Recommended Posts

On 18/11/2023 at 16:15, Xenon said:

I have to say it did go better than I thought it would. The explosion of the booster was quite impressive. I figure the next attempt in 2 to 4 months. 

Baldrick else said it far better than I could... ;) 

 

 

  • Haha 2
On 19/11/2023 at 14:56, anthdci said:

interesting tweet about the front of the starship separating after the FTS

 

https://x.com/astroferg/status/1726002014918705581?s=20 

The FTS charges are near the common and upper domes. Having the nose cone detach after the upper charge goes off is not a surprise.

On 20/11/2023 at 02:15, DocM said:

The FTS charges are near the common and upper domes. Having the nose cone detach after the upper charge goes off is not a surprise.

I'd agree, but it's a single large piece of debris that could cause some damage. Obviously no charge is going to make something so big turn completely into tiny pieces, but it's certainly something the FAA will be asking about before the next one. 

On 20/11/2023 at 04:48, anthdci said:

I'd agree, but it's a single large piece of debris that could cause some damage. Obviously no charge is going to make something so big turn completely into tiny pieces, but it's certainly something the FAA will be asking about before the next one. 

That's not really the purpose of the FTS as far as FAA is concerned. It's purposes are,

1) to terminate engine thrust, and

2) unzip the tanks to disperse propellants (95+% of vehicle mass at liftoff).

The Notice to Mariners and Notice to Airmen give a pre warning to avoid areas under the flight path which could have falling debris. 

The nose cone was only a few seconds from achieving orbit when the FTS fired, and traveling about 22,000 kph. It's very UNlikely it was able to stay together due to aerodynamic and thermal forces. The debris field was Northeast of the Turks.

Edited by DocM

I would guess that the cause of the booster failure was fuel sloshing, probably just need to change the flight profile for the boost back. Should be a quick turn around.

The Starship is probably a bigger issue. Looks like a LOX leak, with where it was when it went boom, might not have a lot of telemetry of what went wrong.

On 21/11/2023 at 22:17, IsItPluggedIn said:

I would guess that the cause of the booster failure was fuel sloshing, probably just need to change the flight profile for the boost back. Should be a quick turn around.

The Starship is probably a bigger issue. Looks like a LOX leak, with where it was when it went boom, might not have a lot of telemetry of what went wrong.

 

Starship and Booster are  both equipped with Starlink, allowing communications even when out of sight of a ground station. 

Starlink is also going into Dragon, the upcoming Polaris Dawn Crew mission testing the use of Starlibj instead of NASA's telemetry network. It'll be going into the lower Van Allen belt, and the crew will come down to 500 km for a few spacewalks.

  • Like 1

Starship 2

There are four remaining Starships to be tested; Ships 28, 29, 30, and 32. Ship 31 has been moved to the Starbase Rocket Garden for display.

Subsequent Ships will be a new configuration, Starship 2. 

Expect significant upgrades.

 

 

 

On 27/11/2023 at 17:32, DocM said:

Starship 2

There are four remaining Starships to be tested; Ships 28, 29, 30, and 32. Ship 31 has been moved to the Starbase Rocket Garden for display.

Subsequent Ships will be a new configuration, Starship 2. 

Expect significant upgrades.

 

 

 

going to be interesting what they do. If they stretch it to give bigger tanks to feed the extra 3 vacuum raptors that will probably make it too tall for the chopsticks to grab it in the same location as the V1. Either the tower will need to be taller or the mounting point needs to relatively lower down starship.

  • Like 2
On 28/11/2023 at 04:50, anthdci said:

going to be interesting what they do. If they stretch it to give bigger tanks to feed the extra 3 vacuum raptors that will probably make it too tall for the chopsticks to grab it in the same location as the V1. Either the tower will need to be taller or the mounting point needs to relatively lower down starship.

There has been talk about the forward fins being relocated, so the attach points may also be moving. They may also extend the height of the tower. We'll just have to wait and see.

Air Force Rocket Cargo Program via C4ISR.net, a defense and military oriented news site.

