new Canon T3i / 600D


Recommended Posts

Canon has unveiled the Rebel T3i (EOS 600D) upper entry-level DSLR. It continues to use the 18MP CMOS sensor seen in the Rebel T2i (550D) but gains a tilt and swivel 1,040k dot LCD monitor like the one offered on the more expensive 60D. It also gains the ability to remotely control flashguns using its internal flash, a feature previously only featured on higher-end models. Alongside the camera, Canon is also launching the 18-55mm F3.5-5.6 IS II, a cosmetically revised version of its optically stabilized kit lens. We've had a chance to use pre-production versions of both and have prepared a Hands-On Preview of the EOS 600D including beta samples gallery.

18-megapixel CMOS sensor

Scene Intelligent Auto mode

Full-HD EOS Movie

On-screen Feature Guide

3.7fps continuous shooting

Wide-area 9-point AF

1,040k-dot vari-angle 7.7cm (3.0”) screen

Basic+ and Creative Filters

Built-in wireless flash control

Announcement/source: http://www.dpreview.com/news/1102/11020720canoneos600d.asp

DPreview Handson: http://www.dpreview.com/previews/canoneos600d/

I know a lot of users on here are often looking at entry level cameras.

Controlling flash through the pop up on an entry level camera? I hope Nikon's own sake they include that on their D5000 replacement.

Link to comment
https://www.neowin.net/forum/topic/973928-new-canon-t3i-600d/
Share on other sites

the bigger slap in the face is that Canon comes out with a swivel screen for the T3i and expects the consumer to pay 200$ more for a camera which is the exactly same as the T2i except for the swivel screen. I know 3 people who are sticking with the T2i because T3i is not worth it. They said it would be better to upgrade to the 60D than the T3i because it will be cheaper

How does the controlling of external flashes using the pop-up one work? :s

Basically, it's like an optical cable, only it goes through the air.

The flash units, Nikon's current range is SB600, 700 and 900, have optical receivers on them that look for the coded message sent out by the pop up flash. The pop up flash send the signal out fractions of a second before it takes the photo. If you tell the pop up flash to send the signal, you can actually detect a slight delay of about .25-0.5 seconds(at least you can on my D90) before the picture is taken.

There are limitations to it, for example in best case scenarios you're limited to about 300 feet and the flash units need to see your pop up flash directly if you're working out doors.

Indoors they work brilliantly in a room. You can even shoot TTL with them, so you don't have to bother dealing with flash ratios or things like that. For more info check out Joe McNally or David Hobby (Strobist). Those two are pretty awesome (and they're going on Tour starting next month; I have a ticket!).

hope that helps.

Mirrorless? :s

yea... they're starting to head that way. I can't imagine that those cameras will be very good for any "pro" level applications.

18-megapixel CMOS sensor

Scene Intelligent Auto mode

Full-HD EOS Movie

On-screen Feature Guide

3.7fps continuous shooting

Wide-area 9-point AF

1,040k-dot vari-angle 7.7cm (3.0?) screen

Basic+ and Creative Filters

Built-in wireless flash control

Controlling flash through the pop up on an entry level camera? I hope Nikon's own sake they include that on their D5000 replacement.

To be honest this is barely an upgrade. Sony has pulled a couple of these releases haha...

And not including pop-up control on entry level bodies is BS, my entry level A200 can do that.

I think the rotating display makes it look less like an SLR and more like a cheaper Digital camera.

Maybe, but at the same time it might be usefull on certain occasions...like close to the ground shots, or when you raise your camera above your head :D

might be tempted to get a 550d as my second video camera, since it's going to come down in price :D

i got it recently on ebay with a 18-55mm IS lens for $599 shipped. it is coming down for sure

Canon though seriously needs to create a ripple in the industry like Nikon did with the Nikon D7000. Canon is too focuses on adding mini features instead of improving the very basics of camera and video like Nikon did with D7000. Also it seems Canon does not really interact with their consumers. Nikon on the other hand started the initiative to interact through social networks and their websites with their consumers by giving tips, tutorials, promoting their camera's in small cities.

