Recommended Posts

Anyone use OpenDesire? It looks like it doesn't stray far from the official 2.2 update and only adds a little :)

The MoDaCo rom looks good as well.

I'm using OpenDesire right now. Have nothing to complain! It's close to stock, with a few added extras. Also there's plenty of updates, and the devs listen closely to people on their forum. :)

I'm using OpenDesire right now. Have nothing to complain! It's close to stock, with a few added extras. Also there's plenty of updates, and the devs listen closely to people on their forum. :)

Sounds good. Can you update without losing all your contacts/aps ect? (after the initial install of a custom rom) Some of the custom roms get updated so frequently.

I looked at OpenDesire but there seem to have been lots of complaints about it looking at the XDA thread. I went for DeFrost in the end, which works splendidly!

You can also install a new ROM without wiping, but in the case that you have any issues, you may have to do a full wipe/clean install. They do recommend that you do a Nandroid backup though before you upgrade, so that in the rare case that something does go wrong, you can do a complete restore.

Sounds good. Can you update without losing all your contacts/aps ect? (after the initial install of a custom rom) Some of the custom roms get updated so frequently.

Yeah I only needed to swipe when going from my 2.1 Sense ROM to 2.2 OpenDesire. After that I updated OpenDesire several times, and never had any issues with losing data. Better yet, I still had some unread notifications and they were still there after updating. Small but pleasant surprise.

I looked at OpenDesire but there seem to have been lots of complaints about it looking at the XDA thread. I went for DeFrost in the end, which works splendidly!

I only had an issue once, and that was when they switched keyboards in an update. Had some crashes, but they released an update the same day which fixed it.

:)

I think I'll go with OpenDesire then, looks like it keeps the Sense UI by HTC intact as well.

No it doesn't. Unless I've missed something new. :p

I do recommend trying the stock GUI though. I personally like it much better than HTC's "dumbed down" version. Put LauncherPro on that thing and you're ready to rock.

No it doesn't. Unless I've missed something new. :p

I do recommend trying the stock GUI though. I personally like it much better than HTC's "dumbed down" version. Put LauncherPro on that thing and you're ready to rock.

It doesn't? Ah right, might go with MoDaCo then it looks like it does run on Sense UI - http://android.modaco.com/content/htc-desire-desire-modaco-com/316565/24-aug-r8-modaco-custom-rom-for-htc-desire-with-online-kitchen-2-2-froyo/

I haven't tried MoDaCo yet. Still happy with OpenDesire so far. To be honest, I felt quite relieved when I ditched Sense. I liked it, but I like everything about the stock UI better. :) Just feels more fresh and modern. Also I hated the Sense browser. :p

Guess I just have that feeling of wanting to experience what I buy first :p

Plus a dog crapping in a bag is better than iOS, so I'm sure I'll love Sense to start with, or forever.

I just don't want to dive right into heavy customization/etc, want a nice light custom rom similar to what stock would be but with some tweaks/extras.

Thanks for all the help guys!

ps. Can't you get Opera or something from the droid store? Chrome should really be on these phones by now lol.

Guess I just have that feeling of wanting to experience what I buy first :p

Plus a dog crapping in a bag is better than iOS, so I'm sure I'll love Sense to start with, or forever.

I just don't want to dive right into heavy customization/etc, want a nice light custom rom similar to what stock would be but with some tweaks/extras.

Thanks for all the help guys!

ps. Can't you get Opera or something from the droid store? Chrome should really be on these phones by now lol.

Yeah that makes sense. :) You can always go for more customization if you get bored.

I believe there's Opera 10 Mini or something in the Market. Tried it, but didn't like it. :p The stock browser looks alot like Chrome though. Not sure if it is. Pretty sure the Sense browser works on the same technology. So you should be fine.

Another question (please don't be mad people :p)

Why is it all the custom roms include A2SD/A2SD+? I thought 2.2 added the ability to install an Application to your SD card?

Thanks

2.2 does add the ability for apps to be stored on your SD card, however the developer of that app needs to specifically code that in. Where as A2SD+ pushes all apps onto your SD card.

A2SD = Froyo 2.2 apps on SD card

A2SD+ = ALL apps onto SD card

I would go with ROMs with A2SD+ ;)

Also, to answer your earlier question. One click root, called unrevoked. Nothing hard at all.

Another question (please don't be mad people :p)

Why is it all the custom roms include A2SD/A2SD+? I thought 2.2 added the ability to install an Application to your SD card?

