Recommended Posts

3 hours ago, jjkusaf said:

Missing a couple of Merlin engines on the back of that food truck .... otherwise .... looks great!

 

If Spaceballs could do it ... so can SpaceX

626b80dd797753892d9d080c34b3758b.jpg

This is so full of win, I don't know where to even begin ... only thing that's missing is "Raise Your Hands", the side pan camera, and the SpaceX paintjob. :yes: :woot:

extra data...

 

reference the above newest Dragon v1...

 

This one is D1-11 which is flying on CRS-9.
D1-12 will fly on CRS-10.
CRS-11 will be the first Dragon capsule to be reused using pressure hull of Dragon D1-6.
D1-6 was CRS-4
CRS-11 will be DR1-? (Dragon v1 reusable - #)

NASA has stated new launchers. NASA has not said that cargo craft can't be refurbished.
Various avionics and thrusters have already been reused in Dragon, Elon statement approx 2 years ago...

reference-EchoLogic/reddit

will require verification, but source usually accurate.

 

pressure vessel (hull)

DragonPressureHull.jpg

 

----------------------------

Remember the launch delay due to the barge.....

 

 Waivers of Ship Protection Probability of Impact Requirement

A Notice by the Federal Aviation Administration on 05/10/2016

 

summary

Quote

This notice concerns two petitions for waiver submitted to the FAA by Space Exploration Technologies Corp. (SpaceX): A petition to waive the requirement that a waiver request be submitted at least 60 days before the effective date of the waiver unless good cause for later submission is shown in the petition; and a petition to waive the requirements that exclude persons in waterborne vessels from the collective risk criteria and limit the probability of impact on waterborne vessels to 1 × 10 −5.

full submission at...

https://www.federalregister.gov/articles/2016/05/10/2016-09685/waivers-of-ship-protection-probability-of-impact-requirement

  • Like 1

ooops          forgot this...

 

another image of the FH booster test article

7L9Q6VL.jpg

 

image source

 

resembles wind tunnel mock-up model

 

ZJfbZzz.jpg

link

 

 

 

wzy8ooH.jpg

link

 

:D

  • Like 2
2 minutes ago, Draggendrop said:

ooops          forgot this...

 

another image of the FH booster test article

7L9Q6VL.jpg

 

image source

 

resembles wind tunnel mock-up model

 

ZJfbZzz.jpg

link

 

 

 

wzy8ooH.jpg

link

 

:D

That's pretty.  Would like to purchase one and sit it up in my living room.

  • Like 2

In reference to pressure hull reuse, McGregor storage

 

RzH0x36.jpg

SpaceX

 

--------------------------

 

Found some eye candy for Falcon "hold down", thought it was neat and dropped it here....

 

Link has images of moving mechanism

Falcon holddown mechanism test, 2015, Vandenburg

 

 

eDXIH93.png

Closed               

 

 

qYrCP1n.png

Open

 

 

JCSAT14-4.jpg

Pin between landing legs is the hold down points, also used for jack/chain stabilizing on ASDS

 

21048044876_d43001a370_o.jpg

FH will have 4 additional actuators for hold down.

 

:D

  • Like 2

Carbon scoring marks due to reentry. If that had been metal tears, I promise those would have been a lot longer and we'd see more of them, there would have been buckling/folding nearby as well as blowouts and breaches. In other words, we'd see a lot more damage, and SpaceX would have been forthcoming about it. :yes: 

Dunno if it is cracks, some sort of structural damage or just scoring marks (hard to tell really) ... but ... if it is damaged ....

 

DATA!!!

 

Gotta remember ... SpaceX didn't have high hopes for this thing returning in one piece ... so even if there is some sort of structural damage ... they have the whole thing to study versus bits and pieces. :)

 

  • Like 1

My guess would be an octaweb shielding degradation/burn through, of which caused increased pressure to push out those lower access panels. Probably a bit for expensive, than wanted, for a reusable...but this is what they need for data and improvements...still a massive win on the landing, particularly with the damage.

 

:D 

  • Like 2

Well, DD, you called it. Octaweb looked like it was on fire, you said ... you may have been right. There's no visible damage on the rest of the rocket, so a high-v entry could have messed with it. Could explain the "leaking and burning".

 

Would make a slightly stronger case for a Chem or Carbon Snuff system to put out any fires at landing; but it's not gonna help anything during a high-v boostback or entry. Problem is any chem or carbon is gonna clog up the Merlins ... :no: ... and that's a no-go.

  • Like 1

They will have a good jump, with the data, to button her up to better withstand the heat/pressure. She landed fine with an admirable control system. This will only get better. After all, this is stuff that is hard to simulate, one needs to do it and see what to improve.

 

This is a total win either way....she landed, under control and presented a book rack of data for the hot and fast returns.....next.....

:D

  • Like 1

Full size image

 

26428478544_2bff22971f_o.jpg

 

image link

 

This and 3 more on SpaceX flickr...

https://www.flickr.com/photos/spacex/

 

Three cores together will give an idea of FH's size......:D

  • Like 1

Yep, it landed with damage -- no idea how bad, but it's damage and it held up all the way to landing. That speaks to the robustness of the platform. :yes: 

 

1.3 Upgrades are in-progress, so this'll be one more thing to look at and improve where needed. I'm sure they're looking at the telemetry very carefully to see what happened, when and where it happened at. Among the things that are special about Falcon-9 Rockets ... they're smart. Nothing, nothing happens to them that SpaceX can't account for later on.

