Recommended Posts

An Indiana man was at Bill Goodman's Gun And Knife Show in Dayton Saturday and decided to purchase a holster for his handgun. The 50-year-old, a conceal carry permit holder, proudly took his new holster out to the parking lot, got in his car, and went to holster his gun...

And promptly shot himself. :|

The Indiana man was rushed to a nearby hospital, where sources say the bullet fatally wounded a finger on his left hand. They will not be able to reattach the finger.

Local police say they will not file any charges. The man was not identified, for obvious reasons.

source

Link to comment
https://www.neowin.net/forum/topic/1138466-man-buys-gun-holster/
Share on other sites

An Indiana man was at Bill Goodman's Gun And Knife Show in Dayton Saturday and decided to purchase a holster for his handgun. The 50-year-old, a conceal carry permit holder, proudly took his new holster out to the parking lot, got in his car, and went to holster his gun...

And promptly shot himself. :|

The Indiana man was rushed to a nearby hospital, where sources say the bullet fatally wounded a finger on his left hand. They will not be able to reattach the finger.

Local police say they will not file any charges. The man was not identified, for obvious reasons.

source

And you wonder how many more idiots like this goes unreported.

2 things wondering what kind of holster and he should have had the safety on. I am assuming its a hard case holster.

I am curious what pistol it was. However not all pistols have a safety. None of mine do. If he was trying to figure out if it fit, then he should have unloaded it, and then did it. Or if he did that already and was putting it back in, then he shouldn't have had his finger on the trigger or anywhere near the trigger/ trigger guard.

I am curious what pistol it was. However not all pistols have a safety. None of mine do. If he was trying to figure out if it fit, then he should have unloaded it, and then did it. Or if he did that already and was putting it back in, then he shouldn't have had his finger on the trigger or anywhere near the trigger/ trigger guard.

My .40 S&W doesn't have a safety but it has a heavy trigger. U remember there being a recall a couple years ago on a certainodel police holster what would happen was the plastic strap would slip down and into the trigger guard causing a discharge. I remember hearing a couple of cops being wounded by it. They made a recall and by that I mean you switched the plastic strap for a cloth one after you payes for it.

2 things wondering what kind of holster and he should have had the safety on. I am assuming its a hard case holster.

There are plenty of firearms that have no safety, the safety lies in a double action trigger and a long trigger pull.

My firearm has no safety, but I'd be hard-pressed to let it go off inadvertently as it is rates at 6 pounds trigger pull. I'd be willing to bet this guy had a hair trigger single-action pistol.

There is a picture on the Blog that shows a pistol with a safety, but I doubt that is the weapon this guy used.

There are plenty of firearms that have no safety, the safety lies in a double action trigger.

My firearm has no safety, but I'd be hard-pressed to let it go off inadvertently as it is rates at 6 pounds. I'd be willing to bet this guy had a hair trigger single-action pistol.

Most revolvers do not have a safety, like you said double action. My .357 does not have one.

My SIG Sauer P250sc has no safety being a double action automatic, but as others have said the pull is relatively heavy at 6+ pounds and that trigger has to move almost all the way back to fire - a long travel.

Double actions are not carried cocked (the firing pin or hammer under spring tension) as the long trigger pull does that when you go to shoot. Many such firearms also have an interlock that prevents the firing pin from moving until the trigger is all rhe way back to the release point. You could smack the thing with a hammer and it wouldn't go off. A built-in safety without a lever.

My guess is that this guy had a single action automatic and carried it cocked. In that state. If the safety lever is accidentally released the trigger then needs little pressure to release - IMO an accident looking for a place to happen.

Earlier model Glocks had a problem with accidental discharge, to the point where Detroit area PD officers started referring to the injury as "Glock Leg," a term still in common use in this area.

Hum,

With automatics carrying one in the chamber isn't unusual, it's pretty much normal for cops and concealed defensive carry as you may not have time to cycle the slide to load a round.