Thanks

Android 2.2 A2SD isn't A2SD, it's rubbish in comparison. It allows you to move an app (not its data, just the app itself) to SD after you install it to internal memory and nothing more.

Proper A2SD and A2SD+ allows moving of everything to the SD-EXT partition and this also includes Cache2SD and you end up with more free internal memory and better performance.

2.2 does add the ability for apps to be stored on your SD card, however the developer of that app needs to specifically code that in. Where as A2SD+ pushes all apps onto your SD card.

A2SD = Froyo 2.2 apps on SD card

A2SD+ = ALL apps onto SD card

I would go with ROMs with A2SD+ ;)

Also, to answer your earlier question. One click root, called unrevoked. Nothing hard at all.

Thanky buddy, I got it all planned for tomorrow, unrevoked, then MoDaCo :)

edit: What's this about formatting the memory stick correctly for A2SD+ though?

Thanky buddy, I got it all planned for tomorrow, unrevoked, then MoDaCo :)

edit: What's this about formatting the memory stick correctly for A2SD+ though?

That is nothing to worry about...

Singh's mini guide

1) If you have an Orange branded handset, make sure you unlock it first

2) Root it using unrekoved (tip, run the exe as admin, right click and select as admin)

3) Create a nandroid backup

4) Then flash your radio - some ROMs require very specific radios. Most need a radio of 5.x+ now

5) Then flash your ROM, then LEAVE IT alone. Go away, and leave it for atleast 15 mins. If it gets stuck on the HTC logo screen or the boot screen. Do not panic. Reboot back into the boot loader, and clear all the caches, including the dalvik cache.

6) Once you have finally booted into your custom ROM, give it a couple of minutes to settle down after you finish the set up process.

7) Download ROM Manager straight away from the Market. And then create the EXT2 (or EXT3) partition. When prompted, select 512MB size of partition, and then select 0mb swap.

8) Reboot

9) Profit.

Good luck!

That is nothing to worry about...

Singh's mini guide

1) If you have an Orange branded handset, make sure you unlock it first

2) Root it using unrekoved (tip, run the exe as admin, right click and select as admin)

3) Create a nandroid backup

4) Then flash your radio - some ROMs require very specific radios. Most need a radio of 5.x+ now

5) Then flash your ROM, then LEAVE IT alone. Go away, and leave it for atleast 15 mins. If it gets stuck on the HTC logo screen or the boot screen. Do not panic. Reboot back into the boot loader, and clear all the caches, including the dalvik cache.

6) Once you have finally booted into your custom ROM, give it a couple of minutes to settle down after you finish the set up process.

7) Download ROM Manager straight away from the Market. And then create the EXT2 (or EXT3) partition. When prompted, select 512MB size of partition, and then select 0mb swap.

8) Reboot

9) Profit.

Good luck!

Really, thanks a lot! My ROM says it includes the newest radio so I think I can skip step 4, but the rest will help loads!

If you use unrevoked then flash AmonRA's R5 recovery, this puts a permanent recovery on the phone just like previous android phones (g1/nexus 1, magic etc) and means you don't need rom manager or an update.zip any more.

It also has a lot more features compared to the fakeflash methods used by rom manager and unrevoked.

If you use unrevoked then flash AmonRA's R5 recovery, this puts a permanent recovery on the phone just like previous android phones (g1/nexus 1, magic etc) and means you don't need rom manager or an update.zip any more.

It also has a lot more features compared to the fakeflash methods used by rom manager and unrevoked.

Not quite sure I follow much of this :p

All I have to go on for my ROM is

To install this ROM:
  • Ensure you have are able to launch the custom recovery image (see 'requirements' above)
  • Download the zip file of your choice from the links below (or the online kitchen) and copy to your SD card
  • Restart your device in recovery mode
  • PERFORM A NANDROID BACKUP FROM THE MENU
  • Select the option to apply an update zip, and select the zip file you copied to your memory card

If that's the way I have to update I guess I should just leave it alone?

Thanks though I'm just soo new too all of this, if it's jailbreaking or customizing the iPhone I'm fine haha.

If you use unrevoked then flash AmonRA's R5 recovery, this puts a permanent recovery on the phone just like previous android phones (g1/nexus 1, magic etc) and means you don't need rom manager or an update.zip any more.

It also has a lot more features compared to the fakeflash methods used by rom manager and unrevoked.

