Help my slinky is bent


 Share

Recommended Posts

On a tech forum :p

Yeh! people here are smart

Is it actually bent or just twisted? You can fix twisted slinkies...

nah its bent, if it were twisted or tangled i wouldnt be in this mess

Link to comment
Share on other sites

Ya, I find it hard to believe people still play with Slinkies.

Regardless, did you try bending it back? Place it over some warm heat (not too hot) and try bending it back. It might have a kink but its better than a complete bend!

Link to comment
Share on other sites

Yeah :p They are pretty fun

Ha ha yer, slinky's rock :D

get a metal slinky.

I second that. I used to have a lot of the coloured plastic one's when I was a kid, but in the end I broke load's of them, so I got a metal one and it rocks :D.

Make's the best sound ever as well.

Link to comment
Share on other sites

My slinky is bent to the left a bit.

I read somewhere that 30% of men have a slinky that bends to the left, 10% to the right, the other 60% is straight, down, or up.

Er... oh... slinky.

Link to comment
Share on other sites

My slinky is bent to the left a bit.

I read somewhere that 30% of men have a slinky that bends to the left, 10% to the right, the other 60% is straight, down, or up.

Er... oh... slinky.

:laugh:

Link to comment
Share on other sites

There will be a memorial service held for Mr. Slinky tomorrow at 10 AM.

Beverages will be served, If you would like to say a few words about your?memories with Mr. Slinky please let us know ASAP.

Link to comment
Share on other sites

Put it in some really hot water for a minute or two, then take it out and push the rings together, so that it's in the form it should be in. Hold it like that until it cools, or put a book on top of it. It should be much better if not perfect now.

Link to comment
Share on other sites

lol that doesn't make sens at all :rofl:

put it in the sun and put somethin above it to press it down ... or BUY A NEW ONE !

Diagram:

lolil3.jpg

Edited by Daninku
Link to comment
Share on other sites

This topic is now closed to further replies.
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.