Battery capacity rapidly decreasing?


Recommended Posts

Are you keeping your Mac plugged in constantly? Have you used the Apple's calibration guide yet? ( http://support.apple.com/kb/HT1490 )

On that note, it could be worse - here's a copy paste from my 2007 MBP broken battery that Apple would not replace because it was bought during the summer and they said it did not match the list of broken batteries even thought it exhibited the *exact* symptoms;

  Charge Information:
  Charge remaining (mAh):	0
  Fully charged:	No
  Charging:	No
  Full charge capacity (mAh):	128
  Health Information:
  Cycle count:	61
  Condition:	Check Battery
  Battery Installed:	Yes
  Amperage (mA):	0
  Voltage (mV):	12303

The battery *died* after 60 cycles - beat that :-) And no, it's no longer in use :-)

150 mAh isn't that much. It could just be due to measurement error.

I will say that my late-2007 MBP battery didn't even get to 80 cycles before it lost most of its capacity. At the end I was barely getting an hour, and that was with everything turned off (WiFi, Bluetooth, etc.) and the brightness all the way down. I wouldn't be surprised if the newer batteries aren't much better.

It depends if those were complete cycles (totally dead to full charge) or just top-up cycles (75%-90% charge to full charge).

Try a couple of complete cycles (let the battery run dead, and then re-charge to full overnight), see if you can 'reset' the battery.

For camparison, after 16 months mine has gone from an original of 5020 mAh to 4740 mAh and is at 94% health. It's had 120 cycles.

Edit: Just found this article:

http://support.apple.com/kb/HT1490

You can calibrate your iBook, PowerBook, MacBook, MacBook Air, or MacBook Pro computer's lithium ion battery for best performance.

The battery has an internal microprocessor that provides an estimate of the amount of energy in the battery as it charges and discharges. The battery needs to be recalibrated from time to time to keep the onscreen battery time and percent display accurate and to keep the battery operating at maximum efficiency. You should perform this procedure when you first use your computer and then every few months after that. If you normally leave your Apple portable computer connected to AC power and very rarely use it on battery power you may want to perform this process once a month. The website www.apple.com/batteries has more helpful information regarding batteries and offers an iCal calendar to remind you to calibrate your battery.

Edited by Laura

for batteries of any kind (laptop, phone, camera etc) Ive always followed the rule of allowing it to discharge completely before charging

Battery is still at about 103% after 792 cycles :)

Macbook White Core Duo 1.83GHZ, brought Oct 2006

Used everyday since, 2GB RAM 320GB HDD

picturefjb.jpg

for batteries of any kind (laptop, phone, camera etc) Ive always followed the rule of allowing it to discharge completely before charging

Battery is still at about 103% after 792 cycles :)

Macbook White Core Duo 1.83GHZ, brought Oct 2006

Used everyday since, 2GB RAM 320GB HDD

This is generally good policy; however, with modern Lithium Ion batteries, this is less important. As far as I understand, full charge and discharge cycles are much more important on Nickel Metal Hydride batteries as they can develop a "memory." Lithium Ion batteries, through calibration, can maintain great condition (through a finite cycle count) with partial charge and discharge cycles.

I'm not sure if this link was posted here yet, but Apple's battery page has some good information on this topic.

for batteries of any kind (laptop, phone, camera etc) Ive always followed the rule of allowing it to discharge completely before charging

Battery is still at about 103% after 792 cycles :)

Macbook White Core Duo 1.83GHZ, brought Oct 2006

Used everyday since, 2GB RAM 320GB HDD

picturefjb.jpg

That's almost hard to believe... just too good to be true. I'm not insinuating that you're a liar, it's just... well... I wish my iBook's battery was that good still.

I'm testing out a little theory on the old battery that I have, I chatted with someone who had issues _after_ 10.5.7 was released, apparently the AppleSmartBattery extension has some issues that a lot of people are seeing (as in reduced power, not charging etc).

It's a bit dangerous and tricky so I'll let you know how it goes. :>

i know what you mean, modern batteries shouldn't require these steps, however i believe they do help.

I also know what you mean being hard to believe, it's the reason i stuck a screen shot up there. I might have been incredibly lucky with this battery, however ive managed to get three years out of a compaq pc laptop battery.

i know what you mean, modern batteries shouldn't require these steps, however i believe they do help.

I also know what you mean being hard to believe, it's the reason i stuck a screen shot up there. I might have been incredibly lucky with this battery, however ive managed to get three years out of a compaq pc laptop battery.

Oh no, I wasn't saying they're not required; I was just contrasting the importance of "calibrating" the battery when using a lithium-ion battery as opposed to a nickel metal or nickel cadmium. I can attest to the fact that calibrating a lithium-ion is important if you don't usually fully discharge and recharge your battery. I had a MBP battery die out after about 100 cycles, mainly because I didn't take good care of it. I know better now :)

For camparison, after 16 months mine has gone from an original of 5020 mAh to 4740 mAh and is at 94% health. It's had 120 cycles.

Edit: Just found this article:

http://support.apple.com/kb/HT1490

After following Apple's instructions for calibrating, my battery is now at 96%, or 4849 mAh.

for batteries of any kind (laptop, phone, camera etc) Ive always followed the rule of allowing it to discharge completely before charging

Battery is still at about 103% after 792 cycles :)

...

Your battery capacity went up after you bought it? I guess you got lucky and your battery had more than the standard arbitrary 5020 mAh to start with :p

yep, as hard as it is to believe, my battery actually got better over time. I think the figure used to be higher, im sure i posted it on neowin earlier in the year.

