Optimize for best video viewing experience


Recommended Posts

Currently, I have my old PC connected to 50" Sony HDTV(1080p). I want to know the best possible way to customize and tweak my pc just for video viewing experience. The drivers, the configurations, best software for playing video, may be some hardware accelaration?

I have p4 2.0 ghz and nvidia ti4600 graphic card and 1.5gig of ram.

Any good specific tutorials/advice out there for such optimization? Is there any good software out there that would calibrate it automatically?

Most sources say you're not going to be able to get 1080p playback on that without dropped frames (multi-core is pretty much a necessity), but if you're talking scaling SD video for viewing on an HDTV, VLC is always a good bet as it has a lot of tweakable options for smoothing, filters, etc. Just make sure you have good source material - 700MB DVDrip downloads of full movies are going to be very hard to make look good on a display of that size. DVDs, on the other hand, should be fine, and while it's been a long time since I worked on the P4 PC I used to have at a previous job, you might be able to pull off 720p video fairly decently. That probably has more to do with the codec and compression ratio - lighter compression 720p (and all video, for that matter) will work better at the cost of more disk space - less number-crunching the CPU has to do in order to decompress and display it. XviD or DivX will be easier than x.264.

As for acceleration on that GPU, I must admit I'm clueless. I'm a bit spoiled for having a Mac as an HTPC, and most video card settings are handled automagically so I'm less experienced when it comes to optimizing. Also, I know NVidia has something like "TrueVideo" or "PureVideo" on some cards that does MPEG-4 acceleration, but I have no idea which models feature it.

Edited by CelticWhisper
Most sources say you're not going to be able to get 1080p playback on that without dropped frames (multi-core is pretty much a necessity), but if you're talking scaling SD video for viewing on an HDTV, VLC is always a good bet as it has a lot of tweakable options for smoothing, filters, etc. Just make sure you have good source material - 700MB DVDrip downloads of full movies are going to be very hard to make look good on a display of that size. DVDs, on the other hand, should be fine, and while it's been a long time since I worked on the P4 PC I used to have at a previous job, you might be able to pull off 720p video fairly decently. That probably has more to do with the codec and compression ratio - lighter compression 720p (and all video, for that matter) will work better at the cost of more disk space - less number-crunching the CPU has to do in order to decompress and display it. XviD or DivX will be easier than x.264.

As for acceleration on that GPU, I must admit I'm clueless. I'm a bit spoiled for having a Mac as an HTPC, and most video card settings are handled automagically so I'm less experienced when it comes to optimizing. Also, I know NVidia has something like "TrueVideo" or "PureVideo" on some cards that does MPEG-4 acceleration, but I have no idea which models feature it.

I do use vlc player but I am n00b at tweaks such as smoothing and filter and such

VLC Player by far uses less resources for video playback I find as well.

As for playing HD content from PC to TV, you'd need a 6 series Nvidia card / Dual core CPU to handle it at least.

As for filters and stuff I don't use any at all with VLC, I use as is. It works and looks great once installed.

you need to upgrade the video card to something more powerful - the rest of the specs should be ok.

how do you connect the PC upto the TV? I personally suggest VGA @ LCD native, but HDMI seems to be the choice for most people now days, especially with audio via HDMI.

you don't need dual core to play hd video. i don't know why everyone keeps saying that. that video card is lacking though...

Really? I've been able to do 720p fine on a PowerPC G4 867MHz and an Athlon64 3000+ 1.8GHz, but I thought for 1080p you pretty much needed some form of SMP setup.