The question is if the firearm has the necessary passive safety interlocks and if it has a double action trigger for that first shot. Double action only (DAO) pistols obviously do, Many single action pistols also have double action for the first shot and single action thereafter (DA/SA).

IMO only these automatic actions should be used for concealed carry, and indeed many police departments and some federal agencies require them - many going DAO only.

For revolvers the proper technique is an empty chamber under the hammer, or a revolver with a between the chambers rest position - something that's been around since at least the Remington New Model Army of 1858 (I have one.)

Turkish: F**k me, hold tight. What's that?

Tommy: It's me belt, Turkish.

Turkish: No, Tommy. There's a gun in your trousers. What's a gun doing in your trousers?

Tommy: It's for protection.

Turkish: Protection from what? Zee Germans? What's to stop it from blowing your b******s off every time you sit down?

This topic is now closed to further replies.
  • Posts

    • This is listed as a preview in WU for me. I usually don't grab them as previews; what's your opinion on it so far?
    • Pale Moon 34.3.1 by Razvan Serea Pale Moon is an Open Source, Goanna-based web browser available for Microsoft Windows, Linux and Android, focusing on efficiency and ease of use. Make sure to get the most out of your browser! Pale Moon offers you a browsing experience in a browser completely built from its own, independently developed source that has been forked off from Firefox/Mozilla code, with carefully selected features and optimizations to improve the browsers speed, resource use, stability and user experience, while offering full customization and a growing collection of extensions and themes to make the browser truly your own. Features: Optimized for modern processors Based on proprietary optimized layout engine (Goanna) Safe: forked from mature Mozilla code and regularly updated Secure: Additional security features and security-aware development Supported by our user community, and fully non-profit Familiar, efficient, fully customizable interface Support for full themes: total freedom over any elements design Support for easily-created lightweight themes (skins) Smooth and speedy page drawing and script processing Increased stability: experience fewer browser crashes Support for many Firefox extensions Support for a growing number of Pale Moon exclusive extensions Extensive and growing support for HTML5 and CSS3 Many customization and configuration options Pale Moon 34.3.1 changelog: Pale Moon will now exclude local resources from CSP checks, aligning it with the rest of CSP handling. Fixed an issue where the devtools JSON viewer would, in some cases, make erroneous requests to remote servers. Updated libpng to 1.6.58+apng. Updated NSS to 3.90.12 (UXP), addressing multiple security issues. Fixed several intermittent and rare crashes. Security issues addressed: CVE-2026-12318 (CWE-125), CVE-2026-12322, CVE-2026-12292 (DiD), and multiple other issues that did not have a CVE designation at the time of patching. Download: Pale Moon (64-bit) | Portable 64-bit | ~40.0 MB (Freeware) Download: Pale Moon (32-bit) | Portable 32-bit Links: Pale Moon Homepage | Add-ons | Themes | Extensions | Screenshot Get alerted to all of our Software updates on Twitter at @NeowinSoftware
    • Onwards to Windows 12 then lol.
    • There is a long thread (128pgs and counting) that I've been following over at ElevenForums that has a method for updating Secure Boot even if there is no BIOS upgrade. I've used this method and had zero issues. NOTE:  I do not take any responsibility if this or any other Secure Boot method bricks your system -- YMMV!  Read carefully before using!
  • Recent Achievements

    • Grand Master
      Jaybonaut went up a rank
      Grand Master
    • One Year In
      Philsl earned a badge
      One Year In
    • Dedicated
      Scoobystu earned a badge
      Dedicated
    • First Post
      Tom Schmidt earned a badge
      First Post
    • One Month Later
      D0nn13 earned a badge
      One Month Later
  • Popular Contributors

    1. 1
      +primortal
      425
    2. 2
      +Edouard
      177
    3. 3
      PsYcHoKiLLa
      124
    4. 4
      Michael Scrip
      77
    5. 5
      Xenon
      76
  • Tell a friend

    Love Neowin? Tell a friend!