I just get the feeling that one day ill switch on the mac and the battery will just rapidly hit 0% health :)

Interestingly enough, I was able to zap my broken battery back to life with some.. unorthodox methodology, the battery meter now shows 720mAh maximum capacity, yesterday it was 170, 280 and 490 respectively - it seems to be going up every time I completely discharge and re-charge it.

This was the battery with the 61 load cycles and 0% by the way.

I wonder how high it'll go :p

After following Apple's instructions for calibrating, my battery is now at 96%, or 4849 mAh.

Your battery capacity went up after you bought it? I guess you got lucky and your battery had more than the standard arbitrary 5020 mAh to start with :p

Mine has too (ignore the 6 months, it's a new refurb):

Picture%201.png

It's on 97% as I've been using it, it charges to the full 4900.

Well, magic does happen - now a few days of emptying, resting, charging the battery the results are so far;

  Charge Information:
  Charge remaining (mAh):	2051
  Fully charged:	No
  Charging:	No
  Full charge capacity (mAh):	2051
  Health Information:
  Cycle count:	61
  Condition:	Good

For some reason it says not fully charged and the cycle count doesn't go up even if I completely discharge it. Note, this battery was originally 61 mAh max capacity until I zapped it and it keeps going up 50-200mAh on every discharge-charge.

Get a battery that will last you 3+ years, like my battery (sig)

Joking, anyway. If it's wearing out, get apple too look at it (need to go to sleep so haven't read the thread but w/e)

EDIT EDIT: Look's like you solved it. Ignore this post plz :)

Edited by Kirbeh
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • About bloody time. I have got PRs with hundred of files and the Web UI just struggling to even load the pages.
    • I wonder if it was applying secure boot certificates/dbx files?
    • I recently tried edge. It seems a lot better. A lot of the junk in it is gone. It seems less bloated and snappy.
    • Lethal fake phone chargers are still being sold on Amazon and eBay, UK watchdog warns by Paul Hill Credit: Pexels The UK consumer rights organization, Which?, is claiming that “potentially lethal knock-off chargers” are still being sold on online marketplaces seven years after it exposed the danger of these chargers. In its latest investigation, it bought 15 USB phone chargers from several online marketplaces and found they were missing key information, meaning they cannot be legally sold in the UK. Which? bought the 15 chargers from seven online marketplaces. These were Amazon (including Amazon Haul), AliExpress, B&Q Marketplace, Debenhams Marketplace, and eBay. It said that the chargers were so badly made that anyone using them was at risk of electric shock. Over half the chargers also posed fire and explosion risks. Of the chargers purchased, one was a fake Apple USB-C 35W power adaptor charger. To confuse buyers, the box was branded with an Apple logo, but testing found it to be a fake. Further testing picked up arcing sounds after 10 seconds of use, where a current jumps between two parts of the electrical circuit, which can cause fires, explosions, or electric shock. The manufacturers of this particular charger also put modeling clay inside it to make it feel more weighty, robust, and genuine. Not all of the chargers were technically faulty; however, some were missing key packaging, markings, and documentation, meaning they can’t be sold in the UK legally. Which? said that it is now campaigning alongside a coalition of safety groups and businesses for new laws that make online marketplaces responsible for ensuring the safety of products that they choose to list on their websites. It also said the government needs to start using powers under the Product Regulation and Metrology Act, which was adopted last July, to impose safety requirements on online marketplaces via secondary legislation, but so far, there have been delays. No matter what country you are in, be sure to properly research what you are buying and only buy authentic chargers to prevent fires. You can read more about Which?’s research here.
    • Visual Studio finally gets long-awaited feature that developers will love by Usama Jawad Visual Studio Code is Microsoft's popular, lightweight, open-source code editor, it is actually Visual Studio that is the company's flagship integrated development environment (IDE). Although the IDE already offers a boatload of useful features for developers, Microsoft has finally introduced a long-requested capability that will be loved by many. While developers have already been able to create Git pull requests (PRs) directly within Visual Studio for the past couple of years, it had not been possible to review a PR without switching to the browser, until now. Microsoft revealed in December 2025 that it is working on UX that enables developers to do just that, and fast-forward to June 2026, and Visual Studio finally has native capabilities to open and inspect a PR, discuss feedback, and wrap up the review, all without switching to the browser. This integration works for both GitHub and Azure DevOps (including on-prem). Developers have access to multiple surfaces to open a PR, including Git Repository, Git Changes, and the Git menu in Visual Studio. Once you open a PR, all the important details will be immediately visible to you, from where you can navigate to various levels of granularity and branch states, depending on the reviews that you are engaged in. As you would expect, you also get a diff view that enables you to see code changes inline or side-by-side in a separate panel. You can also review commit-by-commit. Additionally, this UX fosters collaboration as you can leave comments, reply to threads, and resolve conversations easily. Naturally, you can also leverage Copilot to apply a code suggestion to fix a potential issue. When you are done, you have the ability to approve, complete, and merge the PR. This is a pretty major feature as it has been requested heavily for the past few years. You can try it out in Visual Studio 2026 version 18.7, made available here recently. Microsoft plans to enhance this experience further in future releases with comment filtering, a timeline of PR activity, and more.
  • Recent Achievements

    • Week One Done
      Timaximus earned a badge
      Week One Done
    • One Month Later
      Timaximus earned a badge
      One Month Later
    • Rookie
      FBSPL went up a rank
      Rookie
    • First Post
      davidbazooked earned a badge
      First Post
    • Week One Done
      davidbazooked earned a badge
      Week One Done
  • Popular Contributors

    1. 1
      +primortal
      499
    2. 2
      PsYcHoKiLLa
      174
    3. 3
      +Edouard
      160
    4. 4
      Steven P.
      84
    5. 5
      ATLien_0
      75
  • Tell a friend

    Love Neowin? Tell a friend!