Unrevoked permanently flashes ClockworkMod Recovery to the recovery partition. It is always there. And you don't need an update.zip at all, just *.zip will do. All you have to do is select "install zip from SD card" and then select your zip (tip: drop zip in root of your SD card).

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • About bloody time. I have got PRs with hundred of files and the Web UI just struggling to even load the pages.
    • I wonder if it was applying secure boot certificates/dbx files?
    • I recently tried edge. It seems a lot better. A lot of the junk in it is gone. It seems less bloated and snappy.
    • Lethal fake phone chargers are still being sold on Amazon and eBay, UK watchdog warns by Paul Hill Credit: Pexels The UK consumer rights organization, Which?, is claiming that “potentially lethal knock-off chargers” are still being sold on online marketplaces seven years after it exposed the danger of these chargers. In its latest investigation, it bought 15 USB phone chargers from several online marketplaces and found they were missing key information, meaning they cannot be legally sold in the UK. Which? bought the 15 chargers from seven online marketplaces. These were Amazon (including Amazon Haul), AliExpress, B&Q Marketplace, Debenhams Marketplace, and eBay. It said that the chargers were so badly made that anyone using them was at risk of electric shock. Over half the chargers also posed fire and explosion risks. Of the chargers purchased, one was a fake Apple USB-C 35W power adaptor charger. To confuse buyers, the box was branded with an Apple logo, but testing found it to be a fake. Further testing picked up arcing sounds after 10 seconds of use, where a current jumps between two parts of the electrical circuit, which can cause fires, explosions, or electric shock. The manufacturers of this particular charger also put modeling clay inside it to make it feel more weighty, robust, and genuine. Not all of the chargers were technically faulty; however, some were missing key packaging, markings, and documentation, meaning they can’t be sold in the UK legally. Which? said that it is now campaigning alongside a coalition of safety groups and businesses for new laws that make online marketplaces responsible for ensuring the safety of products that they choose to list on their websites. It also said the government needs to start using powers under the Product Regulation and Metrology Act, which was adopted last July, to impose safety requirements on online marketplaces via secondary legislation, but so far, there have been delays. No matter what country you are in, be sure to properly research what you are buying and only buy authentic chargers to prevent fires. You can read more about Which?’s research here.
    • Visual Studio finally gets long-awaited feature that developers will love by Usama Jawad Visual Studio Code is Microsoft's popular, lightweight, open-source code editor, it is actually Visual Studio that is the company's flagship integrated development environment (IDE). Although the IDE already offers a boatload of useful features for developers, Microsoft has finally introduced a long-requested capability that will be loved by many. While developers have already been able to create Git pull requests (PRs) directly within Visual Studio for the past couple of years, it had not been possible to review a PR without switching to the browser, until now. Microsoft revealed in December 2025 that it is working on UX that enables developers to do just that, and fast-forward to June 2026, and Visual Studio finally has native capabilities to open and inspect a PR, discuss feedback, and wrap up the review, all without switching to the browser. This integration works for both GitHub and Azure DevOps (including on-prem). Developers have access to multiple surfaces to open a PR, including Git Repository, Git Changes, and the Git menu in Visual Studio. Once you open a PR, all the important details will be immediately visible to you, from where you can navigate to various levels of granularity and branch states, depending on the reviews that you are engaged in. As you would expect, you also get a diff view that enables you to see code changes inline or side-by-side in a separate panel. You can also review commit-by-commit. Additionally, this UX fosters collaboration as you can leave comments, reply to threads, and resolve conversations easily. Naturally, you can also leverage Copilot to apply a code suggestion to fix a potential issue. When you are done, you have the ability to approve, complete, and merge the PR. This is a pretty major feature as it has been requested heavily for the past few years. You can try it out in Visual Studio 2026 version 18.7, made available here recently. Microsoft plans to enhance this experience further in future releases with comment filtering, a timeline of PR activity, and more.
  • Recent Achievements

    • Week One Done
      Timaximus earned a badge
      Week One Done
    • One Month Later
      Timaximus earned a badge
      One Month Later
    • Rookie
      FBSPL went up a rank
      Rookie
    • First Post
      davidbazooked earned a badge
      First Post
    • Week One Done
      davidbazooked earned a badge
      Week One Done
  • Popular Contributors

    1. 1
      +primortal
      499
    2. 2
      PsYcHoKiLLa
      174
    3. 3
      +Edouard
      160
    4. 4
      Steven P.
      84
    5. 5
      ATLien_0
      75
  • Tell a friend

    Love Neowin? Tell a friend!