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • About bloody time. I have got PRs with hundred of files and the Web UI just struggling to even load the pages.
    • I wonder if it was applying secure boot certificates/dbx files?
    • I recently tried edge. It seems a lot better. A lot of the junk in it is gone. It seems less bloated and snappy.
    • Lethal fake phone chargers are still being sold on Amazon and eBay, UK watchdog warns by Paul Hill Credit: Pexels The UK consumer rights organization, Which?, is claiming that “potentially lethal knock-off chargers” are still being sold on online marketplaces seven years after it exposed the danger of these chargers. In its latest investigation, it bought 15 USB phone chargers from several online marketplaces and found they were missing key information, meaning they cannot be legally sold in the UK. Which? bought the 15 chargers from seven online marketplaces. These were Amazon (including Amazon Haul), AliExpress, B&Q Marketplace, Debenhams Marketplace, and eBay. It said that the chargers were so badly made that anyone using them was at risk of electric shock. Over half the chargers also posed fire and explosion risks. Of the chargers purchased, one was a fake Apple USB-C 35W power adaptor charger. To confuse buyers, the box was branded with an Apple logo, but testing found it to be a fake. Further testing picked up arcing sounds after 10 seconds of use, where a current jumps between two parts of the electrical circuit, which can cause fires, explosions, or electric shock. The manufacturers of this particular charger also put modeling clay inside it to make it feel more weighty, robust, and genuine. Not all of the chargers were technically faulty; however, some were missing key packaging, markings, and documentation, meaning they can’t be sold in the UK legally. Which? said that it is now campaigning alongside a coalition of safety groups and businesses for new laws that make online marketplaces responsible for ensuring the safety of products that they choose to list on their websites. It also said the government needs to start using powers under the Product Regulation and Metrology Act, which was adopted last July, to impose safety requirements on online marketplaces via secondary legislation, but so far, there have been delays. No matter what country you are in, be sure to properly research what you are buying and only buy authentic chargers to prevent fires. You can read more about Which?’s research here.
    • Visual Studio finally gets long-awaited feature that developers will love by Usama Jawad Visual Studio Code is Microsoft's popular, lightweight, open-source code editor, it is actually Visual Studio that is the company's flagship integrated development environment (IDE). Although the IDE already offers a boatload of useful features for developers, Microsoft has finally introduced a long-requested capability that will be loved by many. While developers have already been able to create Git pull requests (PRs) directly within Visual Studio for the past couple of years, it had not been possible to review a PR without switching to the browser, until now. Microsoft revealed in December 2025 that it is working on UX that enables developers to do just that, and fast-forward to June 2026, and Visual Studio finally has native capabilities to open and inspect a PR, discuss feedback, and wrap up the review, all without switching to the browser. This integration works for both GitHub and Azure DevOps (including on-prem). Developers have access to multiple surfaces to open a PR, including Git Repository, Git Changes, and the Git menu in Visual Studio. Once you open a PR, all the important details will be immediately visible to you, from where you can navigate to various levels of granularity and branch states, depending on the reviews that you are engaged in. As you would expect, you also get a diff view that enables you to see code changes inline or side-by-side in a separate panel. You can also review commit-by-commit. Additionally, this UX fosters collaboration as you can leave comments, reply to threads, and resolve conversations easily. Naturally, you can also leverage Copilot to apply a code suggestion to fix a potential issue. When you are done, you have the ability to approve, complete, and merge the PR. This is a pretty major feature as it has been requested heavily for the past few years. You can try it out in Visual Studio 2026 version 18.7, made available here recently. Microsoft plans to enhance this experience further in future releases with comment filtering, a timeline of PR activity, and more.
  • Recent Achievements

    • Week One Done
      Timaximus earned a badge
      Week One Done
    • One Month Later
      Timaximus earned a badge
      One Month Later
    • Rookie
      FBSPL went up a rank
      Rookie
    • First Post
      davidbazooked earned a badge
      First Post
    • Week One Done
      davidbazooked earned a badge
      Week One Done
  • Popular Contributors

    1. 1
      +primortal
      499
    2. 2
      PsYcHoKiLLa
      174
    3. 3
      +Edouard
      160
    4. 4
      Steven P.
      84
    5. 5
      ATLien_0
      75
  • Tell a friend

    Love Neowin? Tell a friend!