Battery capacity rapidly decreasing?


Recommended Posts

Are you keeping your Mac plugged in constantly? Have you used the Apple's calibration guide yet? ( http://support.apple.com/kb/HT1490 )

On that note, it could be worse - here's a copy paste from my 2007 MBP broken battery that Apple would not replace because it was bought during the summer and they said it did not match the list of broken batteries even thought it exhibited the *exact* symptoms;

  Charge Information:
  Charge remaining (mAh):	0
  Fully charged:	No
  Charging:	No
  Full charge capacity (mAh):	128
  Health Information:
  Cycle count:	61
  Condition:	Check Battery
  Battery Installed:	Yes
  Amperage (mA):	0
  Voltage (mV):	12303

The battery *died* after 60 cycles - beat that :-) And no, it's no longer in use :-)

150 mAh isn't that much. It could just be due to measurement error.

I will say that my late-2007 MBP battery didn't even get to 80 cycles before it lost most of its capacity. At the end I was barely getting an hour, and that was with everything turned off (WiFi, Bluetooth, etc.) and the brightness all the way down. I wouldn't be surprised if the newer batteries aren't much better.

It depends if those were complete cycles (totally dead to full charge) or just top-up cycles (75%-90% charge to full charge).

Try a couple of complete cycles (let the battery run dead, and then re-charge to full overnight), see if you can 'reset' the battery.

For camparison, after 16 months mine has gone from an original of 5020 mAh to 4740 mAh and is at 94% health. It's had 120 cycles.

Edit: Just found this article:

http://support.apple.com/kb/HT1490

You can calibrate your iBook, PowerBook, MacBook, MacBook Air, or MacBook Pro computer's lithium ion battery for best performance.

The battery has an internal microprocessor that provides an estimate of the amount of energy in the battery as it charges and discharges. The battery needs to be recalibrated from time to time to keep the onscreen battery time and percent display accurate and to keep the battery operating at maximum efficiency. You should perform this procedure when you first use your computer and then every few months after that. If you normally leave your Apple portable computer connected to AC power and very rarely use it on battery power you may want to perform this process once a month. The website www.apple.com/batteries has more helpful information regarding batteries and offers an iCal calendar to remind you to calibrate your battery.

Edited by Laura

for batteries of any kind (laptop, phone, camera etc) Ive always followed the rule of allowing it to discharge completely before charging

Battery is still at about 103% after 792 cycles :)

Macbook White Core Duo 1.83GHZ, brought Oct 2006

Used everyday since, 2GB RAM 320GB HDD

picturefjb.jpg

for batteries of any kind (laptop, phone, camera etc) Ive always followed the rule of allowing it to discharge completely before charging

Battery is still at about 103% after 792 cycles :)

Macbook White Core Duo 1.83GHZ, brought Oct 2006

Used everyday since, 2GB RAM 320GB HDD

This is generally good policy; however, with modern Lithium Ion batteries, this is less important. As far as I understand, full charge and discharge cycles are much more important on Nickel Metal Hydride batteries as they can develop a "memory." Lithium Ion batteries, through calibration, can maintain great condition (through a finite cycle count) with partial charge and discharge cycles.

I'm not sure if this link was posted here yet, but Apple's battery page has some good information on this topic.

for batteries of any kind (laptop, phone, camera etc) Ive always followed the rule of allowing it to discharge completely before charging

Battery is still at about 103% after 792 cycles :)

Macbook White Core Duo 1.83GHZ, brought Oct 2006

Used everyday since, 2GB RAM 320GB HDD

picturefjb.jpg

That's almost hard to believe... just too good to be true. I'm not insinuating that you're a liar, it's just... well... I wish my iBook's battery was that good still.

I'm testing out a little theory on the old battery that I have, I chatted with someone who had issues _after_ 10.5.7 was released, apparently the AppleSmartBattery extension has some issues that a lot of people are seeing (as in reduced power, not charging etc).

It's a bit dangerous and tricky so I'll let you know how it goes. :>

i know what you mean, modern batteries shouldn't require these steps, however i believe they do help.

I also know what you mean being hard to believe, it's the reason i stuck a screen shot up there. I might have been incredibly lucky with this battery, however ive managed to get three years out of a compaq pc laptop battery.

i know what you mean, modern batteries shouldn't require these steps, however i believe they do help.

I also know what you mean being hard to believe, it's the reason i stuck a screen shot up there. I might have been incredibly lucky with this battery, however ive managed to get three years out of a compaq pc laptop battery.

Oh no, I wasn't saying they're not required; I was just contrasting the importance of "calibrating" the battery when using a lithium-ion battery as opposed to a nickel metal or nickel cadmium. I can attest to the fact that calibrating a lithium-ion is important if you don't usually fully discharge and recharge your battery. I had a MBP battery die out after about 100 cycles, mainly because I didn't take good care of it. I know better now :)

For camparison, after 16 months mine has gone from an original of 5020 mAh to 4740 mAh and is at 94% health. It's had 120 cycles.

Edit: Just found this article:

http://support.apple.com/kb/HT1490

After following Apple's instructions for calibrating, my battery is now at 96%, or 4849 mAh.

for batteries of any kind (laptop, phone, camera etc) Ive always followed the rule of allowing it to discharge completely before charging

Battery is still at about 103% after 792 cycles :)

...

Your battery capacity went up after you bought it? I guess you got lucky and your battery had more than the standard arbitrary 5020 mAh to start with :p

yep, as hard as it is to believe, my battery actually got better over time. I think the figure used to be higher, im sure i posted it on neowin earlier in the year.

