Installing Solaris Express (B98)


Recommended Posts

Do we have any Solaris Express experts in house at Neowin?

I downloaded the most recent release of Solaris Express (snv_98) on DVD .iso using Sun's download manager to ensure checksum of final download, burned the disc with Brasero in Ubuntu, and tossed it in the tray of a recently refurbished tower. The first time I booted the disk, it worked just fine and I was able to get into the GUI installation and got to around 80% of installation but had the system suddenly reboot. I tracked that to memory timings in BIOS, and after a few hours of Memtest was satisfied everything was good, I preceeded to install Windows 2000 on the first drive (160GB IDE). I wanted to go back later and reinstall Solaris on the second drive (74GB SATA) but the disk will no longer boot far enough to reach the GUI installer. I should mention it detected both drives and all my hardware fine the first time trying this. Instead, after the DVD's grub menu, the system freezes on the portion of the kernel boot...

"

Sun Release 5.11 Version snv_98 32-bit

Copyright 1983-2008 Sun Microsystems, Inc. All rights reserved.

Use is subject to license terms.

"

Installation hangs at this point and is non-responsive. I couldn't locate any relevant info to this problem, but it was strange the disk worked the first time, and does not boot any longer.

Link to comment
https://www.neowin.net/forum/topic/674860-installing-solaris-express-b98/
Share on other sites

Likely more hardware issues. If it booted to the GUI installer the first time, anything short of a selfcombusting DVD-R should have it boot into it again and again. If you get the release info output and nothing else, it's likely hanging at device detection. I think if you add parameter -v to the kernel line of the GRUB entry, it should output verbose info. If you also want/need verbose info of services, add "-m verbose" after the -v.

See where it hangs and post it here.

Also, you should consider getting the OpenSolaris ISO. It's the same as Solaris Express, minus some licensed bits no one would really miss, plus ipkg. And does ZFS boot. And is a LiveCD. Get the ISO here: http://www.genunix.org/ (latest is snv_98)

After adding "-v" to the boot option, the last line to appear before the kernel hangs is "/pci@0,0/pci1849,5239@13,3 (ehci0): Unable to take control from BIOS. Failure is ignored."

Most of the changes I made to the BIOS were for memory timings, I may have made a few changes to disabling built-in ports and devices, I'll see about enabling some of those again and see what random combination works (high quality ASRock engineering).

Solved!

"Universal Serial Bus (USB*) EHCI Specification

The Enhanced Host Controller Interface (EHCI) specification describes the register-level interface for a Host Controller for the Universal Serial Bus (USB) Revision 2.0."

Going on this information, I disabled USB 2.0 support in the BIOS and the Solaris disk booted without incident.

Edited by Budious

Nice.

Still, you should consider going with OpenSolaris distro. It's the same system, but with a network package manager. Makes upgrading less of a pain. "pkg image-update", wait a bit and wham, you've an updated ZFS clone of your current system. If you're going with it, be sure to download an updated ISO, one past build snv_89, because snv_89 came with boot changes that actually require hands-on to make the updated clone bootable.

Can the opensolaris builds if downloaded by .iso be installed over a current installation of opensolaris, or solaris express to maintain current configurations and user settings? I'll probably do a reinstall at a later point, this was my first dive into a Solaris w/ Gnome environment. I tried a Solaris 10/06 w/ CDE a few years back but never got used to to it.

On another topic, I am trying to install the Sun Studio 12 package in Solaris Express to be a compiler for the netbeans IDE. I successfully installed the package, but I need to update the $PATH variable to represent the /usr/bin/version to be identify as "Sun Studio 12" when requested. I did not find consistent recommendations on how to do this, but I assuming that the changes should be made to ~/.profile to something along the lines of:

PATH={$PATH}:/usr/bin:/usr/bin/version:/usr/ucb:.

export $PATH

From the iPhone since I dont have DSL yet in my new apartment. Details only tomorrow.

You install OpenSolaris only once and then update it from the repository. Downliading newer ISOs is just to keep a current version on disc in case of a catastrophe.

Regarding SS12, I have to check it out...

