Badge removal


Recommended Posts

I'm just wondering if any of you guys/girls can give me any advice on removing the FIAT badge and possibly the Punto badge from the back of my car? (See attached images)

My reason for wanting to remove is because it was a nice deep blue, now with time/weather it has faded to a pale mucky looking blue and looks bad in my opinion.

I've checked out some websites regarding what is behind the badge, too.

How I debadge my car?

The Punto Mk1 series had three releases:

Mk1 A (1993-1994), Mk1 B (1995-1997)

These cars can be debadged, but the rear door has some holes. You should fill the holes with an easy artwork at your garage.

Mk1 C(1998-1999)

This series can be debadged only by removing the badge which is only glued.

Mk2 (1999-2003)

All the releases of Type 188 can be debadged by removing the glued badge.

Taken from - Punto power

Ive put in bold my car year/mk.

Ive read that best tried and tested method is to use a hair dryer to slowly warm up the glue but not too much heat to damage the paint work and use some fishing line to slide between the badge and the car, hopefully taking of one of the layer of glue thus the badge coming off. Then using WD40 or some other form of rubbing alcohol to remove the rest of the glue. Then just wax up.

My fear is that I will rip half the paint work off :pinch: as Fiat Punto's are known for very thin paintwork (Which I have found out)

Any advice or tips would be great :)

111fw.jpg

129nw.jpg

Link to comment
https://www.neowin.net/forum/topic/364305-badge-removal/
Share on other sites

I'm not for sure it will work for you.... but getting a hair dryer and warming up the badges loosens the glue. Edit: Which it says in your post. Duh. :blush:

Then very gently see if you can push the letters around... if you can... make it a little warmer until they are almost ready to fall off.

I did this to my oldsmobile, because the "Old" on my Oldsmobile logo chipped and it looked dumb with just smobile.

When I took the logo off I almost crapped my pants because you could still the the lettering on the paint. So I washed and waxed the area and it was fine afterwards. It turned out to be a build up of dirt, salt, glue, and other outside junk.

Link to comment
https://www.neowin.net/forum/topic/364305-badge-removal/#findComment-586439619
Share on other sites

Did the same thing with my escort emblems on my old mk4.

Here is the problem before you take them off make sure theyre not pinned to the car, ie little pins that have punctured the metal so the emblem doesnt fall off.

Because if they are, yer gonna take em off, then have 2-4 holes where the emblem was.

As for what i did, was i took a razor blade and carefully went around the edges to lossen up the adhesive around it. Then once i could slip an index card inbetween i used that as a sort of buffer for when i jammed the flat head screwdriver to pry it off. Then I did what schocks did, a little googone, and some elbow grease and the area where it was, was clean. Actually cleaner than the rest of the car around it, i had to wax the car to make it match.

Link to comment
https://www.neowin.net/forum/topic/364305-badge-removal/#findComment-586439712
Share on other sites

i did my WRX last weekend. i cant vouch for Fiat, but some cars have actual pins thats hold the badge to the trunk. so, when you get the badge off, you have 2 holes in your trunk. you might want to check a fiat board first.

hair dryer works good, a heat gun will do it a little quicker if you have one. after warming them up, get some dental floss or fishing line and saw it back and forth behind the badge to seperate it from the adhesive.

once you have it off, heat up the left over adhesive a little more with the hair dryer and then lighty scrape off as much as you can with your fingers or a nylon stick (the non conductive black sticks used in computers.) they dont scratch. the left over residue i took off with some Goo-Gone spray (the gel works better) and some paper towel.

after that, i washed the back and dried it to make sure there where no scratches or left over adhesive. took about 20 minutes

Link to comment
https://www.neowin.net/forum/topic/364305-badge-removal/#findComment-586439734
Share on other sites

Thanks guy, If you check my post I quoted a little bit text from the Punto Power websites FAQ. Which says its just glued on and doesnt mention pin marks for my model year.

The model previous to mine says this:-

Mk1 A (1993-1994), Mk1 B (1995-1997)

These cars can be debadged, but the rear door has some holes. You should fill the holes with an easy artwork at your garage.

And mine is the Mk2 which says:-

Mk2 (1999-2003)

All the releases of Type 188 can be debadged by removing the glued badge.

I do want to do this, I just really dont want to damage my car :(

Link to comment
https://www.neowin.net/forum/topic/364305-badge-removal/#findComment-586439762
Share on other sites

Here's what I did to my Golf:

Heat it up, a lot. Take your time over this.

Get some tooth floss and double it up. Then very slowly and gently run it back n forth under the badge.

When the badge is removed, a VERY small amount of T-cut will buff out the residue.

Link to comment
https://www.neowin.net/forum/topic/364305-badge-removal/#findComment-586441432
Share on other sites

the proffesional way to do it is to take the badge off  then fill in the holes with special filler then sand it down and then re-spray the sanded area :p

586447801[/snapback]

According to my resources all Mk2 Punto's badges are Glued on with no Pins.

go to a local body shop. They can then take the blame if anything happens :)

586449422[/snapback]

Hmmm, That has crossed my mind but how much would it cost? And I have no idea where my local 'Body Shops' Is ;)

Also, is there any insurance problem with removing badges?

Link to comment
https://www.neowin.net/forum/topic/364305-badge-removal/#findComment-586450143
Share on other sites

Shouldn't really affect the insureance what so ever. Only if you where to claim aggainst the insureance if damage is done to the car. Then they may not pay for any damage.

586450796[/snapback]

Damage while removing the badges or damage as if I got hit by a car and then they found out I had removed the badges and then they wouldnt cover me?

