PC to TV HD Wireless Streaming - Need Advice Please


Recommended Posts

This link sums up my issues.

I quoted the info for you...

I have looked at several posted solutions and configuration settings. I'm stumped.

I am currently using a CGD24G netgear wireless hi-speed cable router, a windows 7 PC (very fast gaming computer - i7 overclocked) with serviio installed, and a brand new Samsung UN40EH5300 TV.

I have tried this solution, and this solution, to no avail. Also done alot of trial and error with the settings. I am currently using the default config for profile "Samsung TV / player (C/D/E-series)."

What happens is with every other file, the video play is great - I can even fast forward and rewind to some extent. But with MKV the stream stutters and I get "loading..." every ten seconds or so. I just can't figure it out. Please halp! lol.

Update: I let a movie (Avatar.mkv) run for a little while through the stuttering. About 5 minutes in, the periods between "loading..." increase and It becomes somewhat watchable. But then about 20-30 minutes into it, I get disconnected with this message "device disconnected device:serviio." My router has "transmission speeds of up to 54Mbps." Are these problems because my router simply isn't fast enough?

The disconnects happen even if I am not watching an mkv file. Any ideas on all this?

I was wondering if I should get a new wireless modem (or if this is a more elusive issue). I think I need dual band to stream mkv files this large. Any suggestions?

I'd say definitely get and 'N' router, preferably dual-band. Just because your router would be dual-band doesn't mean your device would be, so keep that in mind. The best solution, if it's possible, would be to wire it.

I'd say definitely get and 'N' router, preferably dual-band. Just because your router would be dual-band doesn't mean your device would be, so keep that in mind. The best solution, if it's possible, would be to wire it.

I can't really wire it because it's too far away and it would look really, really tacky. I also plan on adding more wireless devices around the apartment later.

So, I guess I am looking for a wireless modem (by that I mean a single piece of hardware that acts as both modem and wireless router) with these abilities:

  • 300+ MB/S Transfer Rate
  • Dual Band
  • QoS, or WMM abilities

Any ideas on a specific model? Id pay $100-150 if I could find a good one.

  • 2 weeks later...

i seen the described issue with that file type across a wide range of networks and equipment. so it ended up being a player/codec issue. i have worked with streaming video to av equipment since 2002 and am still not happy with wireless. wired is still the best way to go to your tv.

i have worked with streaming video to av equipment since 2002 and am still not happy with wireless. wired is still the best way to go to your tv.

+1

I tried to get my XBox 360 and my Western Digital box to work properly over N but never got good enough results. Ended up using a powerline ethernet setup and they work great now.

"I can't really wire it because it's too far away and it would look really, really tacky"

So the run would be longer than 100 meters? That is one freaking Large HOUSE!! So you thinking wireless is going to cover that distance?

As to tacky? You put a jack on the wall, and then run the cable up into the attic or down into the basement or crawlspace and then up/down into the room you need it and then another jack on the wall.

How does that look tacky?

Even if you don't have access to attic or basement, running it under baseboards along the walls works too. How is something you don't see tacky? Now sure if your going to lay the cable across the middle of the floor that would be tacky ;)

If you don't have the skills to do such a thing? Have a buddy that does, supply the beer or hire someone to do it. If you don't have the right to put holes in walls, etc. Then use a powerline adapter vs wireless.

Wireless is for mobile devices, not stationary devices.

First, Wireless N will not get you the speeds you want for flawless HD streaming. Especially with larger files that some of us use.

If you can not directly hard wire them together, your best option will be this - https://www.google.com/search?q=powerline+adapter&ie=utf-8&oe=utf-8&aq=t&rls=org.mozilla:en-US:official&client=firefox-a

I am using a brand of powerline adapters from Netgear. They work perfectly for streaming HD content over large distances. You just plug 1 adapter in near your router and run a ethernet cord into it. Then you plug in the other adapter near your TV/PS3/Whatever and run an ethernet cable from it into your device.