  • 9 months later...
Nice.

Still, you should consider going with OpenSolaris distro. It's the same system, but with a network package manager. Makes upgrading less of a pain. "pkg image-update", wait a bit and wham, you've an updated ZFS clone of your current system. If you're going with it, be sure to download an updated ISO, one past build snv_89, because snv_89 came with boot changes that actually require hands-on to make the updated clone bootable.

True/+1

I upgraded from an early version of OpenSolaris to the current version (in fact, from snv_89), and there's a step-by-step method in the release notes for build 111b (the current version) on a terminal-based over-the-Internet upgrade (works from snv_89 or any earlier build (in fact, from any build that lacks the graphical version of the Update Manager)).

The big news for non-SPARC users is vastly-improved graphics drivers (including new drivers for a passel of nVidia and AMD-based cards, including every AMD HD-series card up to HD4890).

Do we have any Solaris Express experts in house at Neowin?

I downloaded the most recent release of Solaris Express (snv_98) on DVD .iso using Sun's download manager to ensure checksum of final download, burned the disc with Brasero in Ubuntu, and tossed it in the tray of a recently refurbished tower. The first time I booted the disk, it worked just fine and I was able to get into the GUI installation and got to around 80% of installation but had the system suddenly reboot. I tracked that to memory timings in BIOS, and after a few hours of Memtest was satisfied everything was good, I preceeded to install Windows 2000 on the first drive (160GB IDE). I wanted to go back later and reinstall Solaris on the second drive (74GB SATA) but the disk will no longer boot far enough to reach the GUI installer. I should mention it detected both drives and all my hardware fine the first time trying this. Instead, after the DVD's grub menu, the system freezes on the portion of the kernel boot...

"

Sun Release 5.11 Version snv_98 32-bit

Copyright 1983-2008 Sun Microsystems, Inc. All rights reserved.

Use is subject to license terms.

"

Installation hangs at this point and is non-responsive. I couldn't locate any relevant info to this problem, but it was strange the disk worked the first time, and does not boot any longer.

Actually, as opposed to SE, go with OpenSolaris (much further along). The current release is snv_111b (2009-06), with a current developer's build of 117.

Hardware support has vastly improved (over build 98), especially in terms of graphics card support. (I'm entering this from build 117, connected *wirelessly* to the household LAN; wireless because the onboard Ethernet isn't supported by OpenSolaris.)

