What do you drive?


Recommended Posts

  • 2 weeks later...

2004 Fiat Punto Dynamic 5dr 1.2 16v.

Stock photo, but this is the same shape/colour as mine:

DY53MGU.jpg

It's not spectacular, however for a first car it's not bad, nice to drive and fairly quick (granted it's only 80bhp, but it's a fairly small car and it's pretty damn nippy).

Citroen C2 1.4 HDi VTS

08-c2-vts-f3q-s.jpg

A black 2009 Citroen C4.. from work.

1.6L Petrol, 4 speed automatic, oh yea!

Well, it goes from point A to B, in comfort, with a horrible transmission but a chassis that clearly deserves more power, eats corners like a champ.

Surprised it's a 4 speed auto, not 5 speed. Is it SensoDrive?

93 Pontiac Grand Prix SE 3.1L

53rdjb.jpg

207pa1t.jpg

No engine or body mods. Added a Pioneer mp3 head unit, Fosgate 4x6 plate speakers in the dash, JL Audio 6x9s in the rear, Fosgate 900watt amp in the trunk with a pair of Fosgate 10 inch subs.

The only mod I did was add a couple rca jacks under the dash connected to the back of the Pioneer, so I could hook up anything with an output.

Hit a deer before this pic was taken. Had to replace the driver's side fender and piece together the headlight mounting bracket on the driver's side. My dad had someone put on new paint and clearcoat on the entire front and part of the back, so it looks new. Too bad it's coming off the trunk lid and wing now.

Still runs very strong, and gets the factory highway mileage of 27 mpg. I do as much of my own work on it as possible. Handles very well, but I'm tired of sports cars.

I want to replace it with a Toyota truck though. Tired of not being able to haul or pull anything.

  • 2 weeks later...

My hobby car is a 2003 Mitsubishi Evolution VIII. It has gone through several builds all of which I have done all the work and tuning myself. There are a couple videos of the car on the street "playing" with sportbikes and 600+ HP cars. I haven't had it on a dyno but have somewhat recently put it against a 600+ HP Supra and pulled away, that was on 93 octane pump gas and 30lbs of boost. :p

post-329488-12684497075553_thumb.jpg

post-329488-12684497963177_thumb.jpg

Modifications (I think I've remembered everything):

AEM Cam Gears

AEM EMS w/ Speed Density Conversion (AEM 5 Bar MAP Sensor)

AMS 2.0L Built Bottom End w/Revised Oliver Rods, Revised AMS/Ross Racing 8.9:1 Pistons, and O-Ringed Block

AMS GT37R Turbo Kit

AMS 4" Speed Density Intake w/ K&N Filter

AMS 3" Turbo-back Exhaust w/ Testpipe

AMS Fuel Rail

AMS Fuel Pressure Regulator Kit

AMS Full Race Head w/1MM Oversized Valves & Inconel Exhaust Valves

AMS Intercooler

AMS Polished Intercooler Piping (Lower and Upper)

AMS Spec L19 Headstuds

AMS Upper and Lower Flexible Braided Stainless Steel Clutch Lines

AMS VSR Intake Manifold (Polished)

Buschur Racing BFIC Intercooler (24x13x4.5 Core Size)

Buschur Racing Cam Sensor Heat Shield

Buschur Racing Double Pumper (Twin Walboro) Fuel System

Buschur Racing Inline Boost Controller

Buschur Racing Ported 65mm Throttle Body

Carbon Fiber Arm Rest Cover

Custom Blacked Out Headlights

Cosworth Crankshaft Oil Scraper

Evolution 7 Tail Lights

Exedy Triple Plate HD Clutch

FIC 1150cc Injectors

Fluidampr Harmonic Balancer

Greddy Weighted Chrome Shift Knob

HKS Turbo Timer

JMF Large Vented Oil Catch Can

JUN 272 Cams

Kartboy Short Shifter

Lancershop Brass Shifter Bushings (Transmission Cables and Base Bushings)

Nisei Race Battery Kit

Mitsubishi Evolution IX Rims

Perrin Shorty Antenna

RotorPros Slotted and Crossed Drilled Rotors

Shepherd Transmission Ultimate Ratio Transmission w/REM/Cryo Treated Sliders

Shepherd Transmission Stage 2 Transfer Case w/REM/Cryo Treated Gears & Mitsubishi LSD

SparkTech Pro COP Ignition System with Polished Coil Covers (Not installed in pictures)

STM Clutch Fork Stopper

Techna-Fit SS Braided Brake Lines

Tial 50mm BOV

Tial 38mm Wastegate

Tien S-Tech Lowering Springs

Wolo Bad Boy 120 Decibel Air Horn

Zeitronix ZT2 Wideband w/ ZR2 Gauge

  • 3 weeks later...

Still got my 2.0 16v Corrado..

