Recommended Posts

On 17/12/2023 at 22:37, DocM said:

The catch arms grab pins on either side of the booster or ship. Those pins can be moved to a lower location to accommodate a longer vehicle. 

If at some time this relocation poses a problem (balance, etc) they can take the top off the tower and add another segment; they were built using modules. 

And the arms catch only the booster or the starship not both still attached. So I think the height of the tower is not a real issue at the moment.

On 18/12/2023 at 04:03, SteveL said:

And the arms catch only the booster or the starship not both still attached. So I think the height of the tower is not a real issue at the moment.

The arms need to reach high enough to stack a Starship atop the Booster before launch. We already know there will be a longer Starship, be it Starship v2 or the Artemis Depot.

 

Pre-launxh testing for Flight 3 has begun,

 

there were a lot of well known improvements between test flight 1 and test flight 2. I am seeing less upgrades between the vehicles used for 2 compared to 3. Is there much information about there about what is new?

On 20/12/2023 at 16:02, anthdci said:

there were a lot of well known improvements between test flight 1 and test flight 2. I am seeing less upgrades between the vehicles used for 2 compared to 3. Is there much information about there about what is new?

I haven't seen much, but I would expect there would be some improvements inside the tanks that we won't see.

I didn't realize this, but apparently this ship has a payload door.

 

 

On 20/12/2023 at 16:02, anthdci said:

there were a lot of well known improvements between test flight 1 and test flight 2. I am seeing less upgrades between the vehicles used for 2 compared to 3. Is there much information about there about what is new?

 

As mentioned by bguy_1986, the payload bay and internal changes. Also the that Starship will have a major upgrade to Starship 2 after the nexr few launches. Major structural changes, so why upgrade an evolutionary dead end? Rumors of changes to the fins, etc, and a statement from Musk the dry mass would be going down at the same time the tanks will be getting larger. 

Speculation: this seems to make sense if SpaceX will be using the new HFS* steel alloy Cybertruck is introducing. It took CT's door panels down from 3 mm to 1.8 mm without sacrificing strength.

* Hard Fracking Steel

 

  • Like 1
On 21/12/2023 at 22:12, DocM said:

Testing over for the day, and two new tanks and a Starship launch tower segment has departed KSC for Starbase

 

 

Do we know what happened? Looked like a lot of venting when it should have been filling, was something broken?

On 22/12/2023 at 11:47, anthdci said:

Do we know what happened? Looked like a lot of venting when it should have been filling, was something broken?

They did a lot of work on the tank farm to fuel the rocket. Maybe it was something with that. Although they did have a drone checking out a section of the booster. 

Ship: single-engine static fire, looked like a previous test of a de-orbit burn.

Booster: long static fire, about 10 seconds.

If all the data looks good, and the regulatory gods smile on them, Flight 3 could be really close. 

  • Like 1

Next steps for Starship, and Musk will be giving a SpaceX company talk which will be webcast on X. 

Long post, so full text at bottom

Quote

Overnight Ship 30 rolled to SpaceX's Masseys test site, joining Booster 12 for cryoproofing

 

As it stands:


Booster 10/Ship 28 - tested through to Static Fires. Next up, flight configuration work (likely at prod site), then rollout for integrated stack pre-launch testing.

 

Booster 11/Ship 29 - Cryoproofed, receiving engines, then ready for Static Fire testing.

 

Booster 12/Ship 30 - At Masseys for cryoproof testing.

 

Are you all ready for 2024? 😎

 

Edited by DocM
  • 3 weeks later...

From the recent SpaceX All Hands company meeting,

The causes of the Fight 2 failures are now known. The Booster flip was too rapid, and Ship's liquid oxygen venting caused a fire.  They know how to fix both.

The upcoming Flight 3 will  attempt to achieve orbit, perform an orbital refueling system test, and test a Starlink satellite deployment door. The new Starlink satellites will be much more powerful, further speeding up the network.

After Flight 3, a second Starship launch complex will be built at Starbase. A tower segment is already on the way by barge from the Kennedy Space Center SpaceX Operations Area in Florida.

The new tower will be taller to accommodate an increase in size of Starship V3, the upcoming Starship V2 being a transition vehicle.

Booster + Ship height,

Starship V1: 121 m

Starship V3: up to 150 m

After Tower 2 is complete, Tower 1 will be upgraded. 

------

Starship launch complexes in Florida are already in the approval process (LC-49), LC-39a being partially built. Wouldn't be surprised to see some at Vandenberg Space Force Base in California, probably at SLC-6 (aka Slick Six)

20240114_150733.thumb.jpg.81a34783c14599f4d5aa3fbc20c714aa.jpg

 

 

  • Like 3
On 14/01/2024 at 20:51, DocM said:

From the recent SpaceX All Hands company meeting,

The causes of the Fight 2 failures are now known. The Booster flip was too rapid, and Ship's liquid oxygen venting caused a fire.  They know how to fix both.

The upcoming Flight 3 will  attempt to achieve orbit, perform an orbital refueling system test, and test a Starlink satellite deployment door. The new Starlink satellites will be much more powerful, further speeding up the network.

After Flight 3, a second Starship launch complex will be built at Starbase. A tower segment is already on the way by barge from the Kennedy Space Center SpaceX Operations Area in Florida.

The new tower will be taller to accommodate an increase in size of Starship V3, the upcoming Starship V2 being a transition vehicle.

Booster + Ship height,

Starship V1: 121 m

Starship V3: up to 150 m

After Tower 2 is complete, Tower 1 will be upgraded. 