Rocket Cargo is a US military project to transport large amounts of cargo within an hour. SpaceX as a contract to use Starship to test the concept.

C4ISR = Command, Control, Communications, Computers (C4) Intelligence, Surveillance and Reconnaissance (ISR).

C4ISR.net...

Quote

Will Rocket Cargo work? Data collected in 2024 may hold the answer.

WASHINGTON — The U.S. Department of the Air Force’s effort to one day launch equipment halfway around the world via space-bound rockets will go through a series of test flights in 2024 that could reveal whether the concept would even work.

>

Next year, he said, the Air Force also plans to have a cargo bay mockup — basically the upper half of a Starship — it can use to refine the techniques for rapidly loading and unloading 20-foot containers from a rocket. That mockup is now in the final stages of construction by the engineering firm SES in Alliance, Ohio.

And by 2026 — though Spanjers said it could be done by 2025 — the Air Force expects the Rocket Cargo program to demonstrate the ability to rapidly launch rockets, bring large masses of cargo down from orbit, and rapidly load and unload cargo.

>

 

On 09/12/2023 at 04:25, FloatingFatMan said:

Yeah.. I just love the way it exploded all over the place...

Twice.

:p

Tomatoes from the peanut gallery, again.

The process is iteration. One milestone at a time, just like they did when they were developing reusable rockets. 

Since they figured out the magic sauce recipe they have landed over 250 of them.

The first Starship launch was to determine if the pad could survive the environment. Any data acquired after that was gravy. It didn't survive, so they fixed it and moved on to the next milestone. The flight termination system did not work as expected, so they fixed it too. NASA considered the test successful. Things were learned.

The FAA investigation? SpaceX conducted it, not FAA.

The second one was about getting through hot staging, a method not used much outside of Russia. It  succeeded. So did the new  flight termination system. In this case the gravy was Starship getting within 8 seconds of achieving orbit. NASA also considered this  test a success.

Flight 3 will have a different set of milestones.  Even if they are met someone will find a problem with it. SSDD.

 

Edited by DocM
  • Like 3

Starbase is getting a 2nd Starship Tower

Tower segments are already on a barge, destination Texas.

Full text

Quote

Also, the purpose of adding additional towers US 8to support the launch cadence required for the Artemis missions. It is not to create a catch only tower.

In order to catch a booster, a launch mount is needed to place the booster back down and safe the vehicle. There will be residual fuel in the tanks (even if its only fumes) and this will need to be purged with nitrogen provided by the OLM in order to safe the vehicle after landing.

It can not be placed directly onto a transport stand.

 

On 17/12/2023 at 07:25, anthdci said:

obviously they know what they are doing, but if they are stretching starship then it would have made sense for any new towers to be taller to accommodate that.

The catch arms grab pins on either side of the booster or ship. Those pins can be moved to a lower location to accommodate a longer vehicle. 

If at some time this relocation poses a problem (balance, etc) they can take the top off the tower and add another segment; they were built using modules. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Posts