If the wiring is just somewhat decent in your house, you should get speeds that are basically the same as if you were hard wired into your modem/router.

It's a little pricey, but they work perfectly, at least for me. I stream 18gb 1080p movies all the time, and never once had an issue with it.

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • Linux 7.2's first release candidate gets off to a good start by Paul Hill Credit: Larry Ewing It has been a few weeks since the release of Linux 7.1, and in that time, the Linux 7.2 merge window has been open, where developers can submit their features and patches ready for the upcoming release. That window is now shut, and the release candidate phase has begun so that new features can be tested and further fixes applied. According to the founder of Linux, Linus Torvalds, this week’s release candidate looks “reasonably normal”. Although we are super early in the release candidates, this is a good sign as it makes it more likely that an eighth release candidate will not be needed. Torvalds even mentioned that the update’s stats are only larger than they really are because there was another AMD header drop with a third of the patch just being AMD GPU register definitions, which aren’t big changes but make the code contributed look larger overall. In addition to this, he noted that just over half the patch is drivers, even when excluding the AMD register dump. The rest of the changes are spread out over architecture updates, tooling, documentation, and core kernel updates. In the next week, Torvalds says that he will be chilling out, taking the week “mostly off”. Despite this, he will be reading emails and keeping up with things, so if he is slow responding, now you know why. He said he is hoping for a calm week, but we will just have to see if the second release candidate is actually like that. We should expect seven or eight release candidates before Linux 7.2 is released, so expect it around the end of August. If you missed it a few weeks ago, be sure to check out our coverage of Linux 7.1's release.
    • Ridiculous claim that the labor cost difference of $6000 annually would increase cost per phone by $200. The employees produce 3 phones per month or what?
    • Sparkle 2.20.1 by Razvan Serea Sparkle is a free, open-source Windows optimization tool designed to make your PC faster, cleaner, and more private. With Sparkle, you can easily debloat Windows by removing unnecessary apps and services, disable Microsoft tracking to enhance privacy, and apply performance tweaks to boost speed. Its cleaner removes junk and temporary files, while every change is safe and fully reversible. Sparkle also features a modern, user-friendly interface with automatic updates, making system maintenance simple. Explore over 39 tweaks, from disabling telemetry and hibernation to optimizing network and game settings, all aimed at customizing and enhancing your Windows experience. Sparkle supports Windows 10 and 11. Sparkle 2.20.1 changelog: You can now change the Animation Direction from Up, Left, or Off. Added configurable animation direction (Up, Left, Off) for improved accessibility Added TTL caching to the system info backend Refactored tweak application flow to await NvidiaProfileInspector Improved IPC listener cleanup to correctly remove specific listeners Fixed online status not updating after successful network requests Updated system info tests to support backend caching Removed electron-toolkit utils dependency in favor of internal is.dev helper Fixed unwanted files and folders being included in application bundles Download: Sparkle 2.20.1 | Portable | ~100.0 MB (Open Source) Links: Sparkle Website | Github | Screenshot Get alerted to all of our Software updates on Twitter at @NeowinSoftware
    • Never used the G7 Pro, but I've never had a good experience with that style of d-pad and fighting games.
    • And I just bought a seat cushion for my mesh chair. The chair feels nice but the first time I sat in it with boxers, I realized I don't like the feel of mesh on my legs. 😂
  • Recent Achievements

    • One Month Later
      JKR earned a badge
      One Month Later
    • Dedicated
      Asgardi earned a badge
      Dedicated
    • Conversation Starter
      jessse3334 earned a badge
      Conversation Starter
    • Reacting Well
      JuvenileDelinquent earned a badge
      Reacting Well
    • One Month Later
      Excellence2025 earned a badge
      One Month Later
  • Popular Contributors

    1. 1
      +primortal
      496
    2. 2
      +Edouard
      250
    3. 3
      PsYcHoKiLLa
      154
    4. 4
      Steven P.
      86
    5. 5
      macoman
      65
  • Tell a friend

    Love Neowin? Tell a friend!