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • This is about the EU given consumers options, Apple is all about not giving options and locking you into its own services, this hurts Apple far more than it hurts the EU market because it makes Apple products look less appealing by Apple refusing to offer its own service because they have to give options to rivals, the end results are consumers might look at alternatives like Android. It's a game Apple can't really win when there are alternatives and Apple will in time change course on this, until then, let Apple hurt themselves in the EU market.
    • Microsoft unveils new Surface Laptop with improved trackpad, Snapdragon X2, and more by Taras Buria Microsoft's new Surface Laptop Ultra generated a lot of buzz earlier this month, but in addition to its most powerful laptop with an NVIDIA chip, Microsoft also has a more affordable laptop lineup, which has been waiting for an update for quite a while. Today, Microsoft announced the eighth-generation Surface Laptop. The new Surface Laptop is powered by the Snapdragon X2 Plus and X2 Elite processors. These chips offer faster CPU performance, up to 58% faster graphics, and 80 TOPS Neural Processing Units (NPUs) for on-device AI processing. Like the previous models, these chips retain their great energy efficiency, and Microsoft says that buyers can expect up to 20 hours of work on a single charge. The laptop is available in two sizes: 13.8-inch and 15-inch. You will have a hard time finding visual differences between the new and previous models, as Microsoft is not taking any major design leaps, except for the new Jade color, which may look familiar to Surface Laptop 5 owners. Other colors include Platinum, Black, and Dune. The 15-inch variant got a higher-resolution display. It is a 3,270 x 2,180 resolution screen with a pixel density of 262 ppi (the 13-inch model has a 201 ppi density) and a maximum brightness of 600 nits SDR and HDR. Unlike the Surface Pro 12th-gen, which is available with optional OLED displays, the Surface Laptop sticks with IPS, a 1,300:1 contrast ratio, a 120Hz refresh rate, and a 3:2 aspect ratio. Another notable change in the Surface Laptop 8 is its trackpad. It now provides haptic feedback when you perform various actions in apps and the operating system. It is a relatively new feature that Microsoft brought to Windows 11 in recent updates, and it is only available on certain devices, such as the Logitech MX Master 4, Surface Slim Pen 2, the upcoming Surface Laptop Ultra, and now the Surface Laptop 8. The new Surface Laptop with the new Surface Pro Like its tablet-shaped sibling, the new Surface Laptop is notably more expensive. It starts at a $1,599 for a 13.8-inch configuration with a 256GB SSD and 16GB of RAM. However, in the US, the base model has double the storage while keeping the same price. Available configurations include up to 64GB of memory and up to 2TB SSD (user-removable PCIe Gen4). The Surface Laptop 8 is now available for purchase on the official Microsoft website.
    • Microsoft announces 12th-gen Surface Pro with Snapdragon X2 processors by Taras Buria So far, 2026 has been rich in Surface announcements. Microsoft started with a fresh lineup of Surface for Business devices powered by Intel's new Core Ultra 300 processors. Then the company revealed the Surface Laptop Ultra, its most powerful laptop with NVIDIA's RTX Spark processor. Now, it is time for new Surface Pro and Surface Laptop models with Qualcomm processors. Microsoft's original Copilot+ PCs with Snapdragon X1 chips debuted in late May 2024. Two years later, Microsoft is finally updating the lineup with new models featuring Snapdragon X2 processors. The 12th-gen Surface Pro continues the well-established formula of Microsoft's flagship tablet, and Microsoft is not even changing colors, as the tablet will be available in three colors: Dune, Black, and Platinum. The most important changes are mostly hidden inside. Microsoft switched from the Snapdragon X1 to the new Snapdragon X2, which promises up to 53% faster graphics performance than the previous generation and up to 15.5 hours of battery life. The built-in NPU is also much more powerful, and it can run at up to 80 TOPS for on-device AI processing. Like before, the new Surface Pro is available with a 13-inch IPS display, and Microsoft is still offering OLED as a separate, more expensive configuration. Speaking of configurations, the Surface Pro will be available with a 10-core Snapdragon X2 Plus or a 12-core Snapdragon X2 Elite. Microsoft expanded the available RAM configurations to 64GB (previously 32GB was the maximum), while storage remains unchanged at 256GB, 512GB, or 1TB of user-replaceable PCIe Gen4 SSDs. The new Surface Pro and the Surface Laptop Other specs remain mostly unchanged. The computer has the same 1440p Windows Hello webcam, two USB4 ports for charging, data, and display output, Wi-Fi 7 and Bluetooth 5.4 support, dual speakers, and compatibility with Surface Pro Signature and Flex keyboards. With that said, there is one very important aspect of the Surface Pro that changed significantly, and it is the price. While the previous-gen Surface Pro launched at $999 for the base configuration, in 2026, the entry-level Surface Pro with Snapdragon X2, 16GB of memory, and 256GB will set you back an eye-watering $1,499. To sweeten the pill, Microsoft is running a limited-time promotion where Surface Pro buyers can get a free Surface Pro 13-inch Keyboard. The promo runs from June 16 through June 30. The new Surface Pro is available now on the official Microsoft Store website.
  • Recent Achievements

    • One Year In
      Console General earned a badge
      One Year In
    • One Year In
      Twozo Technologies earned a badge
      One Year In
    • One Month Later
      Twozo Technologies earned a badge
      One Month Later
    • Week One Done
      Twozo Technologies earned a badge
      Week One Done
    • Veteran
      branfont went up a rank
      Veteran
  • Popular Contributors

    1. 1
      +primortal
      525
    2. 2
      +Edouard
      209
    3. 3
      PsYcHoKiLLa
      113
    4. 4
      Steven P.
      89
    5. 5
      Nick H.
      71
  • Tell a friend

    Love Neowin? Tell a friend!