 

Take the failed strut last year. Think ULA could have figured that one out? Nope. Not a chance. And since then SpaceX has added more sensors, just to make sure it doesn't take that long to figure it out if it happens again.

  • Like 2
Just now, flyingskippy said:

Which lower access panels were blown out? I wasn't able to see anything on their flicker account. 

Down by the legs, two panels were off prior to landing on ASDS. The area can be seen on landing video. Apparently they were designed to come off when a pressurization occurs above the octaweb....referenced in a reddit thread...need to confirm still

:)

I just checked the vid and didn't see anything. I could be looking in the wrong area too though.  I did see a green flash after engine shutdown characteristic of the TEA-TEB ignition system. Maybe the ignition system took some damage as well. 

  • Like 1

Talking about this area right @Draggendrop?

 

Capture.JPG

 

Whereas the other barge landing looks like it had a black panel across.

 

Untitled-1.jpg

 

 

Still...phenomenal ... data ... plus they'll be able to reuse something from it. :)

 

  • Like 3
This topic is now closed to further replies.
  • Posts

    • Get 1-year and $60 of Sam's Club value for just $15 with Auto-renew by Steven Parker Become a Sam's Club Member Now! Shop Premium-Quality Products and Enjoy Incredible Perks, and Savings. Today's highlighted deal comes via our Gift Cards section of the Neowin Deals store, where for only a limited time, you can save 75% off a Sam's Club 1 Year Membership with Auto-Renew. Sam’s Club is a membership warehouse club, a limited-item business model that offers members quality products at an exceptional value unmatched by traditional retail. From groceries and kitchen supplies to electronics and furniture, Sam's Club has great deals on the items you want! By redeeming and signing up as a member, you'll be paying just $20 for a 1 year Sam's Club membership (normally $50.) You'll receive a complimentary household card for more savings from already low-priced items. Sign up now and save money on all your food and decor. Find great deals on groceries, kitchen supplies, electronic, furniture & more Get discounts on hotels, rental car, live events, attractions, movies, & more Save up to 60% on hotel accommodations around the world Get a complimentary household card for more savings from already low-priced items Although it was published quite some time ago, Sam's Club members can enjoy discounts like this. Important Details For a physical membership card after online membership registration, present your phone number or email along with a valid ID at Sam’s Club Membership Services in any US Sam's Club location to have your membership card printed. This membership offer is only available to new Sam's Club members in the USA. It is not valid for membership renewals, for those with a current membership, or those who were Sam’s Club members less than 6 months prior to the current date. To check your renewal date, please check your billing statement or your online account, or chat with an associate. Promotion code is non-transferable Offer valid for new Sam’s Club members only; not valid for membership renewals, for those with a current membership, or those who were Sam’s Club members less than 6 months prior to the current date. Auto Renew: By accepting this offer, you authorize annual recurring charges to any card on file for your Sam's Club membership fee(s) plus any applicable taxes at then-current rate every year until you cancel. Current rates, which may change, are $50 for Club level and $110 for Plus level. Visit SamsClub.com or a club or call 1-888-746-7726 for full terms or to cancel auto-renewal. Valid at over 597 U.S. Sam’s Club locations. Find a location near you. Redemption deadline: redeem your code within 30 days of purchase Access options: desktop & mobile Membership MUST be activated within 30 days Membership expires 1 YEAR from the date the Sam's Club membership is activated Limit 1 per person, may buy 1 additional as gift This Sam's Club 1 Year Membership normally costs $60, but can now be yours for just $15, for a limited time, that's a saving of $45 (70%) off! For specifications, and terms, please click the link below. Get 1-year of Sam's Club with Auto-renew for just $15 (was $60) This deal is only available to U.S. residents. Support queries If you have queries or need support for any of the Neowin Deals, please use the contact form here. Neowin Deals are managed and sold by StackCommerce who represent Neowin on an affiliate basis. Why we post these deals We post these because we earn commission on each sale so as not to rely solely on advertising, which many of our readers block. It all helps toward paying staff reporters, servers and hosting costs. So for those that keep moaning and complaining, be thankful we're still online for you to even do that. Other ways to support Neowin Whitelist Neowin by not blocking our ads Create a free member account to see fewer ads Make a donation to support our day to day running costs Subscribe to Neowin - for $14 a year, or $28 a year for an ad-free experience Disclosure: Neowin benefits from revenue of each sale made through our branded deals site powered by StackCommerce.
    • Microsoft, why can't I just turn off Copilot on my MS account (in order to stop OneDrive from wanting to summarize everything, ahem) in a way that doesn't break OneNote instead?
    • If we can't agree on a baseline of reality then there is no point in talking. Its a waste of time.
  • Recent Achievements

    • Collaborator
      ryansurfer98 went up a rank
      Collaborator
    • Week One Done
      Eurosoft10 earned a badge
      Week One Done
    • One Month Later
      Eurosoft10 earned a badge
      One Month Later
    • One Year In
      Skeet Campbell earned a badge
      One Year In
    • One Month Later
      Sharbel earned a badge
      One Month Later
  • Popular Contributors

    1. 1
      +primortal
      589
    2. 2
      +Edouard
      190
    3. 3
      PsYcHoKiLLa
      80
    4. 4
      Michael Scrip
      77
    5. 5
      Steven P.
      73
  • Tell a friend

    Love Neowin? Tell a friend!