Team Fortress 2

By MikeFu84
in PC Gaming

 Share

Recommended Posts

Collaborator

logancable

Posted
Posted

Official blog's been updated!

www.teamfortress.com

Hey good job, there, hardhat

December 10, 2008 - Robin Walker

We've been pretty quiet lately, but thankfully, that's about to end. In the next few days we'll have an update out that has a couple of new features for the Engineer and Spy, and a variety of other smaller fixes.

* Teleporters will be upgradeable to level 3. As the teleporter is upgraded, the cooldown will decrease.

* Dispensers will be upgradeable to level 3. They will heal faster and generate metal faster as they are upgraded.

* Spies will be able to recharge their cloaking ability by picking up ammo off of the ground.

* We've made a bunch of minor changes by adding particle systems and upgrading the HUD to show things like deaths by critical hits, players that are overhealed, and giving more information to medics when people are calling for them.

These are just to work on some class balance and depth issues that we've seen in the wild with these two classes, but aren't meant to replace their entire class packs. They will be getting more attention further down the road.

While that's in testing, we're off working on several things that folks have been emailing us about, so we thought it'd be good to provide some detail:

* The next class pack will be the Scout. One of the main goals we're focusing on for him has been to provide tools that make him useful in maps like Dustbowl & Goldrush. If you have any ideas for what you think would work well, post them over on the Team Fortress 2 Forum and we'll take a look.

* We are actively working on a massive XBox 360 update, which will include pretty much everything we've shipped on the PC in the last year. We'll provide you with a rough date when we have one.

* We're also working on bringing over a variety of engine improvements from Left 4 Dead into the TF2 engine, but it won't be a wholesale replacement of the engine. This means we'll get some of L4D's performance improvements, like the better multicore support, but not all of them. For example, we can't bring over some improvements without dropping support for DX8, which we're not prepared to do.

Grand Master

Denis W. Veteran

Posted
  • Veteran
Posted

That's all the Engineers and Spies get as class upgrades? :cry:

They're good additions just by reading about them, don't get me wrong. I just thought they'd get something as fancy as the Medic, Heavy, and Pyro did.

Veteran

D!ABOL!C

Posted
Posted

I liked the achievement tracker, that was a nice update. You can now have achievements you already have removed from the list and also have them added to your HUD so you don't have to keep checking back. These are especially useful for those that require a certain amount of kills, damage etc. to get.

I guess everyone should get ready for 12 v 12 scouts.

Grand Master

DrunknMunky Veteran

Posted
  • Veteran
Posted
That's all the Engineers and Spies get as class upgrades? :cry:

They are still going to upgrade them with proper class packs like the heavy, medic and pyro further down the line. These updates are just for balancing issues.

Can't wait to see what they do with the scout!

This topic is now closed to further replies.
 Share
Go to topic listing

  • Posts

    • Microsoft hides these secret Windows 11 performance boost settings available on every PC