------

Starship launch complexes in Florida are already in the approval process (LC-49), LC-39a being partially built. Wouldn't be surprised to see some at Vandenberg Space Force Base in California, probably at SLC-6 (aka Slick Six)

20240114_150733.thumb.jpg.81a34783c14599f4d5aa3fbc20c714aa.jpg

 

 

big changes in the pipeline. It's already an insane size, when it's 150m it'll be evenmore so. 

  • Like 3
On 15/01/2024 at 15:59, anthdci said:

big changes in the pipeline. It's already an insane size, when it's 150m it'll be evenmore so. 

The fast pace helps the 'failing forward' process, which is why they have moved so far ahead with reusability. Ditto for Tesla EV development.

Many people don't seem to get this. Those folks need to read John C. Maxwell's book.

  • Like 3
  • 3 weeks later...

New Starship tower segments at KSC, to be shipped to Starbase where a second launch site is being prepared. Needed for redundancy and an increased flight rate. Tower will also be taller to accommodate the larger Starship V2 & V3. The existing Tower will also be stretched.

 

 

  • Like 2

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Posts

    • [Price Drop] PDF Expert for Mac v3 is still half off by Steven Parker Today's highlighted deal comes via our Apps + Software section of the Neowin Deals store, where for only a limited time you can save 42% on PDF Expert One-Time Purchase. PDFs remain the best way to transmit documents, but editing them isn't possible with standard Mac software. PDF Expert changes that, allowing you to edit PDF text, images, links, and outlines quickly and easily. Typo in a contract? Easy fix. Need to rework a complete section of a document? No problem. PDF Expert provides a series of essential functions that will transform the way you work with documents on your Mac. It recognizes text and OCR, makes edits, and fills out forms. And with the “Enhance” feature powered by AI, it will fix distortions, remove shadows and improve contrast so that even difficult-to-read documents look great. EDIT Change the text. Easily fix typos, update numbers, or add entire paragraphs Insert images. Update logos in a contract or add a new graph to a report Add links. Enrich your PDFs by linking to other pages or external websites ANNOTATE Highlight the important. Make the most valuable content stand out at a glance Comment on PDFs. Add text to PDFs, insert pop-up notes & write your thoughts in the margins Add stamps. Review documents with our set of stamps or create custom stamps for any workflow ORGANIZE Merge PDFs. Combine multiple files into one PDF document Manage pages. Add, delete, rearrange, or rotate PDF pages with ease Split PDFs. Extract pages from PDFs & save them as separate files CONVERT Convert to PDF. Turn JPG, PNG, Word, PPT, and Excel to PDF PDF to Word. Convert PDFs into editable Word documents PDF to image. Turn PDFs into JPG or PNG images PDF to Excel. Convert PDFs into Excel spreadsheets PDF to PPT. Save PDFs as PowerPoint presentations PDF to text. Convert PDFs into editable TXT files FILL OUT Fill out PDF forms. Easily fill out PDF forms by just clicking on them Sign documents. Add your signature to a PDF in a few clicks. Let customers sign documents with handy one-time signatures Redact PDFs. Blackout or erase confidential information from your documents RECOGNIZE TEXT OCR text in PDF. Recognize the text, so you can search, highlight & copy it Enhance scans. Fix distortions, remove shadows & improve contrast Crop & split pages. Split double-page scans into separate pages & remove undesired margins Good to know: Length of access: Lifetime Redemption deadline: redeem your code within 30 days of purchase Access options: Mac Max number of device(s): Unlimited usage on personal macOS devices Version: PDF Expert 3 for Mac (macOS) Updates: Get continuous support and bug fixes. Additional new features may come at an extra cost. PDF Expert One-Time Purchase normally costs $139.99, but you can pick it up for just $69.97 for a limited time, that represents a saving of $70 (50% off). For a full description, specs, and license info, click the link below. Deal Price One time cost now only $69.97 (was $139.99) Although priced in U.S. dollars, this deal is available for digital purchase worldwide. Support queries If you have queries or need support for any of the Neowin Deals, please use the contact form here. Neowin Deals are managed and sold by StackCommerce who represent Neowin on an affiliate basis. We post these because we earn commission on each sale so as not to rely solely on advertising, which many of our readers block. It all helps toward paying staff reporters, servers and hosting costs. Other ways to support Neowin Whitelist Neowin by not blocking our ads Create a free member account to see fewer ads Make a donation to support our day to day running costs Subscribe to Neowin - for $14 a year, or $28 a year for an ad-free experience Disclosure: Neowin benefits from revenue of each sale made through our branded deals site powered by StackCommerce.
    • Indeed - drives me mad - usually because Refresh is hidden in the full menu.
    • Firefox has had rounded corners for many years. I take it you're not a fan of modern browsers?
    • The problem is in the fundamentals of how businesses are allowed to operate and the change should happen in the basics and certain consumer friendly and moral practices should be enforced by law. This would fix so many things, not just this ages old default browser issue which is a tiny drop in the backut that includes a flood of privacy and other issues.
  • Recent Achievements

    • Collaborator
      conkir earned a badge
      Collaborator
    • Rising Star
      olavinto went up a rank
      Rising Star
    • One Month Later
      lamborghiniv10 earned a badge
      One Month Later
    • Week One Done
      lamborghiniv10 earned a badge
      Week One Done
    • Reacting Well
      X-No-file earned a badge
      Reacting Well
  • Popular Contributors

    1. 1
      +primortal
      504
    2. 2
      PsYcHoKiLLa
      271
    3. 3
      +Edouard
      75
    4. 4
      Skyfrog
      74
    5. 5
      Steven P.
      71
  • Tell a friend

    Love Neowin? Tell a friend!