Do you Hackintosh?


Recommended Posts

I used to hackintosh in the Leopard era... 2007 but not more. It is a waste of time in my opinion. Any update to the OS, brake the whole system down and you have to re-install again. Too painful. I rather have a real old apple system and this is why I have a macpro 2010.

2 minutes ago, macoman said:

Any update to the OS, brake the whole system down and you have to re-install again

Not really, there's plenty of threads on the hackintosh reddit, AMDOSX, Insanelymac where people are fine with their vanilla installs and updating the system through apple and it goes fine. Yes, you can have a problem, and the AMD side is especially vulnerable as the processors arent natively supported by the OS and have to be patched (which can be 'broken' by Apple) but it's part of the fun and part of the challenge to running the system.

 

I've a Mac mini too, and an old G4 that's running great. Its all about choice and I respect those who opt for legit, and opt to hack.

It didnt hurt the brand of any other software that has requirements listed clearly.

 

They could just say if you don't match the requirements then it doesn't work as well.

 

Their os is just a custom window manager on Berkeley Unix out of California. That's right, it's just BSD.

 

I never said my opinions reflected the whole of the internet.

 

They could sell it, it would be fine, as far as I'm concerned they're ignoring a potential revenue stream.

Shoot, since it's the big thing right now they could even offer it as a subscription for non-Apple hardware and I know people that would jump on it.

5 hours ago, margrave said:

It didnt hurt the brand of any other software that has requirements listed clearly.

 

They could just say if you don't match the requirements then it doesn't work as well.

 

Their os is just a custom window manager on Berkeley Unix out of California. That's right, it's just BSD.

 

I never said my opinions reflected the whole of the internet.

 

They could sell it, it would be fine, as far as I'm concerned they're ignoring a potential revenue stream.

Shoot, since it's the big thing right now they could even offer it as a subscription for non-Apple hardware and I know people that would jump on it.

Your post just shows you have no idea of the brand and experience that they trade on. So fair play to you, this conversation is done as it’s pointless.

I've had Apple products. There's nothing that one of them can do that a more economically priced device can't do. Especially one build by hand.

 

From my experience the brand they sell is a fully locked down environment where the user is highly limited. At least there's a bunch of more freedom in the new Unix based OS than from previous versions. 6, 7, even up to 9 MacOS were not only locked down heavily, but trying to program on one of those devices was a nightmare! I hated that!

 

As far as I can tell they want a system so easy that anyone can use it. That's what everyone's trying to do though. They also tend to be proud of not being compatible with other systems. That serves no purpose other than to separate users unless you're 'one of us'.

 

And if you don't think that MacOS is Unix, just open your Applications folder, then open Utilities and double-click on Terminal. That's a proper *ix command terminal.

 

If they could get their store on more systems that would be a new possible window of software sales. I'm not saying all of their OS's could be sold, just their Unix MacOS. NOT iOS! That should stay married to iPhone and iPad.

 

This is one of the reasons I don't support the idea of one OS for all devices. I just don't think it would make the maximum amount of revenue.

1 hour ago, margrave said:

I've had Apple products. There's nothing that one of them can do that a more economically priced device can't do. 

 

Mmmmm. Build iOS or macOS apps are two things. Did you mean device to be a Hackintosh?

Been using a Hackintosh for the last 4-5 years now. It has been very stable. Two days every year, I need to spend some time on updating everything or reinstalling everything. I usually do a clean install once a year when a major new macOS release is out. I am using Clover, though there is now Opencore which is supposedly even better. 

  • Like 2
  • 8 months later...
On 14/01/2020 at 13:18, forster said:

I just wondered if anyone in the community uses a Hackintosh, whether just for curiosity, experimentation, or as a system to get real-life work done (most likely video and music production Id guess, or just general day to day consumption of media).

 

I currently run a Ryzen based Hackintosh as a daily driver, it's great and the only thing that I really can't get access to is Adobe Lightroom (not a big deal as I use Photoshop). I'm running a Ryzen 3600 on an Asus Tuf X570 plus Wifi with 32 gig of ram, really only because I like to use macOS messaging integration (I use an iPhone), and I am an amateur hobbyist when it comes to a piece of tech I try and tinker with it as much as possible.

 

I've had several Hackintosh machines in the past, an intel 4770k/Gigabyte board hack, and just picked up a Dell e5470 laptop which worked great with macOS too.

 

So, would be interested in anyone else's experiences, especially if you have jumped into using Opencore as opposed to Clover - my Ryzen machine is using Opencore and it seems to give a much more of an authentic 'Mac' experience i.e. my Apple TV app works, which I haven't managed to get working on my old intel systems. 