I just get the feeling that one day ill switch on the mac and the battery will just rapidly hit 0% health :)

Interestingly enough, I was able to zap my broken battery back to life with some.. unorthodox methodology, the battery meter now shows 720mAh maximum capacity, yesterday it was 170, 280 and 490 respectively - it seems to be going up every time I completely discharge and re-charge it.

This was the battery with the 61 load cycles and 0% by the way.

I wonder how high it'll go :p

After following Apple's instructions for calibrating, my battery is now at 96%, or 4849 mAh.

Your battery capacity went up after you bought it? I guess you got lucky and your battery had more than the standard arbitrary 5020 mAh to start with :p

Mine has too (ignore the 6 months, it's a new refurb):

Picture%201.png

It's on 97% as I've been using it, it charges to the full 4900.

Well, magic does happen - now a few days of emptying, resting, charging the battery the results are so far;

  Charge Information:
  Charge remaining (mAh):	2051
  Fully charged:	No
  Charging:	No
  Full charge capacity (mAh):	2051
  Health Information:
  Cycle count:	61
  Condition:	Good

For some reason it says not fully charged and the cycle count doesn't go up even if I completely discharge it. Note, this battery was originally 61 mAh max capacity until I zapped it and it keeps going up 50-200mAh on every discharge-charge.

Get a battery that will last you 3+ years, like my battery (sig)

Joking, anyway. If it's wearing out, get apple too look at it (need to go to sleep so haven't read the thread but w/e)

EDIT EDIT: Look's like you solved it. Ignore this post plz :)

Edited by Kirbeh
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • WSCC - Windows System Control Center 10.0.3.8 by Razvan Serea Windows System Control Center is a free, portable program that allows you to install, update, execute and organize the utilities from various system utility suites. WSCC can install and update the supported utilities automatically. Alternatively, WSCC can use the http protocol to download and run the programs. WSCC is portable, installation is not required. Extract the content of the downloaded zip archive to any directory on your computer. Free for personal use. The setup packages and updates are downloaded directly from their author's website! This edition of WSCC supports the following utility suites: Windows Sysinternals Suite (including support for "Sysinternals Live" service) NirSoft Utilities Mitec and more... WSCC - Windows System Control Center 10.0.3.8 changelog: [NEW] update progress is now visible on the Windows taskbar [FIXED] fixed an issue with the Update dialog [FIXED] minor fixes Download: WSCC (64-bit) | 5.4 MB (Free for personal use) Download: WSCC (32-bit) | 6.3 MB View: WSCC Homepage | Screenshot Get alerted to all of our Software updates on Twitter at @NeowinSoftware
    • The level of stupidity at Google and Microsoft is beyond belief. All they are doing by killing this is forcing people to jump over to Firefox and ditch them all together, therefore giving Firefox the market boost it needs to finally crush them all in the end.
    • HWMonitor 1.64 by Razvan Serea HWMonitor is a hardware monitoring program that reads PC systems main health sensors : voltages, temperatures, fans speed. The program handles the most common sensor chips, like ITE® IT87 series, most Winbond® ICs, and others. In addition, it can read modern CPUs on-die core thermal sensors, as well has hard drives temperature via S.M.A.R.T, and video card GPU temperature. Special hardware monitors such as abit® uGuru and Gigabyte® ODIN™ power supplies serie are supported too. HWMonitor 1.64 changelog: Intel Arc G3 & G3 Extreme (Panther Lake). Intel Core Ultra 5 250KF Plus (Arrow Lake Refresh). AMD Ryzen 7 7700X3D (Raphael). AMD Ryzen AI Max+ 495, 492, 488 (Gorgon Halo). AMD Ryzen AI Max 490, 485 (Gorgon Halo). AMD Ryzen AI Max PRO 495, 490, 485, 480 (Gorgon Halo). AMD Ryzen 9 9950X3D2 (Granite Ridge). AMD Ryzen 9 PRO 9965X3D, PRO 9945 (Granite Ridge). AMD Ryzen 7 PRO 9755, PRO 9745 (Granite Ridge). AMD Ryzen 5 PRO 9645 (Granite Ridge). AMD Ryzen AI 7/PRO 450G/GE (Gorgon Point 2). AMD Ryzen AI 5/PRO 440G/GE (Gorgon Point 2). AMD Ryzen AI 5/PRO 435G/GE (Gorgon Point 3). Support of HUDIMM and HSODIMM memory modules. New themes. New real-time graphs. Download: HWMonitor 1.64 | 3.4 MB (Freeware) Download: Portable HWMonitor 1.64 | 2.7 MB View: HWMonitor Homepage | Screenshot Get alerted to all of our Software updates on Twitter at @NeowinSoftware
    • I have had a request since 2017 and so have many others that requested too and nothing has been done about it except its on our list to do.
    • I think it might be behind the trailer park amusements?
  • Recent Achievements

    • One Month Later
      Clizby earned a badge
      One Month Later
    • One Month Later
      Timaximus earned a badge
      One Month Later
    • Week One Done
      Timaximus earned a badge
      Week One Done
    • Rookie
      FBSPL went up a rank
      Rookie
    • First Post
      davidbazooked earned a badge
      First Post
  • Popular Contributors

    1. 1
      +primortal
      497
    2. 2
      PsYcHoKiLLa
      172
    3. 3
      +Edouard
      163
    4. 4
      Steven P.
      86
    5. 5
      ATLien_0
      77
  • Tell a friend

    Love Neowin? Tell a friend!