Networked visited by University of Michigan


Recommended Posts

2 minutes ago, Circaflex said:

Something sounds way off. Hard reset the router using the paperclip method (poke the reset button), plug into router via ethernet. At this point, you arent getting internet so just unplug the WAN cable just in case it was causing a problem, and profit. You dont need to set any ips, mess with the subnet, none of that. Just connect via a physical cable to the router and flash away.

I did that. I can't connect to the router, the webui times out. I've hard-reset the router already. I haven't even touched it besides logging in. 

Figured the problem out. Router doesn't accept connections until WAN is plugged in.

 

Flashed factory to ddwrt now.

 

 

As I suspected, 30/30/30 screws the router up. Everytime I've done this, nothing works.

 

Figured that out, gotta pull the power afterwards. Wait 30, plug it back in. These install notes blow.

Edited by BinaryData
27 minutes ago, sc302 said:

Read the directions and breathe. Take it slow.  You are rushing and creating your own issues. 

Fixed it. MAC Address changed by 1 Number. ISP Fixed it. 

 

Now we wait and see if i have a connection problem.

 

Oh @BudMan - Don't be jealous of my connection. My Friend Mark & his wife have a 1Gbit/s Fiber line in Arizona. They claim to pay $75 / month. 10x my speed for $25 more. And I found out my ISP only has a 20Gbit/s incoming connection per county, thus the cost. They may upgrade to 50Gbit/s in each county, however I'd pay $100 for 500Mbit up/down.

 

And confirmed from ISP, don't care what I do as long as I'm not reselling my internet to my neighbors or DOS'ing someone. My response was "Why use 100mbit when I play with 50Gbit/s at work?" :p

34 minutes ago, sc302 said:

Write down your mac so you can change it if needed with a new or existing router. That way you don't have to have the isp involved.  

I did. My ISP is actually pretty chill.

 

DDWRT seems to have fixed it.

Edited by BinaryData
1 minute ago, Circaflex said:

Glad to hear, wish it could been something tried much earlier ;)

 

 

Well, I wanted to rule as much out as possible. Plus, I planned on upgrading anyways. I wasn't sure this would fix it. I don't see how it just randomly stopped working.

key renewal for what?  Your wifi group key??  Why are you looking at those sorts of settings... Just leave them at default... All you should be worried about is that your wpa2 aes with good PSK!!

 

As to why the native firmware would just freeze up for no reason - because the devices really prob never meant for anyone on a 100/100 connection that actually uses it ;)  I saw your downloads going the other day when you let me remote in..  Your typical user surfing his porn and reading is email doesn't tax the device like that..

21 minutes ago, BudMan said:

key renewal for what?  Your wifi group key??  Why are you looking at those sorts of settings... Just leave them at default... All you should be worried about is that your wpa2 aes with good PSK!!

 

As to why the native firmware would just freeze up for no reason - because the devices really prob never meant for anyone on a 100/100 connection that actually uses it ;)  I saw your downloads going the other day when you let me remote in..  Your typical user surfing his porn and reading is email doesn't tax the device like that..

Shhh... Did you happen to look at my HDs on my computer? :p Strange though, I've been downloading like this, even harder, and it didn't crap out on me. At one point, I was hitting my xfer cap of like 15MB/s from my SeedBox.

I have no interest in what you were actually doing, I just saw lots of files downloading in filezilla.

 

It might not of been specific high level of downloading causing the problem but just accumulation of traffic and sessions.  You would be surprised at how low the session tables can be in some of these soho routers native firmware.. Even though they quite often have decent amounts of memory..  They can have very limited of it towards session tables, they can have very long time outs on sessions, etc.  dd-wrt for sure does a better job of this.

 

Now that you have dd-wrt running, hit it hard for a few days lots of stuff in and out of the network and see how it goes.

4 hours ago, BudMan said:

I have no interest in what you were actually doing, I just saw lots of files downloading in filezilla.

 

It might not of been specific high level of downloading causing the problem but just accumulation of traffic and sessions.  You would be surprised at how low the session tables can be in some of these soho routers native firmware.. Even though they quite often have decent amounts of memory..  They can have very limited of it towards session tables, they can have very long time outs on sessions, etc.  dd-wrt for sure does a better job of this.

 

Now that you have dd-wrt running, hit it hard for a few days lots of stuff in and out of the network and see how it goes.

Sounds good. I just find it strange, oh well. I'll still be grabbing the switch/WAP. I may end up buying another WAP at a later time. Give my garage some WiFi.

 

So, as for the conclusion.

 

Essentially, my router couldn't handle my abusive downloads with its stock firmware. Upgrading to DDWRT seems to have fixed its stability issue. However, for the next week or so, I'll be beating the living hell out of it to see if I can force it to do it again.

 

I'd like to thank Circaflex, BudMan, Jared-, and sc302 for the help and encouragement to step a little out of my comfort zone. I'm glad it worked out this time. If I could give out stickers, you'd all get one :p

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Posts

    • Payday TWO!! Is 13 years old man I feel old - I remember trying it out and if I did not know I would say 5-6 years ago or something
    • Payday 2 engine upgrade adds 64-bit and DX11 support, drastically shrinks install size by Pulasthi Ariyasinghe Payday 2, the most popular entry in the heisting game franchise, is getting a surprising update after all these years. This is slated to be a complete engine upgrade that will enhance almost every aspect of the 13-year-old title, targeting performance, loading times, file size, rendering backend, and more. Developer Sidetrack Games is planning a beta to test out the new version ahead of the full public launch. The development team today revealed that the long-awaited upgrade to the 64-bit architecture is happening with this Diesel 3.0 engine update. By letting the game use more ram than 4GB, it is said to improve stability and compatibility on most hardware. It should also help modders in the long term with implementing larger changes too. "While many of the changes are made on the backend and not everything will be visible to you guys because it is a massive rewrite of the entire codebase, there will be a lot of things that you can look forward to," Sidetrack explained. Payday 2 will also hop over from DirectX 9 to 11. Instead of visual improvements, this is slated to reduce the amount of VRAM used by the title, letting more lower-end hardware access the title and run it better. Since these changes would require a complete redownload of the game anyway, Sidetrack says it has revamped "the game's packaging and bundling system." This should reduce the installation size from 86GB to 32GB. "So, now it's time to finally move the game to your SSDs," added the studio. The Payday 2 Diesel Engine 3.0 update is entering open beta on June 30 for Steam users. No console release plans were announced today. Sidetrack Games says it has been working on this complete rewrite of the codebase for the last nine months. While these changes should break most mods, the studio encouraged modders to use the beta period to repair their creations with support from the development team.
  • Recent Achievements

    • Week One Done
      Scoobystu earned a badge
      Week One Done
    • Week One Done
      tuben earned a badge
      Week One Done
    • First Post
      OffsetAbs earned a badge
      First Post
    • Reacting Well
      OffsetAbs earned a badge
      Reacting Well
    • First Post
      Kolakid60 earned a badge
      First Post
  • Popular Contributors

    1. 1
      +primortal
      440
    2. 2
      +Edouard
      196
    3. 3
      PsYcHoKiLLa
      157
    4. 4
      FloatingFatMan
      71
    5. 5
      Steven P.
      68
  • Tell a friend

    Love Neowin? Tell a friend!