Basically, it's like an optical cable, only it goes through the air.

The flash units, Nikon's current range is SB600, 700 and 900, have optical receivers on them that look for the coded message sent out by the pop up flash. The pop up flash send the signal out fractions of a second before it takes the photo. If you tell the pop up flash to send the signal, you can actually detect a slight delay of about .25-0.5 seconds(at least you can on my D90) before the picture is taken.

There are limitations to it, for example in best case scenarios you're limited to about 300 feet and the flash units need to see your pop up flash directly if you're working out doors.

Indoors they work brilliantly in a room. You can even shoot TTL with them, so you don't have to bother dealing with flash ratios or things like that. For more info check out Joe McNally or David Hobby (Strobist). Those two are pretty awesome (and they're going on Tour starting next month; I have a ticket!).

hope that helps.

yea... they're starting to head that way. I can't imagine that those cameras will be very good for any "pro" level applications.

Isn't that the same thing you could do with the old ones ?... With my EOS 400D I can use my pop up flash to fire my external Sigma flash, but both flashes will affect the image... Will this new feature only fire the external flash?

Isn't that the same thing you could do with the old ones ?... With my EOS 400D I can use my pop up flash to fire my external Sigma flash, but both flashes will affect the image... Will this new feature only fire the external flash?

nope, its not the same thing, as he mentioned, the pop up flash will send out the signal BEFORE it takes the photo. So the pop-up flash sends a signal essentially telling the slave(s) to get ready. Then when the camera takes the actual photo, only the slave's are exposing the shot not the pop-up flash

Isn't that the same thing you could do with the old ones ?... With my EOS 400D I can use my pop up flash to fire my external Sigma flash, but both flashes will affect the image... Will this new feature only fire the external flash?

The sigma flash is in dummy "slave" mode, meaning it'll fire when you see ANY flash. The flash I'm talking about lets you control the flash output either manually or TTL FROM the camera. You can't do that w/ the Sigma flash.