But.. catching a train to a friends tonight, to go and buy a second Corrado - the 2.9 litre VR6 - tomorrow :) It's this one:

76898630.jpg

Can't wait... :)

I love VR6's, both Rado's and Golfs, those engines pull so well, and such a flat torque curve, pretty bomb proof too :-)

Had it a few days now.. boy, it doesn't half put a smile on your face. My 16v has approx 145BHP and this has just under 200BHP.. I didn't think 55BHP would make such a difference, but the VR6 would absolutely annhilate the 16v in a straight line. And it's such silent, refined power... you barely hear it whilst you keep the revs below 2,500RPM but once you break past that the noise is beyond intoxicating. I knew it'd sound awesome as I've been hankering after a VR6 for years and have been fortunate enough to drive a variety of standard and heavily tuned ones (including, most recently, a VR6 turbo putting out just under 400BHP... :wacko: ) and have always loved them.

Feels pretty surreal to own one at last.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • Here is how I fixed Windows 11 not booting after clean installation by Taras Buria Story time. A couple of weeks ago, I experienced a very odd thing with my computers. I was trying to reinstall Windows 11 on my primary device, and everything was going smoothly until the installer performed the first restart. After that, my computer entered the boot disk selection screen instead of continuing the setup process. Huh, that's odd, said I, and selected Windows Boot Manager only to see it fall back into the same screen right away. Then I tried booting from the USB drive with the same result—the PC kept returning to the boot device selection screen, and removing the drive would send my PC to UEFI, again, with no way to launch Windows 11. I fired up my spare laptop, which has been sitting unused for quite a while, to see if I am dealing with a defective USB drive. Nope, Windows 11 installed and started without issues. After trying another drive and checking all the possible settings in UEFI, I decided to try disabling Secure Boot. Lo and behold, Windows 11 started as it should have been in the first place, continued the setup process, and reached the initial setup screen. Victory! After I finished the setup and applied all updates, I re-enabled Secure Boot, and Windows 11 started without issues. Some time later, I tried reinstalling Windows 11 on my laptop only to experience similar issues, with UEFI claiming a Secure Boot violation. I checked whether the drive works on my main PC, and yes, it installed Windows 11 without errors. I scratched my head, went to UEFI, turned off Secure Boot, and installed Windows 11 without issues. After that, I enabled Secure Boot. Note: I used the official Media Creation Tool app for my USB drive. Also, UEFI was properly configured for Windows 11, including no Legacy Mode, a GPT-partitioned drive, and TPM and Secure Boot enabled. From my experience, if you are dealing with similar symptoms, I recommend two things: If you use old Windows 11 install media, create a new one with the latest Windows 11 release, especially if you know your PC already has the latest Secure Boot certificates. If you cannot create a new one, turn off Secure Boot, complete the installation, download all available updates, and then re-enable Secure Boot in UEFI. Note that you need to turn off Secure Boot after installing Windows 11. Otherwise, the installer won't run, claiming a hardware requirements mismatch. I believe the problem hides in Secure Boot certificates that expire this month. Microsoft is currently rolling out new certificates, and maybe a mismatch was causing these issues for both of my systems. I am out of my depth to make a definitive statement; this article is flagged as "Opinion," as I only share my experience and some tips on how to fix the problem. If some of you possess deeper knowledge and understanding of the situation, please share it in the comments. As for everyone else struggling with computers not booting after a clean install, the two steps above should get you out of the pickle.
    • I gave the tool a chance the other day to make a USB. An hour later it was stuck at 0% downloaded. I downloaded the official ISO, downloaded Rufus, and made the USB myself in 15 min.
    • <Moved to software discussion and support> I've got fond memories of Winamp. Changing the skins, the different visualisations etc. But now I just need a simple music player. MSN messenger would be another one, MSN Messenger Plus (I think?) offered so many different plugins. But again, it probably wouldn't work for me these days. And then there is miRC. i think it's still going these days, but lord i had fun with that back in the day. Now it's mostly stuff like Discord, WhatsApp group chats, Signal, Telegram... /me is showing his age...
    • ive always been fascinated by old software this is an old video player for windows from apple
  • Recent Achievements

    • Conversation Starter
      flexorcist earned a badge
      Conversation Starter
    • One Month Later
      AndreaB earned a badge
      One Month Later
    • One Month Later
      agatameier earned a badge
      One Month Later
    • Week One Done
      agatameier earned a badge
      Week One Done
    • Week One Done
      ssd21345 earned a badge
      Week One Done
  • Popular Contributors

    1. 1
      +primortal
      518
    2. 2
      +Edouard
      198
    3. 3
      PsYcHoKiLLa
      147
    4. 4
      ATLien_0
      94
    5. 5
      Steven P.
      77
  • Tell a friend

    Love Neowin? Tell a friend!