      By hellowalkman · Posted

      Microsoft hides these secret Windows 11 performance boost settings available on every PC by Sayan Sen Windows enthusiasts often look for ways to extract as much performance out of their systems as possible, and it's often the case that they try and do so while trying to minimize the heat and power consumption. This is especially relevant in the case of mobile Windows PCs since laptops and notebooks tend to get hot and management of that heat and power is harder in such a form factor. As such users often turn to techniques like under-volting which can be used to squeeze out the maximum capabilities of a chip while also maintaining lowered power levels. There are official apps from AMD and Intel with the likes of Ryzen Master and XTU (Extreme Tuning Utility). While these are quite handy, most enthusiasts probably prefer to dig into the BIOS and play around with settings there like Curve Optimizer on Ryzen, which lets users set various frequency-voltage scaling values. These are essentially called P-States. If you are not familiar with them, Processor Power Management is done through Advanced Configuration and Power Interface (ACPI) P-states and C-states. While P-states or performance pwoer states handle CPU voltage-frequency scaling, C-states deal with CPU sleep states so that some of the CPU functions, which are not necessary at that moment, can be disabled. The P-states and C-states work together to make the processor run more efficiently. It helps the OS and apps determine which cores can be parked and which should be boosted. Of course not every user is an enthusiast or knows the technicalities and integrities of how things like overclocking or undervolting work. Thankfully for them Windows itself offers something pretty cool, though it is hidden by default on all systems. By default, Windows only has two P-States, "Minimum Processor State" and "Maximum Processor State." However, this can be changed with a Registry trick to expand the options under a secret "Processor performance boost mode" dropdown. This essentially enables the HWP or hardware P-States available on a device, and these are not controlled just by the OS itself as the underlying hardware gets involved too. In total there are five Processor Performance Boost Mode profiles that control how Windows requests and allows CPU turbo/boost behavior under the different power policies. They are: Disabled: In this mode, processor boosting is effectively turned off. The CPU will avoid entering turbo or boost frequencies and instead operate closer to its base frequency ceiling. This can significantly reduce power consumption and heat output, but at the cost of reduced burst performance and responsiveness in short workloads. Enabled: This is the standard behavior where boost functionality is allowed under normal conditions. The processor can opportunistically increase frequency when workload demands it, balancing performance gains with power and thermal constraints as managed by the system. Aggressive: Aggressive mode favors performance more heavily, allowing the CPU to enter higher boost states more readily and sustain them longer. This should in theory improve responsiveness under bursty or heavy workloads but increases power draw and thermal output compared to the default enabled behavior. Efficient Enabled: This mode still allows boosting, but with a stronger bias toward energy efficiency. The system attempts to use boost more selectively, avoiding unnecessary frequency spikes when the performance gain is marginal. Efficient Aggressive: This is a hybrid approach where boost is still performance-responsive, but the system continuously weighs efficiency more heavily than in Aggressive mode. It aims to deliver noticeable performance improvements while reducing wasted power in less demanding scenarios. Here's how to enable the Processor performance boost mode: Open Registry Editor: Press Win+R, type regedit, and click OK. Go to: HKLM\SYSTEM\CurrentControlSet\Control\Power\PowerSettings\54533251-82be-4824-96c1-47b60b740d00\be337238-0d82-4146-a960-4f3749d470c7 (where HKLM stands for HKEY_LOCAL_MACHINE_) Modify the value of Attributes from 1 to 2 (you can find modify option by right-clicking) After that, exit Registry, you should now be able to see the new "Processor performance boost mode" dropdown menu: As you can see there are now five new P-States or CPPC states or power profile available that help define the boost mode processor setting on your PC. Wrapping it up here's a quick run-down of the settings as defined by Microsoft itself. Setting Description Disabled The corresponding P-state-based behaviour is disabled. Collaborative Processor Performance Control (CPPC) behaviour is disabled. Enabled The corresponding P-state-based behaviour is enabled. CPPC behaviour is Efficient Enabled. Aggressive The corresponding P-state-based behaviour is enabled. CPPC behaviour is Aggressive. Efficient Enabled The corresponding P-state-based behaviour is Efficient. CPPC behaviour is Efficient Enabled. Efficient Aggressive The corresponding P-state-based behaviour is Efficient. CPPC behaviour is Aggressive. Aggressive At Guaranteed Windows calculates the desired extra performance above the guaranteed performance level, and asks the processor to deliver that specific performance level. Efficient Aggressive At Guaranteed Windows always asks the processor to deliver the highest possible performance above the guaranteed performance level. In the next part we shall be comparing these settings to explore how much of a benefit or regression they can provide in terms of performance and power efficiency. If you decide to change the values on your system and are experiencing problems like crashes or an overheating PC, make sure to revert the steps back to the original state.
    • EA Sports UFC 6 review: Brutal, satisfying, and surprisingly accessible to newcomers

      By Nick H. · Posted

      Bugger, you beat me to it!
    • EA Sports UFC 6 review: Brutal, satisfying, and surprisingly accessible to newcomers

      By +Good Bot, Bad Bot · Posted

      I think he means you haven't reviewed previous UFC games. Of course it doesn't matter... Every time you just report on something that involves the President even if just simply what happened you guys usually get accused of being anti-Trump. We live in fun times.
    • Here is how I fixed Windows 11 not booting after clean installation

      By TheGhostPhantom · Posted

      So how did you solve the problem? Disabling Secure Boot isn’t a solution.
    • Here is how I fixed Windows 11 not booting after clean installation

      By rseiler · Posted

      Another devilish issue surrounding these certificates is what can happen with old, unsuspecting PCs that nevertheless have Secure Boot enabled. In my case, it was a Dell with a 3rd-gen Core chip (so about 13 years old). As of the last few weeks, it was suddenly BSOD'g within about 5 minutes of booting. Turns out it was because of MS's "Secure-Boot-Update" scheduled task, which is scheduled to run 5 minutes after login. It's explained in gory detail here (this is not my post, but it was where I found the answer), but the short version is that this legacy system would need fairly elaborate, manual certificate intervention since MS's automatic cert update method cannot work. How to do that is linked late in the thread. https://www.bleepingcomputer.c...od-caused-by-scheduled-task Secure Boot wasn't at all important for this particular PC, so I disabled it to be done with the problem.

  • Recent Achievements

    • One Month Later
      Leroy Jethro Gibbs earned a badge
      One Month Later
    • Conversation Starter
      flexorcist earned a badge
      Conversation Starter
    • One Month Later
      AndreaB earned a badge
      One Month Later
    • One Month Later
      agatameier earned a badge
      One Month Later
    • Week One Done
      agatameier earned a badge
      Week One Done

  • Popular Contributors

    1. 1
      +primortal
      518
    2. 2
      +Edouard
      198
    3. 3
      PsYcHoKiLLa
      147
    4. 4
      ATLien_0
      95
    5. 5
      Steven P.
      77
    Show More

  • Tell a friend

    Love Neowin? Tell a friend!