I am running a hackintosh with Ryzen 3900x using Opencore 0.6.3. It's great so far, though I don't have a specific use-case for MacOS. I have Win10 in separate ssd, but rarely use it. I ran Manjaro before MacOS, though.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • Waymo recalls self-driving software after cars enter closed freeway work zones by Paul Hill Waymo, the self-driving car maker owned by Alphabet – the parent company of Google –, has recalled some of its fifth-generation Automated Driving Systems (ADS). It did so after some of its cars drove through closed construction zones. According to the National Highway Traffic Safety Administration (NHTSA), the affected vehicles were capable of driving through a closed freeway construction zone and continuing to drive at speed. The listing on the NHTSA website says that Waymo is currently developing a solution to fix this issue, but in the meantime, freeway driving is being restricted. Waymo will update its ADS software so that vehicles can detect when they can avoid entering construction zones. According to the Safety Recall Report, on April 20, 2026, Waymo’s Field Safety Committee began meetings reviewing an event from April 11, 2026, and five events from April 19, 2026, where Waymo’s autonomous vehicles didn’t recognize and drove past ramp closure signs into the pre-planned freeway construction zones. This took place in Phoenix, Arizona. Separately, on May 18, 2026, seven Waymo vehicles entered freeway lanes with active construction in the San Francisco Bay Area by driving between cones that were placed to show the lane was closed. On the back of both of these events, Waymo restricted freeway driving until it could address the issue. In June, Waymo’s Safety Board reviewed the issue and additional information related to ADS performances around construction zones; then, as a result, it decided to conduct a recall. This development is not good for Waymo as it adds to a growing list of technical hiccups its cars have experienced. Ultimately, it will lead to more scrutiny from lawmakers around the world who will be more cautious about letting autonomous vehicles on their roads without tighter regulation. For readers in areas where Waymo operates, does this news make you more wary about stepping into one of these vehicles?
    • I'm still on Windows 10 22H2 because I didn't want to deal with all the issues in Windows 11, so I waited almost a week before installing the latest Patch Tuesday update (KB5094127), I went ahead and did it, and it was a huge mistake—ever since then, my File Explorer has seen a performance drop of about 30% when transferring large files... Once again, Microsoft has outdone itself! This update cannot be uninstalled, either through the Control Panel (via Settings) or by accessing Advanced Startup Options. The only possible alternative would be to use system restore points, but I’d have to reinstall all app and driver updates (and there’s no guarantee it would work). Or there’s the “nuclear option” of a in-place repair without losing files or apps, but even then, all my customizations would be lost! Microsoft just can’t help but mess everything up! Way to go, Microsoft! But I still don’t want your c****y Windows 11!
    • Microsoft: Windows 11 could finally solve a major issue across AMD, Nvidia, and Intel GPUs by Sayan Sen While Microsoft has been trying to improve it, Windows 11 is definitely not flawless, as even today some issues are taking a year to publicly acknowledge. However, one area of trouble that may finally see much better results soon is graphics driver crashes. Work on graphics driver timeouts, also called Timeout and Detection Recovery (TDR), is not new as the latest WDDM 3.2 also has specific improvements regarding it. Windows Display Driver Model (WDDM) version 3.2 is supported on Windows 11 24H2 and 25H2. However, with the upcoming version 26H2, TDR crash diagnosis could go to the next level as Microsoft is introducing a new DirectX 12 API feature called "DirectX Dump Files". Similar to how system memory dump files work when a system crashes or freezes or encounters any such major issue, DirectX Dump Files (DDF) will essentially record a snapshot of the GPU execution right at the moment a graphics-related crash or hang or freeze occurs, so that developers can better understand and diagnoze these TDR and timeout detection errors. The dump will be available as a .dxdmp file for analysis and it will be a comprehensive dump file generated with detailed insights about the hardware, drivers, Windows, as well as the affected application. This should be another welcome change in this department. Earlier at GDC 2026, when the technology was first debuted, Microsoft had shared more details regarding it. The company had explained how DDF is designed to gather data from every layer of the graphics stack into a single file, eliminating the need for developers to manually correlate logs from multiple tools. As mentioned above, the dump can contain a lot of useful details like GPU hardware state information such as register values, shader program counters, page fault virtual addresses, shader memory data, and command buffers. Alongside that, it also captures DirectX runtime and kernel information, including D3D objects, pipeline state objects, device error data, adapter details, and CPU call stacks. Microsoft says the feature has been built around two primary use cases: retail device removals and local device removals. The former allows developers to collect crash information from end users' systems in the field, while the latter helps QA teams and developers investigate issues on test machines. Developers will also be able to include up to 2 MB of custom application data through new D3D12 APIs, providing additional context for troubleshooting. In addition, Microsoft is introducing three dump collection modes ranging from zero-overhead capture, which has no runtime performance impact on supported hardware, to higher-detail modes that collect more vendor-specific debugging data. On compatible Tier 2 hardware, zero-overhead dumps will be enabled by default, meaning developers may begin receiving useful crash diagnostics without making any code changes. The table below explains the three tiers: Tier Description NO_OVERHEAD Enables crash capture with no runtime cost and is suitable for broad deployment MEDIUM_OVERHEAD Provides a balance, capturing additional diagnostic data with moderate impact HIGH_OVERHEAD Collects the most detailed GPU and driver state available, enabling deeper investigation at the cost of higher runtime overhead In terms of availability, the company expects broader release to be around the fall of 2026, which should be right around the time when Windows 11 version 26H2 lands. Right now, DirectX Dump Files are available as a preview and currently, only AMD has the compatible AgilitySDK Developer Preview driver version 26.10.07.02. You can find the official announcement post here on Microsoft's website.
    • And with SO much better perf than the laggy mess that is Files.
  • Recent Achievements

    • First Post
      BizSAR earned a badge
      First Post
    • Week One Done
      Jordan Smith earned a badge
      Week One Done
    • Reacting Well
      BizSAR earned a badge
      Reacting Well
    • First Post
      AndreaB earned a badge
      First Post
    • Week One Done
      Huge Trailer earned a badge
      Week One Done
  • Popular Contributors

    1. 1
      +primortal
      598
    2. 2
      +Edouard
      190
    3. 3
      PsYcHoKiLLa
      80
    4. 4
      Michael Scrip
      76
    5. 5
      Steven P.
      69
  • Tell a friend

    Love Neowin? Tell a friend!