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • No its not, there are ton of Youtube videos to get you started, what do you think people did before AI existed?
    • Read this in Humor Simpson 's voice, "Out of my way Moe".
    • You still can, its just under the Transform flyout for WordArt now
    • Likely nothing will be done in corporate America, there have been countless Tesla self-driving incidents. Then again, there have also been countless human operated incidents. It's literally daily news here in Canada, to the extent that it's now odd if we get a day where a collision doesn't get announced on the radio throughout the day...
    • SKG Hand Massager with Heat OS500 hands on by Steven Parker I was offered the chance to test out the SKG Hand Massager with Heat OS500, and full disclosure, they let me keep it regardless of my findings. Anyway, I jumped at the chance due to my long hours sitting at my desk, mousing around. Apologies for the knife cut across the top of the box; that was my doing, being a bit too heavy-handed with opening up the outer packaging. First up, what's in the box: SKG Hand Massager with Heat OS500 1x Type-C charging cable User Manual 1-Year Warranty (card) In short, everything you need to get started. According to the official Amazon listing, here are the key features: Full-Hand Air Compression: OS500 wraps your fingers, palm, and wrist with multi-chamber air compression for a complete hand relaxation experience. The extended massage chamber helps cover more of the hand and wrist area than standard palm-only hand massagers Palm Kneading with 6 Modes & 6 Intensities: Built-in palm kneading rollers add a hands-on massage feel, while 6 preset modes and 6 pressure levels let you choose the comfort level that fits your day—from gentle relaxation to a firmer full-hand massage 3 Heat Levels with Cooling Fan: Choose from 104°F, 113°F or 122°F warmth to suit different seasons and comfort preferences. The built-in cooling fan helps reduce stuffiness during heated sessions, keeping your hand feeling fresh and comfortable Easy Visual Display & Smart Timer: The digital image display clearly shows massage area, mode, intensity, heat level, and remaining time at a glance. Select 10, 15, or 20-minute sessions for quick office breaks, evening relaxation, or everyday hand care Rechargeable, Cordless & Comfortable: A 3000mAh battery supports over 90 minutes of full-function use on a full charge, with convenient USB-C charging. The soft inner lining, smooth ABS/PU finish, and premium black-gold design make OS500 ideal for home, office, or gifting With all that out of the way, here are my own findings. I gave it a try on both left and right hands, and as you can maybe see from the above YouTube Short, (sorry for the shaky video), my whole hand fits in, but my wrist barely enters the Hand Massager. I was able to push through a bit more with my fingertips extending out the other end to get a bit of massaging on the start of my wrist. Usage For some reason, there is a strap that is very difficult to fasten to my wrist with one hand. I am not sure what function it has, and it isn't mentioned in the user manual. The only thing I could find was in the product images that claimed "wrist precision". Unlike the Bob and Brad Hand Massager, this device does not massage the wrist anyway, even though a "wrist mode" is mentioned, which must be for smaller hands than I have, as it is mainly intended for the hand and fingers. In addition, for its steeper price, there are no disposable gloves provided in the box, which is a bit of an issue considering the internal cover (which appears to be elasticated nylon) cannot be removed for washing; so you are left with only one choice: always thoroughly wash your hands before using it. I can imagine this thing getting a bit grimy after a period of use, and that is a bit of a shame. With that said, the buttons on the device, from left to right, do the following: Heat button: 3-level heat control at 104°F, 113°F, or 122°F Mode button: Auto mode Circular mode Soothing mode Relax mode Palm and fingers mode Palm and wrist mode Intensity button: from (First-time users) 15Ka, 25Ka, 35Ka, 45Ka, 55Ka, 60Ka (Intensive relief) Knead button: on or off (6 pressure levels) Power button: Long-press to turn on or off Cooling button: turn on or off the cooling fan Also, in the product imagery, it states there are 36 "custom modes," but nowhere is it listed what these modes are. I can only imagine that they mean a combination of all of the above settings in different intensity levels. The device itself seems to rely on a single "kneading" mechanism located at the palm area of the hand, which spins when in use, and the other massage features are mainly utilized through the air sacs, increasing and decreasing at various levels on the hand and fingers. I am not sure it offered too much relief for someone who is typing and operating a mouse for hours at a time; further testing may be required. It does feel nice, though. Finally, you may be wondering how this fits into the scope of a tech website? Well, let me tell you something: sometimes I sit for up to 15 hours working on Neowin, and although I take breaks in between, it takes a toll on my body. I think in the immediate absence of a partner to apply relief, a good massager like this Hand Massager can shed the strains of the day in just a couple of 15-minute bursts. On the official website, this has an MSRP of $99.99, but luckily for our readers, it is selling at $10 off for just $89.99 right now on Amazon. SKG Hand Massager with Heat OS500 for $89.99 (with $10 off coupon), $99.99 MSRP For me, this gets a thumbs hands(?) down. However, it could be improved by making it so that the protective covering could be removed and thrown into the washing machine, or get yourself some disposable gloves to use with it. As an Amazon Associate, we earn from qualifying purchases.
  • Recent Achievements

    • Dedicated
      Almohandis earned a badge
      Dedicated
    • Dedicated
      JuvenileDelinquent earned a badge
      Dedicated
    • First Post
      DrWankel earned a badge
      First Post
    • Reacting Well
      DrWankel earned a badge
      Reacting Well
    • Week One Done
      Supreme Spray LV earned a badge
      Week One Done
  • Popular Contributors

    1. 1
      +primortal
      505
    2. 2
      +Edouard
      184
    3. 3
      PsYcHoKiLLa
      86
    4. 4
      Michael Scrip
      78
    5. 5
      Steven P.
      76
  • Tell a friend

    Love Neowin? Tell a friend!