelberg Entrepreneurship in Engineering program at Cornell University's College of Engineering.

He noted that such dramatic fuel efficiency is associated with tiny experimental cars, not bigger mainstream ones.

"No one's really proven a six-seater passenger car [can get] any better than 75 miles to the gallon. So this would represent a big step forward," Callister said.

"They would have to prove that before they can throw rocks at the Prius."

Another expert expressed concern about the amount of energy it would take to generate the required air pressure: 4,500 pounds per square inch, or more than 120 times the pressure inside the tires of a typical four-door sedan.

"That is above what you normally find even in an industrial setting," said William Bulpitt, senior research engineer at the Georgia Institute of Technology's Strategic Energy Institute.

"That takes quite a compressor to do. ... It takes horsepower to compress the air up to that pressure."

If you count that energy, it's hard to believe the car would be that much more efficient than an electric vehicle, Callister said.

The compressed air car will get a chance to prove itself next year when it competes for the Automotive X Prize. The multimillion-dollar award will go to the team that "can win a stage race for clean, production-capable vehicles that exceed 100 mpg equivalent fuel economy," according to the X Prize Foundation.

The air-car concept has also drawn the interest of Tata Motors, India's largest automaker. The company announced an agreement with MDI last year to further develop and refine the technology.

However, the cars have yet to hit the streets in India or anywhere else.

"The project is under progress. We do not yet have any timeframe for launch," said Debasis Ray, the head of corporate communications for Tata Motors.

Only prototypes exist at this point, Vencat said.

The body of the car planned for the United States would be built with fiberglass and injected foam. The chassis, composed of aluminum rods, would be glued together, not welded.

The design allows the car to be as light as possible, Vencat said.

For anyone who has doubts about its safety, he insisted computer simulations show that the vehicle would pass crash tests and meet all U.S. safety standards.

"Do you think somebody would actually put millions of dollars into making a car that will not pass safety regulations? There's no point in doing that," Vencat said.

Callister pointed out that there haven't been any lightweight, 100-plus mpg cars to pass crash tests but said it could be done through a "very clever design" of a lightweight frame.

A good prototype could dispel many of the doubts about the compressed air car, he added.

"I don't think we should discount this advance if it happens," Callister said.

source

I don't see why. It's rather hard to make an air tank go boom. It's actually easier to make an oxygen tank go boom.

Same here. Air is simply a mixture of gases (mostly nitrogen which is inert). This company could rock the automotive industry if they pull through with their pledge. I guess we'll have to wait and see.

Well, it's good to see any company trying to make serious progress. It's absolutely pathetic that with today's technology we have vehicles that are barely more efficient in the consumer range than 40yrs ago - in fact the trend over the past decade was for much larger, inefficient vehicles. It's doubtful this vehicle will get to the upper end of its projected efficiency - especially not with typical usage or fully loaded - but anything over 60mpg would be reasonable, with anything over 80mpg impressive. I'm just surprised the technology hasn't been bought up and buried.

  • 4 weeks later...

When it is compressed 120 times the pressure the of a tyre then it could definately explode with a devistating amount of force, there would be no flames but if you were in the car you would be toast ;) Anyone remember Jaws...

When it is compressed 120 times the pressure the of a tyre then it could definately explode with a devistating amount of force, there would be no flames but if you were in the car you would be toast ;) Anyone remember Jaws...

umm mythbusted :p

The airtanks are designed to take twice the amount of force used in it. and I am sure a blast shield would be installed if that was the occasion.

Also, if you get a hole in the tank, it turns into a rocket, not a bomb.

umm mythbusted :p

The airtanks are designed to take twice the amount of force used in it. and I am sure a blast shield would be installed if that was the occasion.

Also, if you get a hole in the tank, it turns into a rocket, not a bomb.

Hehe, is that then considered turbo? ;)

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • Plans. Christ at least editorialise this tripe for what it is or put your own journalistic take on it.
    • If you have a TV in your living room, chances are you can probably just use the Steam Link app and play your huge PC in big picture mode, effectively giving you the Steam Machine experience to see if you'd actually like it. The good news is the Steam Machine can have it's drives upgraded. It has a USB-C 10Gbs port as well, so the 512GB drive could be quickly moved to an external enclosure and repurposed.
    • This machine could very well be a second gaming PC for their living room as a console experience. So we would have to assume their main PC exists as well; With that said, I have 10gb home network with a 2.5gigabit internet connection here so we tend to have more than enough speed to download games. However, we can't make use of the 10gb LAN using Steam's built in transfer tool because it always compresses transfers and that slows the transfer down to well below a standard gigabit port speeds, sometimes as slow as 200-300Mb/s transfers. While that's probably still faster than most internet connections anyway, if they'd fix the LAN transfer issue it'd be upto x5 faster even on a gigabit LAN, than simply dropping a 2.5gbe port on there with hopes of a few people having fast internet connections. There are solutions, work arounds, like using LANCache if you run a NAS... or simply copying the files over manually using a network share.
    • Samsung announces ultra-fast UFS 5.0 storage to supercharge mobile AI by Paul Hill Local AI models tend to run a lot more slowly than cloud services like Claude and Gemini; however, Samsung has just announced that it has developed its UFS 5.0 solution, which increases data transfer to speeds of 10.8GB/s, enabling faster storage and processing in mobile memory that has the potential to provide more optimal local AI experiences. Commenting on this development, Jangseok Choi, head of Memory Product Planning at Samsung Electronics, said: If you’ve tried local AI, you’ll know it can be quite slow, especially if using the larger parameter models. By developing this new solution, Samsung says that storage is evolving from just storing data to a core piece of infrastructure that supports AI computation, too. The Korean company said that UFS 5.0 integrates the latest embedded memory interface standard from JEDEC and achieves up to 10.8 gigabytes per second (GB/s) transfer speeds. Regarding write speeds, Samsung UFS 5.0 can reach 9.5 GB/s. Both the read and write speeds are twice as fast as those of the previous UFS 4.1 standard. Aside from being ideal for local AI, Samsung’s UFS 5.0 is more power efficient by 40% compared to UFS 4.1. Samsung achieved this by implementing innovations such as clock gating and multi-voltage technologies. UFS 5.0 is also ultra-compact at just 7.5mm x 13mm x 0.9mm; that is 16.7% smaller than UFS 4.1. The company said it will be bringing it to multiple devices in the future, including mobile, wearable, and extended reality.
    • A bit like the steamdeck, this probably isn't for you.
  • Recent Achievements

    • Week One Done
      Almohandis earned a badge
      Week One Done
    • Rookie
      dorf went up a rank
      Rookie
    • First Post
      mike_rumble earned a badge
      First Post
    • Dedicated
      tuben earned a badge
      Dedicated
    • Week One Done
      mnsgroup earned a badge
      Week One Done
  • Popular Contributors

    1. 1
      +primortal
      496
    2. 2
      +Edouard
      209
    3. 3
      PsYcHoKiLLa
      99
    4. 4
      Michael Scrip
      86
    5. 5
      neufuse
      69
  • Tell a friend

    Love Neowin? Tell a friend!