    • WildBit Viewer 6.20 released; no further updates planned by Razvan Serea WildBit Viewer is a popular, fast, and extensive image viewer offering a comprehensive suite of tools for photographers, designers, and image enthusiasts. It includes a powerful Viewer, Slide Show, Editor, Search, Profile Switcher, and Multi-Screen Viewer. The Viewer provides blazing-fast folder, file list, and thumbnail navigation with customizable headers, full-screen view, and a shell toolbar to organize favorite folders. It supports all major graphic formats (over 70), including JPEG, TIFF, PNG, BMP, GIF, PCX, TGA, and RAW formats. Detailed Image Info shows EXIF, IPTC, and XMP metadata, with rotation based on EXIF orientation, wallpaper setting, image comparison, geo-tag viewing, color labels, and CMS-aware color management. The Slide Show module offers 176 transition effects, multi-monitor support, custom shows with per-image settings, image marking, zoom, rotate, and desktop hiding for a professional viewing experience. The Editor supports advanced image manipulation, including crop, resize, color adjustments, curves, edge detection, effects, batch processing, retouching, layer support, and printing. Users can apply mass renaming, update or clear metadata, and work with multi-page TIFFs and animated GIFs. Search allows filtering by name, location, date, size, attributes, and metadata, while the Profile Switcher saves and loads custom layouts for all modules. The Multi-Screen Viewer opens multiple windows on available monitors, allowing simultaneous image viewing with independent zoom, pan, and rotation. WildBit Viewer also supports portable operation, 32- and 64-bit versions, Unicode, high-DPI displays, and multiple Windows styling options. With its combination of speed, versatility, and rich feature set, WildBit Viewer is an indispensable tool for managing, editing, and showcasing images efficiently. WildBit Viewer key features: Blazing-fast folder, file list, and thumbnail browsing Supports 70+ image formats including JPEG, TIFF, PNG, BMP, GIF, and RAW Full-screen view with multi-monitor support Explorer-style file handling with customizable headers Thumbnail Browser with sorting, view change, and fast size adjustment EXIF, IPTC, and XMP metadata viewing and editing Automatic rotation based on EXIF orientation Shell toolbar for organizing favorite folders Image Compare to calculate similarity between images Mass renaming and batch metadata updates File List Generator (HTML, CSV, RTF, TXT, Unicode) Rating and color labels, CMS-aware color management Video playback (AVI, MPG, MPEG, WMV) Animated GIF, multipage TIFF, Camera RAW support Slide Show with 176 transition effects and custom settings Editor: crop, resize, rotate, flip, canvas resize, and retouching tools Batch processing and image format conversion Multi-Screen Viewer: multiple windows with independent zoom, pan, and rotate Profile Switcher: save, load, reset, delete module profiles Portable operation, 32-/64-bit support, Unicode, and high-DPI ready WildBit Viewer 6.20 changelog: Viewer, Slide Show, Editor, Search, Profile Switcher & Multi Screen Viewer. Updated ImageEn to 15.0.0 version. Viewer, Slide Show, Editor, Search, Profile Switcher & Multi Screen Viewer. Updated Jedi JCL&JVCL. Viewer - Image Geo Info, OpenStreetMap removed. Slide Show Remote Mode removed. Note! This means that WildBit Slide Show Remote is now officially EOL. Editor - Shortcut keys for Capture removed. Optimized code. Note! This version includes help what supersedes all previous releases. plus Lots of bug fixes and changes, check Readme files for details. WildBit Viewer End‑of‑Life WildBit Viewer has reached its final release with version 6.20. As development comes to a close, no further feature updates are planned. WildBit Slide Show Remote reached End-of-Life on 06 June 2026, while WildBit Viewer will reach End-of-Life on 30 June 2026. Downloads will remain available until the end of July 2026 (possibly extending into early August). After End-of-Life, the software will no longer receive updates, security fixes, or technical support. Download: WildBit Viewer 64-bit | Portable 64-bit | ~70.0 MB (Freeware) Download: WildBit Viewer 32-bit | Portable 32-bit Links: WildBit Viewer Homepage | Screenshot Get alerted to all of our Software updates on Twitter at @NeowinSoftware
    • Thanks for liking it! 😊 That's Arch Linux with Gnome.
    • LOL. Can't even quote and edit a comment correctly. Figures you're a Linux user.
    • It won't perform hugely better than the 3080 unless you're VRAM limited in games. Have you tried putting new thermal pads on them 3080 and giving it a good clean to see if you can regain your temps and overclock?
  • Recent Achievements

    • Week One Done
      Windows Guy earned a badge
      Week One Done
    • Dedicated
      Mark Spruce earned a badge
      Dedicated
    • Collaborator
      conkir earned a badge
      Collaborator
    • Rising Star
      olavinto went up a rank
      Rising Star
    • One Month Later
      lamborghiniv10 earned a badge
      One Month Later
  • Popular Contributors

    1. 1
      +primortal
      479
    2. 2
      PsYcHoKiLLa
      252
    3. 3
      Steven P.
      71
    4. 4
      FloatingFatMan
      69
    5. 5
      +Edouard
      69
  • Tell a friend

    Love Neowin? Tell a friend!