Link to comment
https://www.neowin.net/forum/topic/364305-badge-removal/#findComment-586450806
Share on other sites

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • Python programmers in a nutshell. Now, guess what lang most AI programmers use... :-)
    • There was nothing whatsoever wrong with Vista as an OS after the SP1 update. People who claim it wasn't were using ancient machines for some silly reason. Not kidding, no hyperbole/exaggeration. Vista was good.
    • Windows ME was worse.
    • Dude, im talking about simply disable it from settings app. Because of the eu regulation, you could disable it here for years.
    • One big question about Mars was answered thanks to Einstein's 100 year old theory by Sayan Sen Image via DepositPhotos Scientists at the U.S. National Institute of Standards and Technology (NIST) have calculated how time passes on Mars compared with Earth, adding detail to how timekeeping would need to work beyond Earth’s orbit. The study, published in The Astronomical Journal, found that clocks on Mars run an average of 477 microseconds, or millionths of a second, faster per day than clocks on Earth. A microsecond is one millionth of a second, a very small unit used in precise scientific timing systems such as atomic clocks, which measure time using consistent atomic behavior. This difference is not constant. Because Mars moves around the Sun in a non-circular path (an eccentric orbit, meaning its distance from the Sun changes over time instead of staying fixed) and is affected by gravity from other bodies, the daily difference can vary by as much as 226 microseconds over a Martian year. The study also identifies smaller repeating changes of about 40 microseconds per day linked to synodic cycles (repeating periods that describe how planets line up with each other as they orbit the Sun from different positions). These longer patterns affect how time differences slowly rise and fall. To make these estimates, researchers compared Mars with Earth and the Moon. The work looks at relativistic proper time (the time actually measured by a clock depending on its speed and the strength of gravity where it is located, as described in Einstein’s relativity). This shows that each world has its own slightly different “rate” of time. This becomes more important as space missions expand into cislunar space (the region between Earth and the Moon) and toward Mars. On Earth, time systems rely on atomic clocks and satellites, which stay closely synchronized for navigation and communication. The study is based on Albert Einstein’s theory of relativity, which shows that time is affected by gravity and motion. Stronger gravity makes clocks run slower, while weaker gravity makes them run faster. “The time is just right for the Moon and Mars,” said NIST physicist Bijunath Patla. “This is the closest we have been to realizing the science fiction vision of expanding across the solar system.” A day on Mars is about 40 minutes longer than on Earth, and a Martian year lasts 687 Earth days. But the main question is not just about days and years, but how fast time itself passes. An atomic clock placed on Mars would function normally, but compared with one on Earth, the two would slowly drift apart due to differences in gravity and motion. This requires careful calculation of what is similar to a time-zone difference across planets. Researchers modeled Mars using a reference surface and included gravitational effects from the Sun, Earth, the Moon, and other planets. This includes a multi-body gravitational system (often described as a three-body or four-body problem, where predicting motion becomes difficult because multiple large objects all pull on each other at the same time through gravity). Mars also follows a Keplerian orbit (an idealized elliptical orbit based on simple gravitational laws that assume smooth motion, before adding real-world disturbances from other bodies). In addition, the researchers accounted for solar tides (small changes in gravitational force caused by the Sun that slightly distort planetary motion and timing, especially in systems involving Earth and the Moon). These combined effects are described as relativistic proper-time offsets (small but measurable differences in elapsed time between locations caused by gravity and motion), which must be included when comparing clocks across planets. “But for Mars, that’s not the case. Its distance from the Sun and its eccentric orbit make the variations in time larger. A three-body problem is extremely complicated. Now we’re dealing with four: the Sun, Earth, the Moon and Mars,” Patla explained. “The heavy lifting was more challenging than I initially thought.” Although the differences are extremely small, they matter for navigation and communication systems that depend on precise timing. Even modern networks on Earth, such as mobile systems, rely on timing accuracy at very small fractions of a second. Communication between Earth and Mars currently takes about four to 24 minutes or more depending on planetary positions, meaning signals are not real-time. A shared and accurate time system could help future missions reduce confusion in navigation and data exchange. “If you get synchronization, it will be almost like real-time communication without any loss of information. You don’t have to wait to see what happens,” Patla said. Researchers note that fully developed interplanetary communication networks are still far in the future. However, understanding how time behaves across planets helps prepare for those systems. “It may be decades before the surface of Mars is covered by the tracks of wandering rovers, but it is useful now to study the issues involved in establishing navigation systems on other planets and moons,” said Neil Ashby. “Like current global navigation systems like GPS, these systems will depend on accurate clocks, and the effects on clock rates can be analyzed with the help of Einstein’s general theory of relativity.” Patla added that the results also help improve understanding of time itself under relativity. “It's good to know for the first time what is happening on Mars timewise. Nobody knew that before. It improves our knowledge of the theory itself, the theory of how clocks tick and relativity,” he said. Source: NIST, IOPscience This article was generated with some help from AI and reviewed by an editor. Under Section 107 of the Copyright Act 1976, this material is used for the purpose of news reporting. Fair use is a use permitted by copyright statute that might otherwise be infringing.
  • Recent Achievements

    • Grand Master
      Jaybonaut went up a rank
      Grand Master
    • One Year In
      Philsl earned a badge
      One Year In
    • Dedicated
      Scoobystu earned a badge
      Dedicated
    • First Post
      Tom Schmidt earned a badge
      First Post
    • One Month Later
      D0nn13 earned a badge
      One Month Later
  • Popular Contributors

    1. 1
      +primortal
      443
    2. 2
      +Edouard
      177
    3. 3
      PsYcHoKiLLa
      124
    4. 4
      Michael Scrip
      78
    5. 5
      Xenon
      76
  • Tell a friend

    Love Neowin? Tell a friend!